• 结果表明速度分布由于壁面粗糙度影响而偏离模型情况;

    It is shown that the tangential velocity distribution in actual combustor differs from that in model com- busior by its wall roughness.

    youdao

  • 研究高宽壁面粗糙度压力损失二次流动紊流强度影响

    The influences of the aspect ratio and wall roughness on the coolant flow characteristics, which mainly involve pressure loss, secondary flow and turbulence intensity, were investigated.

    youdao

  • 最后壁面粗糙度降低旋风分离器压力损失分离效率机理进行了分析

    Finally, the mechanisms of reduction in pressure loss and separation efficiency of the cyclone separator caused by the wall roughness are discussed.

    youdao

  • 试验分析认为,水流流态,壁面粗糙度壁面曲率边界层特性明显影响

    Analytical results show that the now pattern, wall roughness and wall curvature have obviously effect on the boundary layer hydraulic characteristics.

    youdao

  • 试验基础上研究瓦斯爆炸过程壁面粗糙度火焰传播速度超压影响

    On the basis of experiment, the influence of wall roughness on fire transmission and overpressure in gas explosion was investigated.

    youdao

  • 实验结果表明壁面粗糙度超过1%时摩擦系数随着壁面相对粗糙度增加而增加

    The friction factor obtained from the experiments increases with the surface roughness increase when the relative roughness is greater 1%.

    youdao

  • 试验基础上研究瓦斯爆炸过程壁面粗糙度火焰传播速度和超压的影响

    On the basis of the experimental research, the significant influence of the wall roughness on the flame transmission law of the gas explosion was analyzed.

    youdao

  • 研究结果表明:转子壁面粗糙度间隙环流偏心转子特性系数较大影响。

    The effects of stator and rotor wall roughness on the dynamic coefficients of the eccentric rotor in large gap annular flow have been investigated with numerical method.

    youdao

  • 模拟构造了不同壁面粗糙度,得到了面向导率随着壁面粗糙度增加减小结果

    The result shows that with the increase of interface roughness the in plane thermal conductivity decreases.

    youdao

  • 在模拟中构造了不同壁面粗糙度,得到了面向导率随着壁面粗糙度增加减小结果

    The result shows that with the increase of interface roughness the in plane thermal conductivity decreases. It is because that when the interf

    youdao

  • 壁面粗糙度对流场不同位置处颗粒运动影响强弱不同,其中逆流处较弱,下游处较强。

    The effect of roughness on particle motion in the recirculation zone is weaker than that in the fully developed flow region.

    youdao

  • 研究发现水泵出口断面轴向流速分布均匀度速度加权平均偏流壁面粗糙度改变而改变。

    It is also discovered that the axial velocity distribution and velocity-weighted average swirl Angle at the outlet section of axial-flow pump vary with the changing of wall roughness.

    youdao

  • 研究结果表明壁面粗糙度瓦斯爆炸过程影响很大,相比光滑管道,粗糙管的火焰速度大幅度提高

    The research result shows that the wall roughness has great effects on flame transmission in gas explosion.

    youdao

  • 脉动热管优化设计可以通过壁面粗糙度的加工、形成尺度的控制工质匹配选择等来实现。

    Some methods of optimization on pulsating heat pipe are by the designs of capillary wall microrelief, the scale design of existed vapor bubbles and the working fluid selection.

    youdao

  • 脉动热管优化设计可以通过壁面粗糙度加工、形成尺度控制工质的匹配选择等来实现。

    The shape of the existed vapor bubbles influences the startup and operation of pulsating heat pipe essentially, the new vapor bubbles are easier to produce near the smaller vapor bubbles.

    youdao

  • 相位多普勒颗粒测速仪PDPA测量了颗粒平均脉动速度研究壁面粗糙度水平台阶气粒两相流动影响

    The effect of wall roughness on gas-particle flows in a horizontal backward-facing step is studied using a phase-Doppler particle anemometer (PDPA) by measuring the mean and RMS particle velocities.

    youdao

  • 滞后转力矩计算方法中,本文主要介绍滞后引射率粗糙度壁面摩擦系数联合影响一种快速计算方法。

    In the calculations of roll torque of ablation lag, a rapid method for calculating combined influence of ablation injection and roughness on skin friction coefficient is mainly described.

    youdao

  • 对于不同粗糙程度壁面,在同一流量条件下糙率系数随着相对粗糙度增大而增大。

    The roughness coefficient increases when the relative roughness of the surface becomes larger under the same condition of discharge.

    youdao

  • 对于不同粗糙程度壁面,在同一流量条件下糙率系数随着相对粗糙度增大而增大。

    The roughness coefficient increases when the relative roughness of the surface becomes larger under the same condition of discharge.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定