在写数据时，主机总线适配器(HBA)根据块数据和逻辑块地址生成dif。
On a write, the DIF is generated by the host bus adapter (HBA), based on the block data and logical block address.
一旦你开始调整GTL ref电压(单独针对每个核心数据和地址总线)你将会发现不同的总线频率需要不同的电压组合。
Once you begin adjusting GTLREF voltages (for each core data and address bus) you will find that different bus frequencies respond differently to variations in the voltage.
为了在总线上传输仪器命令和数据，控制器给一个呼叫口和一个或几个响应口分配地址。
To transfer instrument commands and data on the bus, the Controller addresses one Talker and one or more Listeners.
总线是连接计算机各部件的一簇公共信号线，由地址总线、数据总线和控制总线组成。
The bus is the computer parts connected by a bunch of public signal, address bus, data bus and control bus composition.
总线由数据总线、地址总线和控制总线组成。
The bus by the data bus, the address bus and control bus composition.
一个存储器地址是由输出到适宜的总线上的二进制数据所组成。这个总线我们称为地址总线。
A memory address consists of binary data being output on an appropriate bus which we call the address bus.
对微控制器而言，PDIUSBD12看起来就像一个带8位数据总线和一个地址位（占用两个位置）的存储器件。
To a micro-controller, the PDIUSBD12 appears as a memory device 8-bit data bus and 1 address bit (occupying 2 locations).
地址总线为数据传输指明内存位置(地址)。
The address bus specifies the memory locations (addresses) for the data transfers.
每种微处理机都具有三组总线，分别供数据、地址和控制信号使用。
Each standard microprocessing unit creates three buses: one each for data, address, and control.
外设连接到中央处理器，通过数据，地址和控制总线和使用可处理所有的指示。
Peripherals are connected to the CPU through data, address, and control busses and can be handled using all instructions.
端口0也是复低位地址和在利用外部程序和数据存储器的数据总线。
Port 0 is also the multiplexed low-order address and data bus during access to external program and data memory.
为了便于获取指令，处理器把需要的由二元数据构成的地址存储在外部处理机总线的序列里面。
To carry out a fetch, the processor places the binary-code address of the desired location onto the address lines of the external processor bus.
由于采用的TMS320F 2808不具备数据总线与地址总线，两个DSP之间采用SPI串行通讯的方式实现数据交换。
Due to lack of data and address parallel bus on TMS320F2808, the two DSPexchange data by means of communication through SPI interface.
由于采用的TMS320F 2808不具备数据总线与地址总线，两个DSP之间采用SPI串行通讯的方式实现数据交换。
Due to lack of data and address parallel bus on TMS320F2808, the two DSPexchange data by means of communication through SPI interface.
应用推荐