在调节完成后，紧固锁紧螺母，重新安装快速进水手柄帽。
After completing adjustments, tighten the lock nut and replace the fast fill lever cap.
承包商应于接头安装后一周重新拧紧螺母，并就在轨道最终衬砌和整平前再一次拧紧。
The contractor shall retighten the nuts one week after joint installation and a second time just before final lining and leveling of the track.
调整后，拧紧锁紧螺母。
调整后，就将锁紧螺母拧紧。
采用激光焊接的方法分别研究了Q 235钢和H62黄铜防护螺母激光焊接后的组织和性能。
The method of laser welding is used to study the organize and performance of Q235 steel and H62 brass protective nut connected by laser welding respectively.
防松螺母拧紧后，再对所有气门的间隙重新检查一次。
Recheck clearance on all valves again after locknut is tightened.
如果仪表指针出现了滞后现象等，将旋下仪表接头六方螺母，将缓冲器旋下清洗干净，装好后再进行使用。
If instrumentation pointer have lagged behind such phenomena, unscrew the meter connector six-party nut, buffer unscrew clean, pack good again after use.
在最后一环安装完后，将压盖随动件压至盘根环上，并用手指上紧压盖螺母。
After the last ring is installed, bring the follower down on the packing and finger-tighten the gland nuts.
“调模”使用油马达调模，没有过载保护功能，负载加大后，四根拉紧杆螺纹、调模螺母螺纹会损坏。
"Transfer mode" used motor oil transfer mode, there is no overload protection function, the load increased, the four tension rod threads, thread nut transfer mold damage.
卸下 通风窗4后，松掉锁紧螺母5上的锁紧螺钉。
将焊有球头的管子与外螺纹接头中心相对，旋转螺母使其自动对中心后，敲击螺母使螺母旋紧。
Make the pipes with button head align with the joints of external thread, rotate the nut and make it align to the center, knock the nut and screw up the nut.
将焊有球头的管子与外螺纹接头中心相对，旋转螺母使其自动对中心后，敲击螺母使螺母旋紧。
Make the pipes with button head align with the joints of external thread, rotate the nut and make it align to the center, knock the nut and screw up the nut.
应用推荐