固定化的目的在于使酶等生物活性物质在保持固有性能的情况下处于不易散失的状态，以便同基础电极组装在一起。
The aim of the immobilization is to preserve inherent biological activity of biomolecules and firmly combine them with base electrode.
研究人员指出，以此机制为基础的太阳能电池的效率将取决于电极材料的使用。
The efficiency of such a solar cell would depend on the materials used for the electrode, according to the researchers.
等离子体炬的核心部分是一对电极，通常用以镍为基础的合金制成。
The core of a plasma torch is a pair of electrodes, usually made from a nickel-based alloy.
在此基础上进行了电弧炉电极调节自适应控制系统的设计，推导出了递推的离散时间模型参考自适应律。
Based on this the design of arc furnace electrode regulator adaptive control system is made, the rule of discrete-time model reference adaptive control is proven.
在单孔电极模型基础上定义了电化学反应的有效三相分界线长度概念，并给出了对应的计算方法；
Based on the mathematical model of the single pore electrode, the effective three-phase boundary length of the electrochemical reaction is defined and calculated.
在一种特殊的钨酸空心管的基础上制备了一种结构简单且灵敏的亚硝酸根离子选择性电极。
A new type of simple and sensitive nitrite ion-selective electrode based on the special tungstic acid hollow tube has been prepared.
为神经假肢的研究提供了电极基础。
It provides the electrode basis for research of the neural limb prosthesis.
在此基础上，设计了用于12个电极点的卡肤电极或者10个电极点的剑状电极四通道神经信号激励模块。
Based on the module, a four channel module for the FES of neurons is designed for 12 sites cuff electrode or 10 sites shaft electrode.
讨论了两类氰离子电极的工作原理，列举了可能的干扰反应，并在此基础上探讨了硫、砷离子对工作电极的影响。
In the present paper the working principles of two cyanide ion electrodes and some possible reactions interfered with the behavior of the electrode listed and discussed.
提出了一种在恒流点焊控制器基础上加入电极热膨胀位移控制规则的方法。
This paper presents a method about electrode movement control rule inserted in current-constant spot-weld controller.
而微电极之前的图像信息处理过程需要一个视觉信息处理模型为基础。
Image information processing before the microelectrode arrays requires a suitable mathematical model for human visual information processing firstly.
良好的电极丝动态性能是高速走丝多次切割加工的基础。
A good dynamic stability is the basis of multiple cut on machine tool of WEDM with high wire travelling speed.
电极浆料是电子信息材料的重要组成部分，而电子信息材料是电子信息技术的基础与先导。
Due to the development of electronic components, the electrode paste as an important part of the electronic information materials made the new and higher requirements.
提出一种集成了检测电极的基于线性阵列电极的微流体芯片，及以此芯片为基础所构建的控制检测系统。
The paper put forward a micro fluidic chip based on arrayed -electrode integrated with detection electrode , and its control and detection system .
本文在前人工作的基础上，采用系统动力学及数值模拟方法研究了外控电化学约束下的电极b - Z振荡体系中的动力学行为。
This thesis investigates the dynamical behaviors of electrode B-Z reaction system under external electrochemical constraints by means of systematic-dynamical analysis.
在简介多电极电磁流量计结构和测量原理的基础上，给出了监控系统的总体结构框图。
On the basis of brief introduction on structure and measuring principle of multiple electrode electromagnetic flowmeter, the general schematic of the supervisory system is given.
在研究已有的静电喷涂装置基础上，采用栅网电极作为食品表面静电涂敷高压电极。
Based on research on available electrostatic spray painting equipment, grid electrode used as high voltage electrode for electrostatic coating on food surface.
在总结矿床地质特征的基础上，重点分析激电极化法在地质找矿中的应用。
Based on a study of the geological characteristics of Babaoshan copper deposit, this paper emphatically analyzed the application of induced polarization method in prospecting.
在此基础上提出了利用UHF信号估算油中尖-板电极局部放电脉冲电流波形的方法。
Based on which, a new method for estimating the PD pulse waveform by using its UHF signals is presented.
该技术方案以小型电火花机床的主轴头和电源控制柜为基础，重点研究了总体结构、电极与工件之间的三坐标移动、电极精确定位、工作液循环系统等关键技术。
The key technologies, the whole makeup, the motion between electrode and workpiece at three coordinates, precise orientation of electrode and cycle system of work liquid are emphatically studied.
电连接器，是在上述温控器的基础上增设接插电极。
The electronic linker is set plug based on the above thermostat.
在分析ert系统电极结构的基础上，对电极传感器提出了新的设计方法，包括电极的安装方法、多层电极的排列形式等。
Based on the analysis of the electrode structure in ERT system, a new scheme for electrode sensor is proposed, including electrode installation method, the array of multi-plane electrodes, etc.
超声电火花复合加工实质上就是在普通电火花放电加工的基础上，在工具电极或工件上叠加一个超声振动，以改善放电加工条件。
Virtually, ultrasonic vibration is added to tool electrode or workpiece electrode on the basis of EDM to improve the processing conditions in ultrasonic vibration assisted EDM process.
在标准CMOS工艺基础上，应用无电浸镀金改进传感电极的生物兼容性，并采用特殊封装技术提高芯片在溶液环境中的稳定性。
Post-CMOS processes including electroless gold plating and special package technique are implemented to enhance the biocompatibility and stability of the biosensor.
在用自然电位或微电极测井曲线标定泥岩段的基础上，利用声波测井数据预测地层孔隙压力，并以樊11-1井为例进行计算。
The method of predicting formation pressure using sonic logging data is presented. The self-potential and micro electric logs are used to calibrate the shale interval in F11 Well of Dongying sag.
在研制含铁离子阴极电极板的基础上，构建了单室直接微生物燃料电池。
A new type of single-chamber direct microbial fuel cell was constructed successfully on the basis of studying the cathode electrode containing Fe3 +.
在研制含铁离子阴极电极板的基础上，构建了单室直接微生物燃料电池。
A new type of single-chamber direct microbial fuel cell was constructed successfully on the basis of studying the cathode electrode containing Fe3 +.
应用推荐