浮选回路的在线模型是实现浮选回路计算机高级控制的基础。
The advanced computer control of flotation circuits is based on the implementation of on-line flotation model.
测量了这三组线圈中的放电电流，并将测量结果与回路计算结果作了比较。
The discharge currents for these three coils were measured and compared with the circuit calculations.
同时作出了模型参数计算的等效回路图，将复杂机械机构计算简化为电回路计算。
The equivalent circuit for model parameter calculation is also given, so a calculation for complicated mechanism could be simplified to a electrical circuit calculation.
对水系统建立整体模型，根据水系统的流体网络图形，得出一种流体回路计算方法。
The method of fluid circuit calculation was available according to the fluid network of water system.
考虑到大脑是人们所知的计算能力最强的，尽管控制行为的回路是多变的它又是如何表现的如此好的呢？
Given that the brain is the most powerful computing device known, how can it perform so well even though the behavior of its circuits is variable?
这种芯片将大大超过目前的计算机模拟速度，现有设备对细胞内大范围非线性回路的噪声影响建模时效率非常低下。
Such chips would be much faster than computer simulations now, which are highly inefficient at modeling the effects of noise in the large-scale nonlinear circuits within cells.
同时针对阻尼绕组提出了用多回路法计算阻尼条电流的方法，并提出一种数据传递方式实施对阻尼绕组的监测。
A multi circuit calculation method is suggested for calculation of the current of the damping winding bar and a method of data transfering is offered to monitor damping winding.
同时针对阻尼绕组提出了用多回路法计算阻尼条电流，并提出一种数据传递方式实施对阻尼绕组的监测。
Be directed to damp winding damp bar is calculated though multi circuit method, and a way to transfer data is offence to monitor damping winding.
即使对作时变运动的复杂多面体的线图，亦只需使用简单回路便可进行快速匹配计算。
Even though line drawings are extracted from a complex polyhedron with time-variant movement, only the simple circuit is used for arriving at a rapid matching computation.
用多回路法分析大型水轮发电机定子绕组内部故障时，将面临计算量大的困难。
Using the Multi loop Method to analyse the faults inside the stator windings of large hydro-generators will face difficulties of large amount of calculation.
根据图表示法和基本回路理论，建立角速度和力矩方程，给出了效率的计算方法，较传统方法直观、简便。
According to the theory of graph representation and fundamental circuits, Angle speed and torque equations are presented, and method of efficiency calculation is given.
系统采用软件方式实时计算交流传动系统的运行参数，包括变压器、四象限整流器、直流中间回路、逆变器、电机及负载。
Its software is designed to calculate the running parameters of the AC drive system, including transformer, quadrant rectifier, DC circuit, inverter, AC motor and train load.
文中给出实用计算法，以便根据冲击回路参数估算操作波的波头、波尾和电压效率。
A practical calculation method is given. With the parameters of the impulse circuit the wave front and tail and the voltage efficiency can be calculated.
本文提出了绕线式感应电机转子回路电阻的斩波调节原理，设计了双环调速系统，并进行了计算机辅助设计和仿真研究。
This paper presents a chopper adapting principle of rotor's resistance of induction motor, develops a two loops speed governing system, and gives computer simulation results.
本文论述了啤酒行业新型麦芽升降箱液压系统的设计、基本回路的选择和主要参数的计算。
This paper discussed the design of a new type of hydraulic system of malt lifting box, theselection of basic circuit and the calculation of the main parameters in the beer industry.
还得到了任意复杂多回路平面机构产生奇异位置的奇异性条件总数的计算公式。
In addition the computing formulae of the total number of singularity requirements for the arbitrary complex multilooped planar linkage to produce a singular position were obtained.
计算的准确度取决于指数波发生器的准确度，而后者和电阻、电容的准确度和回路的杂散电感有关。
The calculation accuracy depends on the accuracy of the exponential wave generator, which is associated with the accuracies of resistor and capacitor and the stray inductance in the generator circuit.
介绍了利用故障电压和故障电流计算故障回路电抗值的电抗法故障点定位的原理。
The theory of fault locating by calculating the reactance of feeder line with measured fault current and voltage is introduced.
这种器件具有制作工艺简单、阈值功率低和可室温运转等特点，是进行光计算回路可行性研究的理想元件。
The device is an ideal element for optical computing because of its favorable characteristics, such as simple fabrication technique, low critical power and easy room-temperature operation.
该结论不但适用于闭合回路中的感生电动势的计算，而且也适用于有限长导体上的感生电动势的计算。
The conclusion not only can be applied in the calculation of electromotive force of close loop, but also can be applied in the calculation of electromotive force of limited conductor.
分析与计算结果表明，因串联电抗器的电抗率不同，其流进电容器回路的谐波电流也截然不同。
Analysis and simulation results show that different harmonic currents flowing into the capacitor circuit is different due to different reactance ratio of series reactor.
并将结果与漂移模型计算结果进行比较，结果可为两相自然循环回路设计、运行提供参考。
Furthermore, the results based on different models are compared, which may provide some references for the practical design and operation of two phase natural circulation loop.
以回路电流法为基础，选定某一定子绕组为基准绕组，列写了用矩阵形式表示的、计算回路电流及支路电流的网络方程。
The network equations based on loop current method and expressed in matrix form are established, and the loop currents, then the brance currents, can be calculated by the equations.
算法主要由两步构成：在第一步计算中合上所有联络开关：然后计算全网的最优匹配回路流以决定每个回路中最适合打开的开关。
At the first step, all the tie breakers are closed to form a meshed network and then an optimal matching loop flow is calculated to determine the breakers most suitably to be opened in each loop.
在运用多回路法建立的同步电机数学模型中，计算了包括漏感在内的详尽的参数。
For the Multi loop model of the synchronous motor, this paper calculated all the parameters, including the leakage inductance.
从分析速调管输出回路的电磁场分量入手，结合微波电路理论，提出了计算速调管输出回路间隙阻抗的场分析法。
A new method (field analysis method) is presented to calculate gap-impedance in a klystron output circuit based on the analysis of the electromagnetic field components and microwave circuit theory.
方法：通过生产分析及计算机的控制回路。
Methods: By the analysis of production and the control circuit of computer.
分析工业锅炉自然循环的水动力计算特点，对简单及复杂循环回路的计算方法提出建议。
Analysis the character of hydrodynamic calculation for natural circulation of industrial boiler and give the recommendation of calculation method for simple and complex circulation circuit.
分析工业锅炉自然循环的水动力计算特点，对简单及复杂循环回路的计算方法提出建议。
Analysis the character of hydrodynamic calculation for natural circulation of industrial boiler and give the recommendation of calculation method for simple and complex circulation circuit.
应用推荐