此外，片上集成的模拟外设的正常工作电压降至1.8V，这有助于简化应用设计以及最大限度降低整体功耗需求。
In addition, integrated analog peripherals are fully functional at supply voltages down to 1.8v. This can help simplify design as well as helping to minimize overall power demand.
镍锌充电电池正常工作电压是1.65V，比常规的镍氢电池的1.25V高出30%。当刚充完时，两个端极的电压甚至能高达1.85V！
The NiZn cell has a nominal voltage of 1.65V, which is 30% higher than that of a NiMH cell (1.25V nominal). When freshly charged, its terminal voltage is even higher at 1.85V!
该逆变器电源电压相同的条件下正常工作。
The inverter supplies a voltage identical to that under normal operating conditions.
由电孤启动到正常工作这段时间，电网线路的电流电压波动性较大，往往给电路其它各元件造成强烈的冲击。
From starting-up to stabilization of the arc, the electric current and voltage usually fluctuate acutely, which makes a great impact on other circuit components.
完成电路连接之后，接通偏置电压，在没有离子束电流的情况下进行电流测量，以验证系统能够正常工作。
After the connections are made, verify the system is working properly by turning the bias voltage on and taking a current measurement with no ion beam current.
由此引起的过电压频率通常为正常的工作频率。
当输出电压超过40v时，产品进入保护状态，当故障排除或重新起机时，电源工作正常。
When the output voltage is over 40v the product is protected. When the fault is excluded or is start working again the power supply is working normally.
所有单元当电压下降到93vac时仍然能够保持正常工作，尤其适合于那些电源稳定性存在问题的使用场合。
All units when the voltage drops to 93vac when still can maintain normal work, especially suitable for those power stability problems of using occasions.
因为TWC具有储氧功能，其工作正常时两个氧传感器的电压响应曲线不同，否则二者的电压响应曲线形状相近。
Because TWC has the oxygen storing function, the two oxygen sensors have different voltage response curves in their normal working conditions, otherwise their voltage response curves are similar.
维护人员对产品进行日常例行维护，保证其正常工作，例如，设置线电压或更换耗材。
Maintenance personnel perform routine procedures on the product to keep it operating properly, for example, setting the line voltage or replacing consumable materials.
当输电线网发生故障时，各相的电压、电流都会随之偏离正常工作状态。
When transmission lines are at fault, the voltage and current will change violently.
该转换器的高输入阻抗和低失调电压漂移输入增益级可以保证芯片在微弱电压信号下正常工作。
The designed converter could operate well with a slender supply voltage signal because of its high input resistance and low offset drift.
电能质量是指引起用电设备故障或不能正常工作的电压、电流或频率的偏差。
The power quality is denoted by the deviation of voltage, current or frequency, which makes electric equipments not work proper.
通过监测动力电压，该装置先对正常的工作量进行测定，然后依据被测动力发生的变化，估计并设定一个自动的关闭点。
By monitoring both voltage and power, the unit measures the normal working load, then calculates and sets an automatic shutdown point for detected power changes.
发射机的所有电路基本上都是围绕着如何给行波管的各电极提供正确稳定的工作电压及使行波管正常工作的各种保护和控制功能而设计的。
All circuits of the transmitter are basically designed to offer the proper, steady voltage for the electrodes of TWT and various protective, control functions for its smooth operation.
提出了一种新的光电开关电路设计形式（差分形式的光电开关电路），解决了在低电压宽供电电源下，光电开关电路难以正常工作的问题。
This Paper Provides a kind of new designing form used in the photoelectric switching circuit. It solves the problem happened at the photoelectric switching circuit with low voltage and wide range.
因此即使在低电源电压操作下，各晶体管仍可正常地在饱和区工作。
Thus, operating even under lower voltage of power source, each transistor can still be operated at saturation region normally.
电压波动及闪变过大，将导致许多智能仪表及设备无法正常工作。
Voltage fluctuation and large flicker make most of the intelligent instruments and equipment work improperly.
电压波动及闪变过大，将导致许多智能仪表及设备无法正常工作。
Voltage fluctuation and large flicker make most of the intelligent instruments and equipment work improperly.
应用推荐