镀层中只有少部分锌粉颗粒发生塑性变形，并且变形取向也无明显的规律。
Only a few zinc particles in the coating occurred plastic deformation with irregular orientation.
取向的结果，导致大量的硬段残留取向、应力软化、应力滞后和高变形，以及材料的高模量和高强度。
The orientations of polyurethanes resulted in a large number of the residual orientation , the stress softing and stress hysteresis , the permanent set , the higher modulus and strength of materials .
本文分析了注塑成型过程中简单收缩、冷却、分子取向等因素对注塑件变形的影响。
This paper discusses the three factors that affect the deformation of injection molded parts:simple nonuniform shrinkage, part cooling and molecular orientation.
目的：研究新生在体红细胞变形和取向的变化。
Objective:To study the deformation and orientation of RBCs under abnormal physiological conditions of phenylhydrazine injection in vivo.
利用背散射电子衍射取向成像技术定量分析了热模拟单向压缩条件下Q235碳素钢热变形时铁素体的织构形成规律。
The textural features during ferrite refinement by deformation enhanced transformation were analyzed by means of orientation mapping based on the EBSD technique in a Q235 low carbon steel.
结果表明：在低轧制变形程度时，完全限制(FC)模型计算结果的取向分布较其它模型更符合实际结果。
The results show that the orientation distribution calculated by the FC (full constraints) Taylor model is closer to experimental results than those by other models at the low rolling deformation DE.
铜单晶线材中位错蚀坑密度与材料浸蚀时间，变形量以及晶体学取向有关。
The dislocation etch pits density(EPD) of copper single wires is related with corroded time, deformative extent and crystal orientation of material.
利用背散射电子衍射取向成像技术定量分析了热模拟单向压缩条件下Q235碳素钢热变形时铁素体的织构形成规律。
The texture evolution of ferrite during warm compression of Q235 low carbon steel was determined quantitatively by means of orientation mapping based on the EBSD technique.
长丝价格结合预取向丝的价格将下调。我们的印度通讯员报导，由于下游织造需求强劲，变形纱价格却有所增加。
Filament prices were mixed with POY prices being reduced while textured yarn prices were raised, thanks to stronger demand from weavers, our India Correspondent reports.
在拉伸过程中，具有退火孪晶的晶粒内部首先发生变形，产生的变形孪晶遗传了退火孪晶的取向。
On the deformation process the annealing twins transform into deformation twins, which is TWIP effect, and so th.
在拉伸过程中，具有退火孪晶的晶粒内部首先发生变形，产生的变形孪晶遗传了退火孪晶的取向。
The results show that there are 60% annealing twins in TWIP steel before deformation and 32% deformed twins after deformation.
在拉伸过程中，具有退火孪晶的晶粒内部首先发生变形，产生的变形孪晶遗传了退火孪晶的取向。
The results show that there are 60% annealing twins in TWIP steel before deformation and 32% deformed twins after deformation.
应用推荐