除此之外还有利用差动变压器和扰曲线应变计的电感变换方式，以及变电阻式压力变送器。
Besides there is also some alternatives such as an inductance conversion using differential transformer and space curve deformeter and variable resistance pressure transmitter.
根据朗伯-比尔定律和库贝尔卡-芒克理论，设计了一种利用分光光度计和测色仪测定混纺织物同浴染色上染速率曲线的方法。
According to Lambert-Beer and Kubelk-Munk theory, the method using spectrophotometer and color measurement was designed to determine the dyeing rate of blended fabrics in one bath.
然后根据光纤组A和B的标定曲线，对振动计的灵敏度进行了补偿。
Then based on the calibration curve of group A and B, compensation of sensitivity was made.
利用这些曲线，即可从检温计的指示温度推算出定子最热段绕组铜线最高温度值和平均温度值。
Using these curves, the highest and average temperatures of stator winding can be calculated from the thermodetector indication.
采用RF—5301PC荧光分光光度计测定激发光谱、发射光谱和磷光衰减曲线；
The photoluminescence spectra and the decay curves were recorded on RF-5301PC.
首先描计基线5分钟使其适应，观测其特点，此时的监测曲线反映了颈椎中立位安静状态下脑组织血红蛋白含量即脑血流量情况。
First draw the basic curve for 5 minutes, observe its characteristics. At that time the monitoring curve reflects the brain oxygen situation and the brain blood during a tranquil state.
配制上述标样溶液，用紫外-可见分光光度计测量吸光度，然后以浓度和吸光度来绘制曲线。R2要大于0.995。
Prepared standard solution above for calibration curve, and run UV-VIS program. Then draw a diagram with absorption and concentration. R2 should be greater than 0.995.
提出了密度计法颗粒分析试验的一种曲线拟合及修正方法，经验证效果较好。
A curve fitting and revising methods to solve hydrometer grain analysis is presented, and proved good satisfactory.
基于MCULPC 2138和数码语音芯片ISD1420接口技术，设计并研制出了一种新型集语音报告、报警功能于一体，并同时显示温度变化曲线的智能温度计。
Based on the interface technology MCU LPC2138 and the digital sound chip ISD1420, a new type of intelligent thermometer which could report, alarm and show the change curve of temperature was designed.
在碳电阻温度计标定过程中，经验公式的选用对碳电阻温度计标定曲线的正确性有着重大的影响。
In the course of calibration of carbon thermometer, the selection of the experimental formula of carbon thermometer will affect the validity of the calibrating curve greatly.
影响测定结果的分量主要有：标准溶液、回归曲线、样品平行试验、二乙酰一肟分光光度法、分光光度计、取样等。
Mainfactors are as follows: standard solution, regressive curve, parallel experiment of sample, diacetyl monoxide's reagent colorimetric method, spectrophotometer, sampling, etc.
在计及磁饱和效应影响时，本文提出了利用电机磁化曲线，使电机参数随机变化的处理方法。
This paper provides a simple and useful method for calcalating motor parameters by means of the no-load characteristic.
采用X -射线衍射、差热分析、微量热计及压汞测孔仪对公路粉煤灰水泥的水化产物、水化放热曲线、孔尺寸分布进行了研究。
The hydrated products and pore size distribution of high road fly ash cements were studied by means of XRD, DTA, Mercury porosimeter, etc.
公司主要销售有拉力计、弹簧测试仪、量具、影像测量仪、荷重曲线仪及纸带机等仪器设备。
Its main products include pulling tool, spring tester, measuring tool, image measuring apparatus, load curve measuring tool and paper tape punch, and other instruments.
配制上述标样溶液，用紫外-可见分光光度计测量吸光度，然后以浓度和吸光度来绘制曲线。
Prepared standard solution above for calibration curve, and run UV-VIS program. Then draw a diagram with absorption and concentration.
用UV 3100 PC分光光度计测试光谱特性曲线。
We tested the spectrum characteristic with UV3100PC spectrophotometer.
再用振动信号记录系统记录此时实验激励的振动加速度的均方根值。将记录的数据利用最小二乘和优化设计的方法拟合成振动频率计权曲线。
The data were fitted to the same form of the frequency weighting Wk of ISO 2631-1 with the least square method and optimization of parameters.
再用振动信号记录系统记录此时实验激励的振动加速度的均方根值。将记录的数据利用最小二乘和优化设计的方法拟合成振动频率计权曲线。
The data were fitted to the same form of the frequency weighting Wk of ISO 2631-1 with the least square method and optimization of parameters.
应用推荐