涵盖麻田散体相的形成。显微组织与强度、韧性及延性间的关系将以整个课程所学到的观念加以阐述。
Martensite formation is covered. The relationships between microstructure and strength, toughness, and ductility is presented in terms of the concepts developed throughout the course.
用显微硬度、电子拉伸等试验方法，测定了银、铜、钽的硬度、抗拉强度、延伸率与冷加工变形量的关系及冷加工态银、铜、钽退火软化曲线。
The hardness, tensile strength and elongation of Ag, cu and Ta, their relationship with the degree of cold work and soften annealing curves of cold-worked Ag, cu and Ta were investigated.
目的：探讨结肠正常组织和腺癌组织的显微自体荧光图像差异与肠壁不同结构层次的荧光强度差异。
To investigate the difference of microscopic autofluorescence imaging of normal and adenocarcinoma colonic tissue, and the autofluorescence intensity difference among the colonic tissue layers.
用金刚锥显微脱粘法测得复合材料的界面强度。
The interfacial strength was measured using pyramidal diamond micro-debonding method.
材料的化学成份，显微组织等强烈影响磁声发射强度。
The chemical compositions and microstructure of materials intensively influence the strength of MAE.
结果表明，材料的磨料磨损主要由显微切削和显微裂纹两个因素控制，材料的耐磨性由其强度与韧性的配合所决定。
The results show that the abrasive wear loss is mainly controlled by micro-cutting and microcracking. The wear resistance may be determined by the combination of strength and toughness.
研究了不同荧光波长对双光子荧光共焦显微镜横向、纵向分辨率和光斑强度的影响。
The numerical results show that the transverse resolution, the axial resolution, and the intensity of the spot increase as the rate of fluorescent wavelength to illustrated wavelength increases.
目的：观察低强度激光血管照射对模拟失重兔显微红细胞聚集性的影响。
AIM: To explore the effect of intravascular low intensity laser irradiation in ear cavity on viscosity of red blood cell in rabbits of simulated weightlessness.
氧化铝的强度与其颗粒的独特显微形貌有着内在的联系，而氧化铝颗粒的显微形貌取决于铝酸钠溶液的分解工艺。
Inherent relation exists between the strength and micro appearance of alumina grain. And the micro appearance of alumina appearance depends on the precipitation process of aluminate liquor.
在合适的电刷镀工艺下，镀层表面平整、光滑，具有较高的显微硬度、耐蚀性和结合强度。
The layer is smooth with higher microhardness, corrosion and bonding strength by using the proper process.
与一般涂层相比，梯度涂层显示出更为优异的弯曲强度、结合强度、抗热冲击性、显微硬度分布及缓和热应力等性能。
As compared to general coating, gradient coating has even more excellent performances in bending strength, bonding strength, thermal shock resistance, microhardness and thermal stress relaxation.
脉冲参数对显微硬度和拉伸强度的影响符合相似的规律，但也有所不同；
The effect of pulse parameters on micro-hardness and stretch strength correspond to similar law, but different slightly.
研究了高强度细晶粒碳素钢焊接接头熔合区附近的显微组织及精细结构。
The microstructure and fine structure of weld fusion zone for high strength fine grain steel were studied.
分析了高强度合成铸铁中石墨和基体组织的形成过程，并将其与普通灰铸铁的显微组织进行对比。
The formation process of graphite and matrix structure in high strength synthetic casting iron was analyzed and compared with the microstructure of common grey iron.
元素在界面两侧的扩散是影响材料显微组织、表观硬度及界面结合强度的关键。
The interfacial diffusion of alloying element is an important factor to microstructure, apparent hardness and interfacial bond strength.
对45钢连接螺栓断裂件的显微组织、断口形貌、硬度和抗拉强度进行了观察分析和测试。
The microstructure, surface fracture morphology, hardness and tensile strength of the failed 45 steel connecting bolt were analyzed and tested.
通过立方体抗压强度试验和电子显微镜(sem)研究高含盐量对水泥土强度影响的内在机理。
By using cube compressive strength test and SEM, the inherent reason of the bad influence can be explored.
采用扫描电子显微镜(SEM)对表面多孔管进行检测，结果显示用新工艺烧结的表面多孔层质量好、结合强度高。
After inspected by SEM, the results indicated that the porous surface tubes sintered by the new process had high quality and strong joint strength.
研究了正火处理对FAS390Q桥壳钢显微组织、强度、冲击韧性和韧脆转变温度的影响。
The effect of normalizing on microstructure, strength, impact toughness and ductile-brittle transition temperature of FAS390Q axle housing steel was studied.
对质点强化型的高强度7475铝合金超塑变形中显微组织变化进行了研究。
The microstructural changes of high-strength aluminum alloy 7475 in the process of superplastic deformation were systematically investigated.
最后结合接头显微组织分析了组织因素对接头强度和塑性的影响。
Finally the effects of microstructures on the welds strength and ductility were discussed.
电铸镍的显微硬度和抗拉强度分别提高90%和130%。
For the nickel deposit, microhardness increased 90% and tensile strength increased 130%.
分别以应力分析仪和显微硬度仪测试两组试件的挠曲强度和硬度值。
The flexural strength and hardness of the specimens were tested with an instron testing machine and a microhardness tester.
成型的坯体表面平整、柔韧性好、有一定的强度、显微结构均匀。
The formed green thin substrate is smooth and flexible with a certain strength and uniform microstructure.
目的对应用激光扫描共聚焦显微镜进行荧光强度的测定条件做了详细的分析。
Objective To explore the conditions under which fluorescence intensity is determined in confocal laser scanning microscopy.
通过显微观察及板内结合强度测试，结果表明，蒸汽冷凝水对水溶性PF树脂胶有稀释作用，改变胶的流动和渗透性能。
The results of microscopic observation on the glue line and internal bond testing of the board showed that the condensed water would dilute PF and thus increase its flow and penetration into flakes.
由于晶核剂的补充加入，使烧结微晶玻璃的显微结构得到调整，并有利于提高强度性能。
The supplementary addition of nucleating agent caused the change of microstructure and the improvement of mechanical properties of sintered glass ceramics.
探讨了焊接工艺过程对气压焊焊接接头显微组织及强度的影响。
The effect of welding process on the microstructure and the strength of welded joint is discussed in the present paper.
目前常用的骨质疏松评价指标包括骨密度、骨代谢生化指标、骨生物力学强度及骨小梁显微结构。
The most widely used parameters of osteoporosis include bone mineral density, biochemical markers of bone metabolism, biomechanical properties and the microarchitecture of bone trabecula.
目前常用的骨质疏松评价指标包括骨密度、骨代谢生化指标、骨生物力学强度及骨小梁显微结构。
The most widely used parameters of osteoporosis include bone mineral density, biochemical markers of bone metabolism, biomechanical properties and the microarchitecture of bone trabecula.
应用推荐