给出了摩擦力模型和电液伺服马达的静态特性。
Friction models and static characteristics of electrohydraulic servo motors are given in this paper.
本文将库伦摩擦力模型用连续摩擦力模型表示。
So a sequential friction model was replaced of coulomb friction.
本文提出了既能正确反映摩擦力特性又便于编程的连续型指数摩擦力模型。
This paper presents a sequential exponential friction model which describes not only the friction characteristics correctly but is also convenient for computer programming.
另有一种模型将气流归因于摩擦力。
An alternative model ascribes the stream to frictional forces.
从不同角度出发考虑了联合动力装置系统中各部件间的摩擦力因素的影响，建立了三s离合器啮合过程的数学模型。
Considered from different perspectives the influence of friction factors of each part of combined power plant, set up the mathematical model of s.
文中建议了考虑活动支座摩擦力影响的简支梁桥整体分析模型。
An analytic model including effects of frictional force at movable supports is suggested.
结合湛江港某码头工程基桩，用模型试验模拟现场地质情况，对港口单桩、排架桩基负摩擦力进行模型试验。
The test of negative skin friction along the single pile or wharf bent piles, which is modeled after piles of ZanJiang harbor, is studied.
当接触面被完全剪断后，模型中的剪切应力出现了一定程度的下降，此后的剪应力在摩擦力的作用下基本保持不变。
However, as the interface was fully damaged, shear stress would decrease to a certain degree, and the residual shear stress nearly kept a constant value which equal to the friction force.
基于分形几何理论，推导出了滑动摩擦力分形预测模型，并从理论上对该模型的正确性进行了分析。
A fractal prediction model of sliding friction forces was derived based on the fractal geometry theory. The validity of the model was verified theoretically.
结果表明，连续墙基础内侧土体不提供竖向摩擦力和水平抗力，在设计这种基础时可按空心基础建立计算模型。
The calculating model of a hollow foundation was established in designing this foundation, which hoppened to be in conformity with the research results.
针对直接驱动阀阀芯摩擦力，论述了基于模型的摩擦力自适应补偿。
An adaptive friction compensation scheme for direct drive valve was proposed based on LuGre model.
利用单峰接触的模型，建立了相对湿度与摩擦力关系的公式。
The maximum static friction force goes up with the relative humidity…
采用复数法，在不考虑摩擦力的情况下建立了单缸四冲程内燃机的力分析数学模型，确定了计算框图，并编制了专用的计算机程序。
A calculation method for force analysis of the internal combustion engine with four strokes was established, and a flow chart was presented.
采用复数法，在不考虑摩擦力的情况下建立了单缸四冲程内燃机的力分析数学模型，确定了计算框图，并编制了专用的计算机程序。
A calculation method for force analysis of the internal combustion engine with four strokes was established, and a flow chart was presented.
应用推荐