化学植筋技术是一种基于混凝土结构的新型后锚固技术。
Chemically planted bar in concrete structure is a new style post-embedding technique.
目的研究锚栓边距和间距的变化对混凝土结构后锚固群锚抗剪性能的影响。
An experimental study was carried out on shear bearing capacity of post-installed anchor group in concrete structure with different anchor edge distance and anchor space length.
后锚固技术是现代房屋装修、设备安装、旧房改造及工程结构加固等的专用技术。
The technique is a special technique used in the engineerings of house decoration, equipment installation, reconstruction and reinforcement etc.
介绍了后锚固群锚连接在拉剪复合受力情况下承载力计算的两种方法：弹性方法和塑性方法。
Two methods-elastic approach and plastic approach-for calculating the resistance capability of post-installed multiple-anchor connections under combinations of tension and shear loads are presented.
摘要：采用价值工程原理，比较预埋钢管法、预埋钢筋法、预埋铁板法、后锚固法的连墙件性价比。
Abstract:The paper compares the cost performance of four practice of wall fastener by value engineering principle, such as embedded pipe, embedded steel bar, embedded steel plate and after the anchor.
种植钢筋是一种先进的后锚固技术，已广泛应用于国内外的民用结构工程，在防护工程中植筋技术具有广阔的应用前景。
As an advanced post installed anchorage technology, insert rebar has already been applied to civil structural engineering all over the world, and has vast prospect for using in protected engineering.
稳压补张后回油至设计控制应力进行锚固。
Anchorage shall be carried out when the pressure stabilizing and tensioning make up is made.
在对工程地质等具体情况进行分析的基础上，提出了厂后高边坡加固处理工程措施，其中主要措施是应用预应力锚固技术并取得了良好的效。
Based on the investigation and analysis on the engineering geological conditions, this paper puts forward the high slope consolidation measures such as pre stressed anchorage technology.
超前支护锚杆锚固后与顶板岩石构成一体，这样使超前锚杆形成组合梁作用，放炮后，能够阻止顶板岩石冒落。
Forward support bolt combined with roop rock by bolting can play a roll of combined beam, which can prevent roof rock caving immediately after explosion.
对于竖向预应力传力锚固后损失的计算，收缩徐变模型的选取对其结果影响较大。
For the calculated prestress losses after jacking, the model of creep and shrinkage of concrete plays a significant role.
目前，工程上一般采用超声无损检测技术对锚固螺杆进行健康检测，主要是检测经过长期服役后在其内部产生的裂纹或缺陷。
At present, ultrasonic non-destructive testing is usually used in health detection of anchor screws, and it mainly used in detecting inner defect of anchor screws under long term service.
目前，工程上一般采用超声无损检测技术对锚固螺杆进行健康检测，主要是检测经过长期服役后在其内部产生的裂纹或缺陷。
At present, ultrasonic non-destructive testing is usually used in health detection of anchor screws, and it mainly used in detecting inner defect of anchor screws under long term service.
应用推荐