该系统包括单片机系统电路、寻迹检测电路、平衡检测电路、步进电机驱动电路、数码显示电路等。
The control system consists of AT89S52 single chip computer system, autonomous tracing circuit, balance detection circuit, driving circuit of stepping motor and LED display circuit.
分析了NDP在电火工品无损检测中电桥自动调平衡的方法、参数计算及硬件电路和软件流程图。
Analyzes the method of auto balance, parameter calculation, hardware circuit and software flow chart of electric bridge of NDP in the non -destructive testing of EED.
分析车轮动平衡检测的基本原理，设计信号检测的硬件电路。
Basic principle for the dynamic balance detection of wheels is analyzed, and a circuit for signals detection is designed.
检测电路分为全桥平衡模块、电荷放大器模块、信号放大模块、相关双采样模块、采样保持模块、闭环反馈模块、低通滤波模块和数字时序控制模块。
The circuit is divided into full bridge module, charge sense amplifier module, correlated double sampling and holding module, closed-loop feedback module, low-pass filter and time controlling module.
检测电路分为全桥平衡模块、电荷放大器模块、信号放大模块、相关双采样模块、采样保持模块、闭环反馈模块、低通滤波模块和数字时序控制模块。
The circuit is divided into full bridge module, charge sense amplifier module, correlated double sampling and holding module, closed-loop feedback module, low-pass filter and time controlling module.
应用推荐