与数字多用表不同，微欧姆计没有内部电阻器(RS)，所以四条引线都要连接才能进行测量。
It doesn't have the internal resistors (rs), as in the DMM, so all four leads must be connected to make a measurement.
这个小的电阻值通常用数字多用表或者微欧姆计来测量。
This small resistance is normally measured with a DMM or a micro - ohmmeter.
对于大多数的应用来说，微欧姆计或数字多用表足以用来进行接触电阻的测量工作。
For most applications, the micro-ohmmeter or DMM is sufficient for contact resistance measurements.
热敏薄膜电阻制备是非致冷微测辐射热计红外焦平面的一项关键技术。
Preparation of thermal sensitive thin film resistor is one of key technologies in uncooled micro bolometer IR FPA fabrication.
用夹钳装置2381和一个微欧计的帮助，测试电缆的欧姆电阻和材料的取样以束或条的形式能被测量。
With the help of the clamping device type 2381 and a microhmmeter, the ohmic resistances of test cables and samples of materials in the shape of cords or strips can be measured.
图1 - 24所示的脉冲驱动模式使微欧姆计能够消除被测未知电阻上的寄生偏置电压。
The pulsed drive mode, shown in Figure 1-24, allows the micro - ohmmeter to cancel stray offset voltages in the unknown resistance being measured.
使用微欧计进行电阻测量必须采取四线技术以使测试电缆和连接器带来的误差减至最小。
Measurements made using the micro-ohmmeter are always performed using the four-wire technique in order to minimize errors caused by test leads and connections.
使用微欧计进行电阻测量必须采取四线技术以使测试电缆和连接器带来的误差减至最小。
Measurements made using the micro-ohmmeter are always performed using the four-wire technique in order to minimize errors caused by test leads and connections.
应用推荐