利用影响系数法进行不平衡量的解算。
The unbalancing value was resolved with influence coefficient method.
论证了矢量计算法和影响系数法的一致性。
Consistency of vector calculation and influence coefficient methods was verified.
最后，对柔性转子动平衡中的影响系数法进行了探讨。
Finally, the influence coefficient method is used to balance the flexible rotors.
本文采用力学中的影响系数法计算主轴部件的静刚度。
In this paper the method of influence coefficient in mechanics is used to calculate the static rigidity of spindle parts.
利用影响系数法进行现场动平衡，很好地解决了问题。
This problem can be well settled by influence coefficient method to carry out dynamic balance in the field.
基于转子动平衡的影响系数法，本文提出了相对系数法。
A relative coefficient method for rotor dynamic balancing is developed based upon the influence coefficient method.
将影响系数法应用于水轮发电机转子现场动平衡，消除其振动故障。
The influence coefficient methods were applied in dynamic balance of hydrogenerator rotor at site to solve the vibration fault in this paper.
本文系统地阐述了平面连杆机构运动与运动误差分析的影响系数法。
This paper presents systematically a Kinematic Influence coefficient method for kinematic and kinematic error analysis of planar linkages.
提出了基于影响系数法的快速单面平衡策略，并将此法推广到双面平衡。
The quick balance strategy for 1-plane is brought forth based on the influencing coefficient method, and idea is further spread to 2-plane automatic balance.
影响系数法是利用线性系统中校正量和被测量之间的线性关系进行转子动平衡。
The linear relationship between the corrected value and measured value is used to balance the rotor in the influence coefficient method.
本文针对精密离心机机械结构的特点，用影响系数法对精密离心机进行动平衡。
According to the characteristics of precision centrifuge mechanical structure, the precision centrifuge dynamic balancing system was realized.
重点探讨了影响系数法中参数K的确定原则和相应技术，并与估计邻域法做了对比分析。
Especially Discussed ascertaining principles of K value and correspond technic in the Influencing Coefficient Method, contrasting with the Estimating Neighborhood Method.
本文是从分析挠性转子的不平衡单质量的动态响应出发，找出用影响系数法平衡挠性转子的理论依据。
The dynamic response of unbalanced single disc rotor is analysed and theoretical aspects of flexible rotor balancing by the influence coefficient method are studied.
其次深入研究了旋转机械动平衡原理及其作为动平衡方法之一的影响系数法，将幅相影响系数法应用到系统中。
Secondly, the dynamic balance's fundamental and amplitude-phase influence coefficient method are studied and the latter will be applied into the system mentioned above.
针对每个离散角速度，依据影响系数法，采用包含残余振动值和校正不平衡的广义线性二次型目标性能函数推导出控制律。
For each discretized angular speed, the control law is derived from the generalized linear quadratic objective performance function including residual vibration measurements and imbalance correction.
通过分析海铁联运运量的影响因素，提出基于集装箱货值的改进生成系数法来预测海运进出口集装箱内地生成量；
On the basis of analysis of the factors effecting rail-sea intermodal transportation volumes, this article presents the improved production coefficient method calculated by value instead of by weight.
通过改进传统的相关系数法进行通道交通需求预测，分析了交通需求的相关影响因素。
Traditional correlation coefficient method was improved for corridor traffic demand forecast; accumulating and dispersing nodes and correlative influence factors of traffic demand were analyzed.
文章利用解析法研究了材料热膨胀系数对温度场中太阳电池板最大应力的影响。
The effect of thermal property on the stress distribution in solar panel in thermal field is studied analytically.
最后分别运用偏相关系数分析法和单项因子权重度量法来估算各因子的影响程度。
Finally, the affected degree of factors is evaluated by applying partial relation coefficient analysis method and single factor weighted index method.
为了消除端点和假频影响，文中采用了双曲线速度滤波法和相似系数法。
Hyperbolic velocity filtering and similar coefficient method are introduced to remove the influences resulting from end-point effect and alias.
通过应用瑞利里兹法研究了分层椭圆几何参数和缝线等效弹性系数对压缩屈曲载荷的影响。
The effects of geometry parameters of ellipse and stitching thread on buckling loads are investigated by Rayleigh Ritz energy method.
本文讨论了常用的噪声系数测试方法—Y因子法中高频及中频衰减器本身失配和测试系统中其它部分的影响所造成的测试误差。
This paper discussed the error in the measurement of noise figure—The method of Y factor , The error is caused by mismatch of RF attenuater and IF attenuater and the others in the measurement system.
采用应力释放法模拟盾构法隧道开挖时，合理地确定生成衬砌前的应力释放系数是至关重要的，它对地表变形以及衬砌内力的影响非常明显。
When the method of stress releasing is adopted to model shield-driven, it is very important to determine the coefficient of stress releasing before lining is built.
采用电磁场有限元法，考虑上述因素的影响，得到了各种情况下的计算极弧系数曲线。
Taking the effects of above factors into account, 2D FEM is adopted and a series of curves to determine the coefficient are achieved.
应用基尼系数法，分析了1984 - 1996年河南省农村区域经济差异变化的趋势及其影响因素。
Applying the method of Gini Coeffcient, the trend of the variation of rural regional economy differences of Henan province from 1984 to 1996 and its factors affecting are analyzed.
层次分析法能够确定各个因素的影响系数，该系数亦可作为权重赋值给数据库，最终作为栅格图片的一个重要参数。
AHP to determine the impact of various factors coefficient, the coefficient can be as a weight assignment to the database, and ultimately as a raster picture of an important parameter.
同时，本方法利用有限元法分析的应力和孔隙水压力结果，按有效应力法计算边坡安全系数，可分析施工过程中应力和孔隙水压力变化对边坡最小安全系数的影响。
On the other side, the proposed method can also consider the influence of the change of stress fields and pore pressure field on the minimum factor of safety by the finite element analysis.
完全相关系数法分析表明，气温日较差和平均风速的减小与蒸发皿蒸发量的减少具有最显著的相关性，是蒸发皿蒸发量减少的影响因子。
And decreases in diurnal temperature range and wind speed were found to be the main influencing factors leading to the decrease of pan evaporation.
本文综述了采用示波原理间接测量血压方法的研究进展，并介绍了波形特征法和幅度系数法两类血压判别方法的基本原理，对影响其测量精度的因素进行了分析。
The paper expatiated it on the basis of different algorithms in this field by dividing them into two categories named as feature point method and amplitude characteristic ratios method.
本文综述了采用示波原理间接测量血压方法的研究进展，并介绍了波形特征法和幅度系数法两类血压判别方法的基本原理，对影响其测量精度的因素进行了分析。
The paper expatiated it on the basis of different algorithms in this field by dividing them into two categories named as feature point method and amplitude characteristic ratios method.
应用推荐