为配合卷板设备数控系统的研制和对卷板工艺过程进行优化，建立了三辊数控卷板成形过程的弹塑性大变形接触问题的有限元模型系统。
To cooperate with the development of the numerical control system of plate bending and to optimize the process, the deform law of this process has been studied.
应用有限棱柱单元法对群桩与土相互作用系统进行了三维弹塑性分析，并以无限棱柱元模拟半无限空间地基土的边界条件。
In this paper, the three dimensional elastoplastic analysis of a group pile soil interaction system is made by using the finite prism element method.
对电厂管道支吊架系统中的花蓝螺丝进行了弹塑性有限元分析。
This paper carried out an elastic - plastic finite element analysis on the petal basket - like screw cap used in many pipe support - hang systems.
基于动力学和弹塑性力学理论，采用轴对称有限单元法系统地分析了软土地基上半刚性基层沥青混凝土路面结构体的工作性状。
On the basis of the theory of dynamic mechanics and elastic-plasticity mechanics, the asphalt pavement of semi-rigid subbase on the soft clay ground is analyzed using the axisymmetric FEM.
本文对有限弹塑性变形中关于应变及应变率的分解问题进行了系统的评述。
The paper presents a systematical review on the recent studies for the problem of decomposition of strain and strain rate in finite elastoplastic deformation theory.
根据弹塑性有限变形理论，用有限元法建立了卫星推进系统贮箱金属膜片变形的有限元分析模型。
According to the deformation of elastic-plastic theory, the finite element analysis model of metal diaphragm for tank of propulsion system in satellite was established in this paper.
本文采用I -DEAS软件作为计算机辅助分析的工具，基于弹塑性有限元理论和传热学理论，建立了工作状态下主轴系统的有限元分析方法及技术处理方法。
Based on elastic FEM theory and heat transfer theory, the author USES I-DEAS software as a CAE tool, builds the finite element analysis method and techniques of the principle shaft system on work.
本文针对高压全缠绕复合材料压力容器，应用有限元分析系统对其应力偏大的筒身应力进行了弹塑性非线性数值模拟。
In this paper the finite element analysis is applied to simulate the elastic-plastic numerical value for the high-pressure full wrapped composite pressure-vessel.
运用多刚体系统动力学及接触冲击理论建立了节理岩体弹塑性动态本构模型。
In this paper, a elastic-plastic dynamical constitutive model on jointed rock masses under blasting load is established with the help of the multiple rigid-body dynamics and contact-impact theory.
以汽车碰撞模拟试验系统中台车与吸能器之间的碰撞接合为例，设计弹-塑性缓冲结构。
By studying crash-connection between the sled and the absorber of car crash simulation system, the buffer of elastic-plastic material structure is designed.
使用大型三维非线性有限元程序（TFINE），对拉西瓦拱坝-地基系统进行了三维弹塑性有限元数值模拟，对该拱坝-地基系统在正常荷载下的位移和应力进行了分析。
This paper presents the elastoplastic numerical results of Laxiwa arch dam-foundation system by employing 3D non-linear FEM code, TFINE. Displacements and stresses of the dam were analyzed.
同时对某水电站引水隧道系统进行了三维粘弹塑性有限元数值模拟和三维弹塑性有限元数值模拟。
In this paper, a 3-d visco-elastoplastic FEM and a 3-d elastoplastic FEM are used to analyze the stability of the excavation structure of one hydropower station diversion tunnel system.
应用动力弹塑性分析方法对高土石坝的地震反应特性和破坏机理进行了系统研究。
The main purpose is to study the seismic response and failure mechanism of high earth-rockfill dams under earthquakes by using dynamic elastoplastic methods.
应用动力弹塑性分析方法对高土石坝的地震反应特性和破坏机理进行了系统研究。
The main purpose is to study the seismic response and failure mechanism of high earth-rockfill dams under earthquakes by using dynamic elastoplastic methods.
应用推荐