存在一最佳放电电压效应。
There was a most suitable discharge voltage for the reaction.
用自放电电压的高低来判定电容器的质量。
The quality of electrolytic capacitor was judged by self-discharge voltage.
当放电电压达到400v时，晶粒尺寸略有回弹。
But when discharging voltage increases further to 400v, the grain size rebounds slightly.
性能稳定，低率放电电压平稳，无电压滞后现象。
Stable performance, low rate discharge voltage stable, no voltage hysteresis.
如果工频放电电压值超出范围，可对间隙进行微调。
If the working-frequency discharging voltage value exceed normal range, can faintly adjust the discharge gap.
空气绝缘起始放电电压在不同压力下表现出不同的特征。
The initial discharge voltage using pressured air as insulation medium has different characters under diverse pressures.
对两种预电离源的放电电压和电流进行测量，得到瞬态信息。
The transient discharge voltage and current of the two pre ionization sources were measured also.
采用本实用新型制造的锂电池，初始放电电压可提高约10%。
By adopting the lithium battery manufactured by the utility model, the initial discharge voltage can be improved about 10%.
结果表明：增加放电电压和电源频率可以提高PCP的降解率；
The results indicate that with increasing of discharge and power frequency degradation efficiency of PCP on AC increases.
分析了放电电压、致密次数、加热温度等因素对压坯致密度的影响。
The effects of the discharge voltage, compacting times and temperature on the relative densities of the compacted specimens are analyzed.
随着充放电电压的升高，首次不可逆放电容量增大，循环稳定性减弱。
With the increase of the charge-discharge voltage, electrochemical stability was reduced and irreversible capacity loss occurred during the first cycle.
结果表明，放电加热功率的大小与空腔尺寸、放电电压和工作气压有关。
The results show that power of discharge is related to the dimension of cavity, the voltage of discharge and the pressure of work gas.
同批次生产的相同规格的电池，电池内阻越小，电池的放电电压平台越高。
If the battery is produced in the same batch and has the same specification, the less of the resistance the higher of the discharge voltage plateau.
结果表明：在室温条件下，电池具有较好的循环稳定性和较高的放电电压平台。
The results showed that at room temperature, the battery had excellent cycle stability and high discharge voltage platform.
减少动态功耗的主要技术：（1）降低开关电容。（2）降低充放电电压摆幅等。
The main techniques used to decrease active power are :(1)reduce switch capacitance. (2)Minimize level of voltage which to precharge or discharge capacitance.
结果发现：在一定范围内，随着放电电压和放电频率的增大，CO2的转化率增大；
The results showed that the decomposition of CO2 could be enhanced by increasing applied voltage or frequency within limits.
考察了激光取样、辅助火花放电电压、电极尖端距离等条件变化时对分析结果的影响。
The influence of laser sampling, auxiliary spark discharge voltage, and electrode point gap on analytical results was examined.
试验结果表明增加放电电压、多次放电、对粉末进行预热，均能提高压坯的平均致密度。
The experimental results indicate that the relative density increases when improving the discharge voltage, increasing the discharge times and heating up the powder before compaction.
该方法具有放电电压低，陶瓷层结构致密与基体冶金结合，适用于多种金属材料等优点。
The method has some excellent characters, such as low voltage, fine and close texture, metallurgical bond with the substrate, suitable to various metal materials.
空气湿度在95%相对湿度下较40%相对湿度下，相同激光能量触发的放电电压提高5%。
When air humidity is 95%flashover voltage triggered by laser only increase 5%than that when air humidity is 40%.
直流辉光放电过程中需要控制的三个重要工作参数为放电电流、放电电压和放电室内氩气气压。
There are three important parameters in the DC glow discharge process, the discharge current, discharge voltage and argon pressure in discharge source.
对于电极表面有缺陷的情况，只要选取适当的电极表面轮廓模型，其起始放电电压也是可计算的。
In the case of electrode surface imperfections, the discharge inception voltage can also be calculated provided a suitable electrode surface profile model is chosen.
结果表明，适当的淬火，不仅增加了放电容量很大，但也可以改进的循环稳定性和放电电压特性。
The results show that proper quenching not only increased discharge capacity greatly but also can improved cycle stability and discharge voltage property.
然而在高倍率放电的条件下，电池的放电电压曲线会出现电压峰，同时电池的放电容量也有所增大。
However, when the battery was discharged at high rate, the voltage peak would be in the curve of discharge voltage and the discharge capacity would also be increased.
研究表明，虽然材料性能和放电次数对校形精度有一定的影响，但放电电压是校形精度的决定因素。
The studies indicate that materials properties and discharging times have effects on sizing precision, but the discharging voltage is the primary factor for the sizing precision.
数值求解了电路中各电容器和激光管的放电电压和电流脉冲波形，得到了与实测波形一致的模拟结果。
Numerical solutions of discharge voltage and current pulses on each capacitors and laser tube in the circuit are in good agreement with the experimental ones.
电火花线切割加工时工具(电极丝)和工件之间的放电电压是对放电加工过程进行实时检测的重要参数。
Voltage between tool and workpiece is an important parameter in the on line monitoring of wire electrical discharge machining (WEDM) process.
本文提出了测量电池放电电压曲线的同时测量二氧化锰电极电位，锌电极电位和电池内阻变化的新技术。
A new technique had been developed for measuring discharge curves of dry cells as well as the electrode potential of MnO2 and Zn electrode potential and internal resistance simultaneously.
对影响放电电压大小及频率的电源参数进行了讨论，如供电电压、控制信号占空比、振荡电路的R和C等。
Some parameters affecting the frequency and magnitude of power supply, such as supply voltage, duty of control sigal. the R and C of oscillation circuit are discussed.
讨论了一些影响放电电压大小及频率的电源参数，如供电电压、控制信号占空比、振荡电路的电阻和电容等。
Some factors affecting the frequency and magnitude of power supply, such as supply voltage, duty of control signal, the resistance and capacitance of oscillation circuit are discussed.
应用推荐