考虑爆破强度是必需的，所需的撕裂强度。
Consider the bursting strength that is required and the tear strength desired.
耐机械操作性：具有高强度、高撕裂强度。
Resistance of mechanical operation: high strength and high tearing strength.
模具明年将作出从高撕裂强度室温硫化肯定的。
Next mold will be made from high tear strength RTV for sure.
硅胶管有一些限制，包括降低撕裂强度相比，PU管。
Silicone tubing has some limitations, including lower tear strength when compared with PU tubing.
其拉伸强度高、撕裂强度大、回弹性好、压缩永久变形小。
The light rubber plastic foam material has the characteristics of high tensile strength, high tearing strength, good rebound resilience and low compression set.
本文主要研究论述硫化体系对硫化硅橡胶老化后撕裂强度的影响。
In this paper, research on curing system of vulcanized silicone rubber aging tear strength after impact.
本文主要研究论述硫化体系对硫化硅橡胶老化后撕裂强度的影响。
The effects of beating and pressing on the tearing strength of paper also have been investigated.
纳米累托石的加入可以显著提高SBR和NR的硬度和撕裂强度。
The introduction of OR into SBR and NR enhanced their hardness and tear strength .
磺化油SEO、STO改善无铬鞣革的撕裂强度优于其他加脂剂。
The tearing strength of the chrome-free tanned leather stuffed by the sulfonated oil SEO, STOwer better.
例如，300%定伸应力提高了77%，抗撕裂强度提高了38%。
For instance, 300%modulus was increased by 77% and tear strength by 38%.
结果表明，增塑剂含量增加、增塑效率提高使涂层织物撕裂强度降低。
The results indicate that tearing strength of coated fabric decreases with the increase of the plasticizer concentration and plasticizing efficiency.
通过对涂层剂组成的调整，研究影响聚氯乙烯涂层织物撕裂强度的因素。
Influence factors of PVC coating agent on tearing strength of coated fabric by changing coating agent composition is studied in this paper.
物理性能参数间存在着相互关系，该文将以撕裂强度为例对其进行探讨。
There lie some correlations among mechanical properties. In this paper, we will take tear strength for example to discuss this correlation.
分析了在热硫化硅橡胶混炼胶撕裂强度的测试中撕裂强度出现偏差的原因；
The cause leading to deviation of tear strength in measuring tear strength of silicone rubber vulcanizate was analyzed.
隔膜的发展趋势是较高的孔隙率和抗撕裂强度、较低的内阻和良好的弹性。
The development trend of (separators) was high porosity and tearing strength, low inner resistance and good elasticity.
(低密度聚乙烯)：具有以下优良性质：高撕裂强度，高耐化学性，防水性。
LDPE (Low Density Polyethylene) : Offers such advantage as tear strength and high chemical resistance. It is also waterproof.
它比天然橡胶具有较好的抗挠曲开裂性能，但撕裂强度较低，动态模量较高。
It has a better flex cracking resistance than those of natural rubber but a lower tear strength and a higher dynamic modulus.
结果表明：PU弹性体的硬度、拉伸强度和撕裂强度随nco基含量增加而提高。
The results showed that the hardness, tensile strength and tear resistance of PU increased with the increasing percentage of free NCO.
随着体系中DCS含量增加，纸浆的抗张强度、撕裂强度、耐破指数均有所降低。
With the increasing of DCS, the tensile strength, tear index and burst index of pulp decreased in different degrees.
N326在天然橡胶中具有较高的拉伸强度、抗撕裂强度、耐磨性及抗蹦裂性能。
N326 in natural rubber high tensile strength, tensile strength and wear resistance and jumped cracking.
有效硫化体系的断裂伸长率、拉伸强度、撕裂强度、耐磨性、抗热氧老化性能最好。
The elongation at break, tensile strength and tearing strength of the HVSSBR cured with EV system are the best.
研究了黑化液组分的体积分数、黑化处理时间及温度对黑化层厚度及撕裂强度的影响。
Effects of volume percent of each component in oxidation solution, time and temperature of oxidation on thickness and tearing strength of blackened coating were studied.
LDPE(低密度聚乙烯)：具有以下优良性质：高撕裂强度，高耐化学性，防水性。
LDPE (Low Density Polyethylene) : Offers such advantage as tear strength and high chemical resistance. It is also waterproof.
产品的性能与特点：可以提高胶料的拉伸强度，撕裂强度和伸长率，且生热小、低回弹性。
Product Characteristics: it can improve tensile strength, tearing strength, elongation of rubber compound, and it has lower heating and low resilient.
结果表明，短纤维的加入显著提高了SFRC的撕裂强度、10%定伸应力及邵尔A型硬度；
The results showed that the filling of short fiber evidently improved tear strength, modulus at 10%and Shore A hardness of SFRC.
PVA改性增强了无纺布的力学性能，拉伸强度和撕裂强度分别提高了25.0%和21.6%。
PVA modification enhances mechanical performance of NWF, tensile strength and tear resistance are increased by 25.0% and 21.6% respectively.
方法：在相同条件下对两种硅橡胶材料进行吸水率、溶解率及撕裂强度测定，对其进行t检验分析。
Methods: the water sorption, the water solubility and the tear strength of two kinds of silicon rubbers were examined and evaluated under the same conditions.
测试结果表明，随着蒙脱土用量的增加，复合材料的定伸应力、拉伸强度和撕裂强度均大幅度提高。
The results showed that the tensile strength, elongation at break and tear strength increased with the OMMT content increasing.
磺化油SHO、STO、SEO改善铬鞣革撕裂强度的能力优于硫酸化鱼油、亚硫酸鱼油及硫酸化牛蹄油。
Superior to the sulfated fish oil, sulfited fish oil and sulfated neats-foot oil, the tearing strength of the chrome-tanned leather which stuffed by the sulfonated oil SHO, STO, SEO.
实验结果表明：与噻二唑类硫化体系相比，硫脲类硫化体系硫化的橡胶具有较大的拉伸强度、撕裂强度和断裂伸长率。
The effects of factors such as curing system, blending ratio, the kinds and content of fillers on the mechanical properties of CR/CM vulcanizates were also studied.
应用推荐