研究了测定方法的原理与最佳测量条件。
The principle and the optimum determining conditions of the method are investigated.
选择恰当的物理参数可满足正弦相位调制干涉仪最佳测量条件。
The optimum measuring condition of the laser diode interferometer can be determined by choosing appropriate physical parameters of the laser diode.
本文提出了应用射电干涉测量的方法测七地球自转的三个参数时，源矢量的最佳分布条件。
An optimum distribution condition of radio sources for the determination of Earth rotation parameters by means of VLBI technique was proposed and explained in detail.
通过用该方法对铀尾矿库现场连续一年的监测，观测了铀尾矿库年氡析出率的变化规律，总结出年平均氡析出率的最佳测量季节和测量条件。
The annual change regularity of radon release rate from uranium tailings was observed. The optimum season and condition of monitoring the annual average radon release rate are summarized.
工作中对样品的灰化方法、谱线干扰及测量线对和最佳稀释条件的选择进行了研究。
The method of ashing, spectral interferences and selection of the interference-free lines and the optimum spike addition have been studied.
对影响其光谱测量的各种因素进行了较为详细的研究，确定了试验的最佳测定条件。
Detailed study was made on the factors influencing the spectrometry and the optimal detecting conditions in the test were determined.
分析测量误差与调制电流大小的关系，进而确定短距离测距的最佳实验条件。
The measurement error is found to decrease with the increase of the modulation current and this relation is applied to finding the optimum experimental condition for the short distance measurement.
报道了电镀锌-磷合金镀液的基液、 配体、表面活性剂和工艺条件的选择以及镀液性能的测量结果。推荐了电镀锌-磷合金的最佳工艺配方和条件。
The Paper deals with the selections of basic solution, complexant , surfactant and operating conditions of Zn-P plating. The optimum bath composition and operating conditions are recommended.
报道了电镀锌-磷合金镀液的基液、 配体、表面活性剂和工艺条件的选择以及镀液性能的测量结果。推荐了电镀锌-磷合金的最佳工艺配方和条件。
The Paper deals with the selections of basic solution, complexant , surfactant and operating conditions of Zn-P plating. The optimum bath composition and operating conditions are recommended.
应用推荐