运用超动态应变测试技术、超声波检测仪对层状复合岩体的爆破损伤破坏机理和破坏过程进行了实验研究。
By use of dynamic strain testing, the ultrasonic wave, bedded composite rock damage and fracture mechanisms and the fragmentation process during blasting have been experimentally studied.
在砂砾石中进行的平地定向爆破实验得到了较为集中的堆积体。
In experiments of directional blasting on flat ground the piles of the thrown grits are comparatively concentrated.
以最新的激光动光弹为实验手段，对初始应力条件下的爆破应力波的传播过程进行了实验研究。
A new dynamic holophotoelasticity method is used in laboratory test to study propagation of dynamic stress by blasting subjected to initiative stress.
介绍了爆破漏斗的实验设计和实验方法，并对实验结果进行了分析。
The experiment design and method of loose blasting funnels are introduced in this paper, and an analysis of the test results is carried out.
实验还利用扫描电镜、X—射线衍射、紫外光谱、红外光谱及XPS电化学分析能谱等现代分析手段进行了爆破法制浆的微观研究。
Simultaneously, the advanced analytic technology of SEM, X-ray diffraction spectrum, UV spectrum, IR spectrum as well as XPS were used to analyze the microcosmic of explosion pulp.
实验结果表明，用本文公式计算孔槽型平膜片的爆破压力，完全符合工程要求。
Experiments showed that the bursting pressure of hole-slot flat rupture discs calculated by the formula well met the requirements of engineering.
本文分析了槽孔断裂控制爆破的理论依据，对其断裂机理进行了探讨，并且讨论分析了现场和实验室模型试验的结果。
This paper analyzes the theory of Trench fracture controlled explosion and discusses its fracture mechanism. Also, the paper analyzes the results from in situ and laboratory tests.
在实验室条件下采用浇注的混凝土试件代替岩石进行爆破实验，然后应用提出的方法进行了分维数计算。
The casting concrete test piece is used to carry out blasting experiment under laboratory conditions, and then calculations are conducted using fore-mentioned approaches.
使用VCR采矿法进行采矿时，必须就地进行爆破漏斗实验，以确定利用球状药包落矿时的爆破参数。
By employing the VCR mining method, the experiment of blasting funnel must be carried out on the spot in order to ensure the parameters in mining by globular dynamite charge.
通过实验分析稻草爆破法制浆的爆破因子对爆破工艺过程的控制和影响。
The explosive technical process′s control and effect were studied by analyzing the explosive factor in rice straw explosion pulping.
文章结合一起由爆破振动破坏而引发的实际案例，进行了系列实验研究，对爆破振动破坏效应的鉴定方法进行一定的探讨和研究。
Identification method of blasting shake destroy effect is studied through series of experiments according to a practical case of blasting shake destroy.
本文从大块发生的主要因素出发，通过实验采用辅助孔爆破方法取得了良好的效果。
From the main cause lead to this problem this essay give a maybe solution to it through using supplementary hole in explosion.
在实验室进行模型试验的基础上进行了现场试验，并取得了较好的爆破效果。
Based on model test in the laboratory and site test, a blasting effect is achieved.
在理论上和利用实验室模型实验对深孔控制卸压爆破中的控制孔的作用进行了研究分析。
The effect of control holes of the blasting method was analyzed theoretically and the blasting mechanism of it was discussed and tested by lab and in field.
实验结果表明，油棕eFB采用爆破法制浆及抄造高强度瓦楞原纸是可行的。
The results indicated that the EFB explosion pulp can be used for high performance corrugating medium.
笔者简要地介绍了束状深孔爆破机理的基础实验、爆破参数的选取及爆破技术的实施，并对爆破效果进行了分析。
In this paper, basic tests on the mechanism of bunch-long-hole blasting are outlined, calculation and selection of blasting parameters, and its application t...
根据生产实验结果提出了东鞍山矿微差爆破适宜间隔时间的数值。
The modelling experiment has shown that the procedures are practicable, the reasonable values of the time interval for long hole m…
静压、爆破试压实验台、脉冲试压台等数套生产检测设备。
Static pressure, blasting testing experiment platform, pulse pressure sets several production and testing equipments.
在爆炸加载的动云纹法实验获得成功的基础上，本文研究了与爆破机理相关的几个基本问题。
Based on successful dynamic moire teste, the paper has studied some problems related to rock blasting mechanism.
在实验室进行了单孔抛掷爆破试验，观测了台阶爆破漏斗形成过程，分析了抛掷速度及分布规律。
The single-hole casting blast experiment was conducted in lab. The formation process of blasting crater was observed and the casting velocity and its distribution rule was analyzed.
它既保证了经过水压实验后的复合材料壳体有足够的承载能力，又能可靠地预报其爆破压强。
The predicted burst pressure value by the equation well agrees with the practical tested value, so it provides a new safe monitoring means of composite case h…
仿真和实验表明，本文的优化方法可行，所得试验和检测回路参数可确保爆破试验成功和传感器的良好动态特性。
The simplified simulation model composed both of the circuits of the rupture test and the Rogowski coil is centered on the SIMULINK environment of the MATLAB softwar…
仿真和实验表明，本文的优化方法可行，所得试验和检测回路参数可确保爆破试验成功和传感器的良好动态特性。
The simplified simulation model composed both of the circuits of the rupture test and the Rogowski coil is centered on the SIMULINK environment of the MATLAB softwar…
应用推荐