弹性轴承、中心部件和缓冲器安装在悬臂固定在桥上的部分。
The elastomeric bearing, the centering member and the buffers are mounted on a cantilever on the fixed part of the bridge.
当桥梁通道关闭时，两个油压缓冲装置提供除了弹性轴承外的支撑。
When closing the bridge two Oleo buffers are provided in addition to the elastomeric bearings.
这座桥由弹性轴承支撑，并在移动过程中由一个定心元素将它带到中间适当的位置之上。
The bridge is supported by elastomeric bearings and is brought into the correct position by a centering element in the middle in the process of movement.
没有轴承失败或弹性联轴器的要求，因为它的磁化鼓大会直接连接到轴。
There are no bearings to fail or requirements for flexible couplings because its magnetized drum assembly is attached directly to the shaft.
本文采用非线性分析方法研究了同时考虑支承阻尼和转子外阻尼的弹性支承滑动轴承系统的油膜失稳振动问题。
This paper studies the film unstable vibration of bearing system supported by flexible support considering both support damp and rotor extemal damp by use of nonlinear analysis.
本文建立了同时考虑支承阻尼和转子外阻尼在内的弹性支承滑动轴承系统模型。
The paper established a modal of bearing system supported by flexible support considering both support damp and rotor external damp.
假设柔性轴承的寿命符合韦布尔分布，应用赫兹弹性接触理论和滚动轴承额定动负荷理论进行柔性轴承的寿命分析。
Hertz contact theory and dynamic load rating theory are used to study flexible bearing life assuming that the life is coincident with Weibull distribution.
艉轴承弹性模量、径向间隙、厚度对接触压力分布有明显的影响。
The contacting pressure of the stern bearing is influenced with its elastic modulus, radial clearance and thickness.
弹性金属塑料瓦以其独特的性能，在水轮发电机组推力轴承上得到广泛应用。
With excellent performances, the elastic metal-plastic pads are widely used in the thrust bearing of the water turbine generator sets.
本文将转臂轴承视为弹性环节建立并提出适合于这类传动的变形协调普遍方程。
In this thesis, the equations have been set up through treating bearings of rocker arm as elastic component.
研究了弹性支承滑动轴承系统的油膜稳定性理论。
This paper studies the film stability theory of the sliding bearing system with elastic support.
设计参数合理的外弹性阻尼支承可以明显改善轴承-转子系统的固有特性及强迫振动响应。
External elastic damping support, if designed reasonably, may obviously improve the natural or forced vibration response characteristics of bearing rotor systems.
研究表明，在所研究的频率范围内，弹性轴轴承系统存在两阶自然频率。
The result showed that a flexible shaft-bearing system has two order natural frequencies.
另外，轴承(18)的外圈(23)显示出一定的径向弹性。
In addition, the outside lane (23) of the bearing (18) displays a definite radial elastic.
没有弹性联轴器是必需的，而且没有轴承磨损，这意味着更大的机械可靠性。
No flexible shaft coupling is required, and there are no bearings to wear out, meaning greater mechanical reliability.
弹性金属塑料轴瓦是大型水轮发电机推力轴承的关键性部件，其性能的好坏直接影响到整个系统运行的动态品质。
Elasto metal plastic bearing pad is key part of large hydraulic turbine thrust bearing and its performance being better or worse directly influences the dynamic quality of whole system running.
转子-轴承系统中包括弹性轴、刚性圆盘以及具有阻尼和刚性的径向轴承。
The system consists of elastic shaft , rigid disks and bearing which has damping and stiffness.
轧辊弹性弯曲微尺度行为的机构学控制与轧机滚动轴承延寿方法的成果，已获国家科技二等奖；
The mechanism control method of roll micro dimensional elastic deformation and achievement of mill rolling bearing longevity prolongation research are awarded the national technology two degree.
本文介绍了水轮发电机弹性金属塑料瓦推力轴承的变形分析和瓦面形状的设计方法。
This article briefly introduce the design and operational aspect of water turbogenerator elastic metallic plastic guide bearing.
该模型考虑了轴承，轴和齿轮啮合弹性。
This model considers the elasticity of bearings, shafts and gear meshes.
研究了非线性弹性转子-轴承系统的轴心轨迹，认为对称不平衡转子是连续弹性轴，它两端支撑在滑动轴承上，油膜反力采用非线性短轴承模型。
With reference to a symmetrical unbalanced rotor treated as a continuous elastic shaft suPPorted at its end by lubricated journal bearings, the short bearing model is adoPted.
考虑到永磁轴承约束为弹性约束，永磁轴承约束的悬挂式单自由度陀螺罗盘实质为永磁轴承约束的悬挂式二自由度陀螺罗盘。
Because the restraint of PMB (permanent magnetic bearings) is the elastic restraint, suspended SDOF gyrocompass restrained by PMB, in fact, is not SDOF gyrocompass, but two DOFS gyrocompass.
该系列的HS20密封Hollowshaft的浮动轴安装和春季系绳轴承负荷减少和消除弹性联轴器，减少磨损和维护。
The Series HS20 Sealed Hollowshaft's floating shaft mount and spring tether minimize bearing loads and eliminate flexible shaft couplings to reduce wear and maintenance.
通过有限元计算及光弹性实验，结果证明，滚针轴承的接触应力分布与轴承手册和教科书中所给出的公式不符。
After calculating with finite element method and photoelastic-test, it shows that the contact stress distribution is not in keeping with the formulas given by some bearing hand books and textbooks.
本文研究了自动调心分离轴承装置的结构和调心原理，分析了弹性元件载荷与变形的关系，给出了分离轴承接触角和极限轴向负荷的确定方法。
The relation between load and deformation of the spring element is analysed and the calculating methods of constant angle and maximum axial load are set up.
在轴承与主轴支撑面的径向位置上设有的热膨胀量和弹性变形余地。
The radial position between the bearing and the supporting surface of the main axis is provided with a space for the heat inflation and the springy transformation.
弹性体轴承，发动机支架，电子设备支架，调谐吸震。
Elastomeric Bearings, Engine Mounts, Avionics Mounts, Tuned Vibration Absorbers, Tension-Torsion Straps, Dampers.
滚动轴承一般按经验公式估算其刚度特性或简化为定常的弹性元件，但误差较大。
Rolling bearing stiffness is usually estimated empirically and it is simplified as a constant stiffness element. This method often causes large error.
滚动轴承一般按经验公式估算其刚度特性或简化为定常的弹性元件，但误差较大。
Rolling bearing stiffness is usually estimated empirically and it is simplified as a constant stiffness element. This method often causes large error.
应用推荐