极限扭矩与极限弯矩之间的相关关系。
The curve of interaction between ultimate moment and ultimate torque .
在梁的极限分析中采用新的刚塑性模型,推导出极限弯矩公式。
Using the improved model, an ultimate bending moment formula is presented.
探究了腐蚀深度、腐蚀宽度和腐蚀形状等参数对极限弯矩荷载的影响。
Parameter study conducted indicates that the shape of the corrosion defect has significant influence on the bending capacity of the corroded pipes.
用结构极限载荷中的弯矩调整法,计算出钢筋砼的连续梁,板结构的极限弯矩。
This article applies the method of adjusting curved moment in structural limiting load to calculate the curved moment of reinforcing bar and concrete continuous boards and beams.
当目标函数是塑性极限弯矩凸函数时,证明了这一最优性条件也是最优解的充分条件。
It is proved that the optimality conditions are also sufficient if the objective function is a convex function of the plastic limit bending moment.
最后分析了双舷侧宽度对极限弯矩和最大剪应力的影响,提出了选取双舷侧宽度值的建议。
The results indicate that if introducing the double-hull board side structure, the shearing stress will be greatly decreased, while the effects on improvi…
目前,计算总纵极限弯矩的方法主要有三种,即非线性有限元法,理想结构单元法和逐步破坏分析法。
There are three main methods by far, nonlinear finite element method, idealized structural unit method and progressive collapse analysis method.
根据混凝土的非线性本构关系,提出了粘钢加固梁的开裂弯矩、极限弯矩、刚度的计算方法,并将理论值与试验值进行对比分析。
Calculating methods of cracking moment, ultimate moment, stiffness of the beams strengthened by steel plate are offered according to the non-linear relationship between stress and strain of concrete.
所选用的弯矩-曲率关系是假定超过屈服后有一个水平段,即弯矩保持在极限值不变。
The moment-curvature relationship chosen is assumed to have a horizontal branch beyond yield, with the moment remaining constant at the ultimate value.
最后,基于极限强度,将该组合方法用于评估散货船在极值弯矩作用下的船体梁安全性。
Then, the compound method is used to assess the hull girder ultimate strength reliability of a bulk carrier subjected to extreme bending moments.
另一方面,随轴压比增大,梁柱上弯矩分配虽略有变化,但对整榀框架的极限承载能力和总的弯矩调幅能力影响不大。
On the other hand, though increasing axial compression ratio of column changes the moment redistribution in frame, the effect on ultimate loads and total modulations is insignificant.
从环板的平衡方程出发,应用奇异函数法计算其在最大弯矩极限条件下的极限荷载。
Based on the equilibrium equation of annular plates, the limit loads of annular plates under ultimate condition of the maximal moment were calculated by singular function.
对用套管加强的T型管节点在平面外弯矩作用下的极限强度作了参数化分析。
This paper presents the results of a parametric study to investigate the ultimate strength of sleeve reinforced hollow section T-joints subjected to out-plane bending.
按桩身内力变化,采用极限状态法,以正负弯矩对桩进行双面配筋。
According to the variation of the pile's internal force, the methods of limiting state is used to make bilateral reinforcement through bending moment.
利用该试验机对日本大发公司生产的经过圆角滚压处理的曲轴的极限承载弯矩进行了测试。
The limit bending capacity of a round-corner-rolled crankshaft is measured with the testing machine.
现有的经验方法无法准确计算同时传递竖向剪力和不平衡弯矩的钢筋混凝土板柱中节点的极限承载力。
The existing experimental method cannot accurately calculate the ultimate carrying capacity of the reinforced concrete slab column connections subjected to moment and shear.
本文分析了承受轴力、弯矩及剪力的型钢构件极限承载力和钢筋砼框架短柱受剪承载力。
This paper analyzes the ultimate strength of steel sections subjected to axial loading, bending and shear as well as shear strength of reinforced concrete short columns in frames.
基于极限分析的观点,推导了工业中焊制三通在面内弯矩作用下的极限载荷估算式。
The limit load calculation of welding piping tees under the action of the in plane bending moment was derived based on the limit analysis.
除对使用荷载阶段进行研究和给出计算的结果外,也给出弯矩-曲率全曲线和极限变形的计算。
Besides the research and calculation materials for the stage of working load, the complete moment-curvature curve and the calculation of ultimate deformations are provided too.
本文用极限平衡法求解了钢管混凝土格构柱在轴力和弯矩共同作用下的极限承载能力。
This paper describes the limit analysis of latticed columns made from concrete-filled steel tubes under combined bending and axial loading.
分析在正常使用极限状态下截面内力分别为最大负弯矩和最大正剪力两种工况下应力分布规律。
Then take three-dimensional simulation for the model, and analyze the stress distribution when conditions maximum positive shear or maximum nagetive moment happens.
基于极限分析的观点,推导了工业中焊制管道三通在面内弯矩工况下的极限载荷估算式。
Based on the limit analysis viewpoint, a formula that could be used to estimate the in plane limit moment of welded branch pipe Tee was derived in this paper.
本文通过对预应力混凝土屋架的荷载-挠度曲线分析,说明预应力混凝土屋架在强度极限状态时,屋架的挠度是不小的。因此,由屋架的变位引起的上弦次弯矩影响是不可忽略的。
Through the analysis of the load-deflection curves of prestressed concrete roof trusses, it is shown that these trusses deflect a considerable amount in the state of ultimate strength.
基于极限分析的观点,推导出面外弯矩作用下焊制三通的极限载荷估算公式。
Based on the limit analysis viewpoint, a formula that could be used to estimate the out-of-plane limit moment of welded branch pipe tee was derived in this paper.
基于极限分析的观点,推导出面外弯矩作用下焊制三通的极限载荷估算公式。
Based on the limit analysis viewpoint, a formula that could be used to estimate the out-of-plane limit moment of welded branch pipe tee was derived in this paper.
应用推荐