循环试验结束后，后斜门应满足第25部分的拉力要求。
After the cycle test, the door shall meet the pull force requirements of section25.
目的探讨微循环试验在磁保健用品的功能评价中的应用。
Objective to explore the application of auricle microcirculation test to functional evaluation on magnetic health care products in mice.
论述了在100MW机组电站锅炉所作的低负荷水循环试验。
Water circulation reliability tests were held at low loads in a 100mw utility set's boiler.
为了解决这些疑问，海恩斯带领一组研究人员在做一个最新循环试验。
To settle some of the doubts, Haynes led a team of researchers in a modern redux of the experiment.
拉伸和疲劳循环试验说明了所研制的仪器能有效地检测构件的应力集中。
Tensile and fatigue tests showed that this detector can effectively detect Che stress concentration of ferromagnetic component.
对316L不锈钢进行了单轴应变控制和应力控制下的系统循环试验。
An experimental study was carried out of the cyclic properties of 316l stainless steel subjected to uniaxial straining and stressing.
本文介绍了中空玻璃气候循环试验台循环供水系统的设计原理及设计方案。
This article introduces the design principle and design project of circulating water supply system for the hollow glass climate circulating test bench.
对316L不锈钢进行了单轴应变和应力控制下的室温和高温循环试验。
An experimental study of the cyclic properties is carried out for 316l stainless steel subjected to a uniaxial straining and stressing at both room and elevated temperature.
主要讨论了大瓷套冷炸、温度循环试验中炸裂及瓷套经磨削入库后开裂的原因。
The factors of cold cracking of large porcelain sheel, cracking in temperature circulating test and cracking before warehousing are discussed.
本文利用空间环境效应地面模拟设备对环氧结构胶粘剂进行了真空热循环试验。
In this paper, using ground-based simulation facilities, the vacuum thermal cycling test was carried out on the epoxy construction adhesive.
本文利用空间环境效应地面模拟设备对环氧结构胶粘剂进行了真空热循环试验。
Study on preparation and properties of heat-resistant epoxy adhesive cured at room temperature;
快速充电用于循环试验时，经几次循环后要用标准充电法将电池恢复至完全充电态。
When the rapid charge was adopted for the cycle test, the battery should be restored to full charge state by the normal charge after a few cycles.
对冻融循环试验结果研究，提出基于动弹性模量衰减的纤维轻骨料混凝土冻融损伤模型。
The research to establish a model of freeze-thaw damage of fiber reinforced lightweight aggregate concrete for relative dynamic elastic based on experimental results has been done.
采用热风循环试验干燥机对杉木木束进行干燥速度与能耗试验，探讨杉木木束的干燥性能。
In this paper, experimental study on drying efficiency and energy consume of China firs wood bunch was performed in a circular hot-air dryer.
采用拉、压循环试验测试了AZ31镁合金的包辛格效应(BE)，并研究了BE的机制。
The Bauschinger effect (BE) of AZ31 magnesium alloy was tested by the experiment of cyclical tension and compression, and the mechanisms of BE were investigated.
特别针对砂性土壤，提出了应用室内三轴循环试验的结果评估单桩在单向循环侧向力下的变形方法。
The usually used design method, p-y curves method, is unsuitable for estimating the deformation response of the large-diameter monopile under long-term cyclic lateral load.
本文通过对光缆拉伸试验和温度循环试验的论证，揭示出在光缆生产过程中选择合适余长的重要性；
Tensile and temperature tests of the optical fiber cable were carried out. Results of these tests showed proper cxcess fiber length selected during the cable production.
采用高倍率放电循环试验方法，研究了阀控免维护铅酸蓄电池在循环过程中端电压和容量的变化规律。
The variation of discharge voltage and capacity for VRLAB were investigated by means of cyclic tests at high discharge rate.
经过100次相变循环试验，表明相变储能陶粒表面保持完好，相变材料的质量损失率均在5%以下。
The surfaces of all the phase change energy storage ceramsites were intact after 100 cycles of phase change, and the loss rate of the mass of phase change materials were below 5%.
野外采集原位岩石、江水样品，进行饱和-烘干循环试验，在单轴压缩状况下进行声发射(AE)特性试验。
Field in-situ rock, river water samples, saturated - drying cycle experiment was carried out, under the conditions of uniaxial compression characteristics of acoustic emission (AE) test.
在大功率泵机组循环试验中，其介质温升是一个很严重的问题，温升大小对于整个试验的安全具有重要意义。
In circulating test of heavy power pump set, the temperature rising of medium is a problem to be focused on, and the scope of temperature rising is of importance to the safety of overall test.
论述了各种类型热试验（热平衡试验、热真空试验、热循环试验） 在航天器研制中的重要性及它们的做法要点。
The paper discusses the importance and implementation of various types of thermal tests (thermal balance test, thermal vacuum test and thermal cycling test) during the spacecraft development phase.
我们将介绍新合金材料的基本属性以及在表面贴装应用中的验证结果，特别是在跌落冲击和温度循环试验的结果。
The basic properties of the new alloys shown here were fully characterized and their use in SMT applications evaluated, especially in drop shock and temperature cycling tests.
良好的环境控制系统：（1）于持续循环试验中，臭氧浓度仍能够快速达到平衡 （2）测试槽具有自动持温功能。
Excellent system control: (1) Maintaining rapid resumption of O3 concentration during continuous circulation (2) With the ability of automatically and steadily keeping the chamber temperature.
冻融循环试验表明，由于净浆、砂浆和混凝土这三种水泥基材料孔结构的不同，使得其破坏时的外观和断面形状各不相同。
Freezing and thawing test shows that the figuration and cross-section of cement-based materials (paste, mortar and concrete) are different after they damage because of their different pore structures.
采用盐雾和紫外-冷凝室内人工加速老化循环试验的方法，对聚氨酯和丙烯酸两种典型的船壳涂料进行人工加速老化试验。
The degradation of two coatings systems based on polyurethane and acrylic were studied by exposed in UV-condensation chamber and salt-fog chamber alternately.
结果表明，在常温充电-低温放电循环试验中，电池的循环寿命次数仍能达到200次的要求，证明了镉镍蓄电池良好的耐高温性能。
Results of evaluations to date indicate that the number of cycle life attains standard target of 200 times, which reflect good high temperature performance.
真空热循环试验前后CF/EP层合材料的拉伸性能由电子万能材料试验机完成，本文利用扫描电镜观测试样表面形貌和拉伸后的断口形貌。
The tensile strength and Young's modulus of CF/EP specimens before and after vacuum thermo-cycling were measured by an electrical universal material testing machine.
真空热循环试验前后CF/EP层合材料的拉伸性能由电子万能材料试验机完成，本文利用扫描电镜观测试样表面形貌和拉伸后的断口形貌。
The tensile strength and Young's modulus of CF/EP specimens before and after vacuum thermo-cycling were measured by an electrical universal material testing machine.
应用推荐