蓝色是蓝天、碧水和晶冰的颜色。
探讨晶种粒度和晶种密度等因素对抗垢效果的影响。
The effects of some parameters on antifouling result have been concerned, such as seed crystal size and seed crystal density.
从1985年天朗遗弃在交叉印刷电路板的设计和晶圆开关。
From 1985 Tannoy abandoned printed circuit boards and wafer switches in the crossover designs.
随着温度升高，晶粒电阻和晶界电阻逐渐降低，导电性更强。
The grain resistance and the grain boundary resistance decrease with increase of temperature, so that the electrical conductivity is improved.
理论分析表明：硼对沉淀强化、固溶强化和晶界强化均有贡献。
Theoretical analyses have shown that boron benefits precipitation strengthening, solution strengthening and grain boundary strengthening.
运用X射线衍射技术和晶相显微技术对试样进行了分析和讨论。
And the samples were analyzed in X-ray diffraction technology, micro-photograph technology and SEM.
探讨了脉冲电流对大块非晶合金的结构驰豫和晶化转变行为的影响。
The influence of high-density pulsing current on the structural relaxation and crystallization behavior has been discussed.
结果表明，快淬后磁粉的显微结构与快淬速度和晶化温度密切相关。
The result indicated that the microstructure of the powder is clearly related to quenching velocity and crystallizing temperature.
结果表明：氢提高玻璃转变和晶化激活能，延迟晶核的形成及长大。
It is shown that hydrogen increases the activation energy of the glass transition and crystallization, and retards the nucleation and crystal growth.
出现再热脆性的主要原因是晶界粗大碳化物的析出和晶内二次硬化。
The authors suggest that the primary factors of the reheat embrittlement are precipitation of coarse carbide along the grain boundary and secondary hardening in the grain.
热压过程有助于促进反应的完全和晶型的完整，但会导致晶粒的长大。
Hot pressing can facilitate the integrality of reaction and the crystalline structure, but will induce the grain growth.
研究了位阻剂、超临界流体干燥处理工艺和晶化温度对粉末性能的影响。
The effect of surface active agent, supercritical drying temperature, pressure and holding time, calcination temperature and holding time on the properties of powders are studied.
裂纹沿未溶碳化物和晶界走向开裂，说明未溶碳化物降低了晶界处结合强度。
Finally, the slight crackle fissures along the direction of undissolved carbide and crystal boundary, and.
位错平面滑移，过早产生塞集和晶界上滑移灵便性差导致热轧后具有高的脆性。
The slip in the dislocation plane produces blocking at an early stage and the uneasiness of slip at grain boundaries leads to high brittleness of the material after hot rolling.
用裂纹密度和晶界裂纹的比例对晶界氧化的程度及裂纹扩展情况定性地加以分析。
The oxidation degree of grain boundaries and crack propagation are qualitatively analyzed based on crack density and percentage of intergranular crack.
在最佳超塑性条件下，断口中形成了大而深的空洞，晶界滑动和晶间断裂特征明显。
The deep and large cavities are formed on fracture surface and grain boundary sliding and intergranular fracture characteristic is obvious on the optimal superplastic deformation condition.
本文研究了热形变工艺参数对奥氏体晶界和晶内不同区域的形变程度不均匀性的影响。
This paper researches the influence of technology parameters of hot deformation on the nonhomogeneous deformation between the austenitic grains and different zones within the grains.
贝壳中的方解石和文石层均呈多级超微结构，微量的有机质在晶界和晶内呈不连续分布。
The calcite layer and aragonite layers are multi-scale structure , and a small quantity of organic matrix distributes mainly in their grain boundary.
考察了凝胶硅硼比、碱度、碱金属离子、添加晶种、老化时间和晶化时间对晶化产物的影响。
The effect of boron to silica molar ratio, basicity, alkali cations, seeds, aging and reaction time on the crystallization was investigated.
沿晶界疲劳开裂与否与驻留滑移带和晶界的交互作用方式密切相关，而与晶界结构本身无关。
It is suggested that intergranular fatigue cracking strongly depends on the interaction mode of PSBs with GBs, while the GB structure itself plays a much less role.
在曾经是深情和晶的贫民窟生活写照，它遵守个人赎回，甚至与伟大斗争，社会变革的可能性。
At once an affectionate and coruscating portrait of ghetto life, it abides the possibility of personal redemption and even, with great struggle, social change.
射线衍射和透射电子显微镜实验不但证实它的非晶性，而且给出它的平均颗粒度大小和晶化产物。
X-ray diffraction and transmission electron microscope experiments indicate the powder sample is amorphous and also show the average particle size and crystallization products.
在高温下，由于钡空位的增加、晶粒较细晶界较多和晶界的氧化作用等增加了材料的PTC效应。
The improvement of the PTC characteristics was induced by the more oxide of the grain boundary of the refiner particle size and an increase of the Barium vacancy.
晶圆处理系统是光刻机的重要组成子系统，其包含两个主要部分：晶圆传输系统和晶圆预对准系统。
The wafer processing system is an important subsystem of the lithography, which consists of a wafer transmission system and a wafer pre-alignment system.
本研究主要探讨反应温度和反应时间对铝型材厂工业污泥合成堇青石材料的得率和晶相结构的影响。
The influence of sintering time and sintering temperature on the crystalline structure of cordierite synthesized from waste aluminum sludge was studied in this paper.
纳米晶铜表面原子和晶界原子具有更高的表面活性，钝化能力大大提高，同时钝化膜的溶解速度加大。
Surface atoms and intergranular atoms of nc copper have high activity, and that the passivation ability and the dissolution rate of passive film are increased.
从致密化和晶化的角度分析了化学法制备莫来石先驱体粉料的优缺点，提出了化学法尚需解决的问题。
The features of the chemical methods are analyzed in terms of densification and mullitization of mullite ceramic, and some problems that should be addressed in future research are proposed.
从致密化和晶化的角度分析了化学法制备莫来石先驱体粉料的优缺点，提出了化学法尚需解决的问题。
The features of the chemical methods are analyzed in terms of densification and mullitization of mullite ceramic, and some problems that should be addressed in future research are proposed.
应用推荐