本文通过分别对非线性和线性反演方法的优缺点进行分析，提出了一种求解地震自动剩余静校正问题的两步法。
Analyzing the advantages and the shortcomings of linear and non-linear inversion methods, the paper presented a method in two steps for estimation of seismic automatic residual statics.
提出了一种可解决超音速、亚音速、跨音速、冲击波共存的流场计算方法，即变形流体网格两步法。
The paper presents a new computational method named two steps various shape FLIC method, applied for the existence of the supersonic , sub critical sonic , transonic, shock wave.
提出了一个考虑模态噪声影响的基于残余力向量法的损伤识别两步法。
A new two-step damage identification method based on residual force vector considering the impact of measurement error (noise) in most cases is proposed.
针对泵站电机和水泵特性的双馈调速系统设计，提出了两步法交流励磁控制策略。
This paper introduces the design of Doubly-fed system according to the characteristics of induction motor and pump, and points out a new strategy of ac excitation in two steps.
在此基础上，我们又提出了解决旅行商问题的两步法，大量的仿真实验表明这一算法取得了良好的效果。
On this basis, we proposed a two-step solution of the traveling salesman problem, a large number of simulation experiments show that the algorithm has produced good results.
文摘：介绍了金属表面清洗过程中清洗液的净化处理工艺，提出酸化中和、丙纶毡吸油两步法处理废液，处理后的废水达到了国家废水二级排放标准GB8978- 88。
Abstract: the article described the cleanse treatment technology of the cleaning mixture. Put forward using acidizing and polyacrylate to treat waste fluid and reach GB8978-88.
介绍了金属表面清洗过程中清洗液的净化处理工艺，提出酸化中和、丙纶毡吸油两步法处理废液，处理后的废水达到了国家废水二级排放标准GB8978 - 88。
The article described the cleanse treatment technology of the cleaning mixture. Put forward using acidizing and polyacrylate to treat waste fluid and reach GB8978 88.
而对于责任承担，提出了“两步法”按份分担损失，同时指出由于不能发现真正的行为人，不能对受害人的精神损害进行赔偿。
As for the bearing of the liabilty, It must shar the liabilty according to way of "two-step". It's hard to compensate the victim's spiritual damage, because we can not find the real actor.
针对多点成形件成形误差检测中的三维数据配准问题，提出了一种用两步法将CAD模型数据和三维测量数据点全局配准的方法。
In this paper, a new method for the global registration of the CAD modeling data to the 3d measured data is presented.
针对多点成形件成形误差检测中的三维数据配准问题，提出了一种用两步法将CAD模型数据和三维测量数据点全局配准的方法。
In this paper, a new method for the global registration of the CAD modeling data to the 3d measured data is presented.
应用推荐