本文给出了频标放大器输出级相位噪声功率谱密度的公式。
A formula of phase spectrum density for transistorized amplifier is given.
第三，轨到轨放大器输出级增益与负载有关，这将影响放大器的开环增益，当然也影响了闭环增益的准确性。
Third, rail - to - rail amplifier output stages exhibit load - dependent gain which affects amplifier open - loop gain, and hence closed - loop gain accuracy.
现代运算放大器有某种方式的推挽式的输出级，许多也是不对称的，并且某一方向的压摆率有比其它方向的有更大的倾向。
While all modern op amps have push-pull OUTPUT stages of some sort, many are still asymmetrical, and have a greater slew rate in one direction than the other.
最初的集成运算放大器的输出级是NPN电流源的NPN放射追随器或通过电阻下拉，如图1.6所示。
The earliest IC op amp OUTPUT stages were NPN emitter followers with NPN current sources or resistive pull-downs, as shown in Figure 1.6.
采用位线平衡技术、高速两级敏感放大器及可预置电压的数据输出缓冲，以提高存储器的读写频率。
A fast access time is obtained by utilizing a bit line equalizing technique, a high speed hierarchical sense amplifier and a preset data output buffer.
LTC 6915是具有14级可编程增益的仪表放大器，采用轨对轨输出，其增益可通过串行或并行接口方便设置。
The LTC6915 is a precision programmable gain instrumentation amplifier with rail - to - rail output. The gain can be programmed to 14 levels through a parallel or serial interface.
由偏置在AB类的电流驱动的共源放大器构成输出级；
A current-driven common source amplifier which is biased on class AB constitute the output stage.
放大器级绝对没有任何关系与输出级拓扑。
Amplifier class has absolutely nothing to do with output stage topology.
列读出级采用新型主从两级放大列读出结构，其中主放大器完成电荷到电压的转换，从放大器驱动输出总线来满足一定的读出速度。
In the design of column readout stage, master and slaver structure has been adapted, where master amplifier converts charge to voltage, and slave amplifier works with standby mode to drive output bus.
在输出级设计时，为了提高效率，采用了推挽共源级放大器作为输出级，输出电压摆幅基本上达到了轨至轨；
When designing output stage, in order to enhance the efficiency, it uses the push-pull common source stage amplifier as the output stage, the output voltage swing basically reached rail-to-rail.
描述了光学放大器的输入和输出级的光路。
Optical circuits for optical amplifier input and output stages are described.
列读出级采用新型主从两级放大列读出结构，其中主放大器完成电荷到电压的转换，从放大器驱动输出总线来满足一定的读出速度。
In the design of column readout stage, master and slaver structure has been adapted, where master amplifier converts charge to voltage, and slave amplifier works wit.
给出了一种常用两级低电压CMOS运算放大器的输入级、中间增益级及输出级的原理电路图，并阐述其主要工作特性。
The principle figures of input stage middle gain stage and output stage for a usual two stage low-voltage CMOS operational amplifier and their principal performance are presented in the paper.
磁放大器后级稳压技术广泛应用于改善多路输出功率变换器的交叉调整率。
Magamp is an effective solution for improving cross regulation of multi-output power converter.
只要制造商不是评价的放大器，其输出功率在此截断的国家，放大器通常被称为A级，单端。
As long as the manufacturer isn't rating the amplifier for its output power in this clipped state, the amplifier would normally be called class a, single-ended.
第二，推挽A级放大器输出阶段将拥有固有拒绝电源纹波和噪声。
Second, a push-pull class A amplifier output stage will have inherent rejection of power supply ripple and noise.
两个功率放大器的输出级均采用PMOS和NMOS晶体管特殊设计而成。
Two power amplifier output stage using PMOS and NMOS transistors by the special design.
两个功率放大器的输出级均采用PMOS和NMOS晶体管特殊设计而成。
Two power amplifier output stage using PMOS and NMOS transistors by the special design.
应用推荐