然后你拿起那束纤维并稍微扭一下它,因为这样做可以进一步增加它的断裂强度。
Then you take that bundle of fibers and you twist it a little bit, because by twisting it, you increase its breaking strength even more.
分组测定热皱缩温度及断裂强度。
Heat shrink temperature and breaking strength tests were carried out.
断裂强度可满足或超越工业标准。
Published break strengths are average and meet, or exceed, industry standards.
高断裂强度及绝缘性能。
鞋类。鞋帮的试验方法。断裂强度和伸长率。
Footwear - Test methods for uppers - Tensile strength and elongation.
结果表明,螺栓的预紧应力接近材料的断裂强度。
The results suggest that the stress is close to the breaking strength.
探讨了陶瓷磨削表面残余应力对断裂强度的影响。
In this paper, the influence of the surface residual stresses of ceramics grinding on fracture strength has been studied.
利用压力爆破技术测量了圆形金刚石膜的断裂强度。
The fracture strength of circular diamond film was measured by a burst pressure technique.
鱿鱼的腕足断裂强度是影响鱿钓脱钩率的重要因素。
Broken strength of arms and tentacula of squid is a significant factor affecting the jigging-off rate.
织物各向的断裂强度和断裂伸长也比二向织物均匀。
A more uniform strength of rupture and the rupture elongation of the fabric can be obtained in each direction.
用于测定绞装和筒装生丝的断裂强度及断裂伸长率。
Used for testing breaking tenacity and elongation at break of raw silk in skein and bobbin.
冬青属的木才具有高抗断裂强度,是制作后缘的理想材料。
Holly has high tearing resistance and is excellent for trailing edges.
随着纤网定量的增加,断裂强度,撕破强度和顶破强度增加。
When webs weight increases, rupture strength, tearing strength and bursting strength are increased.
研究认为,触腕平均断裂强度低是造成高脱钩率的主要原因之一。
The results also indicate that the low broken strength of tentacles is one of the main causes leading to high jigging off rate.
氧化棉纤维的断裂强度和断裂伸长率随氧化程度的提高不断降低。
The breaking strength and elongation decreased as the degree of oxidation of cotton fiber I...
与此相反的是,此体系的断裂强度则随环氧树脂用量的增加而提高。
On the contrary, the tensile strength of the system improve with the increase of epoxy content.
实质断裂强度性能受到了外加载荷与磨削残余应力的组合应力的制约。
The real fracture strength is restrained by both stresses caused by outside load and residual stresses after grinding.
可供织物分析、设计时,方便地查找织物断裂强度及有关参数使用。
Thechart could be used to make fabric analysis and design easier.
结果表明;随着烧结温度的升高,开口气孔率降低,断裂强度升高。
Results show that the open porosities are decreased and fracture strength is increased with the increase of the sintering temperatures.
粗糙表面的晶粒间易产生V形口,导致应力集中,降低了膜的断裂强度。
Rough surface is easy to generate V shape of stress concentration, which reduce fracture strength.
分析结果表明纤维长度会对纱线性能,如断裂强度和断裂伸长率产生影响。
The conclusion is that the fiber length actually made a remarkable impact on the quality of MVS yarns, such as the rupturing intensity and elongate ratio.
得到了材料的断裂强度随微裂缝长度随机分布无序度的增加而降低的规律性。
It is obtained that the strength of the material decreases as the degree of disorder of micro-crack size distribution increases.
试验说明,随着芳香母粒含量的增加,出现纺丝困难,纤维的断裂强度下降。
The spinning process became complicated and the fiber strength decreased with the addition of fragrant masterbatch.
用于测定氨纶丝断裂强度、裂伸长率、伸长负荷、力松驰、性变形等性能指标。
Used for testing indexes of polyurethane monofilament, such as breaking tenacity, elongation at break, load at specified elongation, relaxation of stress, plastic deformation, etc.
杂质含量高的板材出现两次断裂现象,其最终断裂强度比普通板材高,但塑性差;
The SMA plate with the high content of impurity have two-step fracture phenomenon, whose ultimate fracture strength is higher than the normal one, however, its plasticity is worse.
结果表明,随阻燃剂的增加熔体的表观粘度下降,并且阻燃纤维的断裂强度也下降。
Experiments reveal that the apparent viscosity of the melt flameretardant PP decreases with increasing additive. The breaking strength of flameretardant PP fiber decreases with increasing additive.
结果表明,随阻燃剂的增加熔体的表观粘度下降,并且阻燃纤维的断裂强度也下降。
Experiments reveal that the apparent viscosity of the melt flameretardant PP decreases with increasing additive. The breaking strength of flameretardant PP fiber decreases with increasing additive.
应用推荐