另一种方法是建立发动机系统的模拟模型。
An alternate approach is to set up an analog model of the engine system.
时滞是给定发动机系统稳定性的控制因素。
The controlling factors in the stability of a given engine system are the time delays.
欢迎加入全球领先飞机发动机系统制造公司！
这是由于不同的压力和温度之间在汽车发动机系统。
This is due to the difference between the pressure and the temperature in the car engine system.
在气化炉，发动机系统，损失也发生在不同的阶段。
In gasifier-engine system, losses also occurs at different stages.
汽车的振动与噪声主要来源于发动机系统和传动系统。
The vibration and noise of the automobiles mostly comes from the engine and transmission system.
固体推进剂发动机系统的可调性基本上比液体或混合型的要差。
Solid propellant engine systems are basically less flexible in operation than liquid or hybrid propellant systems.
这些云团不仅阻挡了飞行员的视线，而且还损坏了发动机系统。
These clouds not only blocked out the pilots' sight but also damaged the engine system.
小型吸式气化炉干泥炭燃料，托盘已经成功地在天然气发动机系统。
Small downdraft gasifiers fueled with dry peat-pallets have been successfully tested in gas-engine system.
低频或中频燃烧不稳定性通常包含发动机系统中几个组件的相互作用。
Low or intermediate frequency combustion instability generally involves the interaction of several components of an engine system.
本文给出了一组能够描述各种组合发动机系统工作过程的通用方程组。
A set of general equations which can describe the operating process of all kinds of combination engine systems is given in this paper.
建立了一体化弹用小涡扇发动机系统含粘性力项的准三维欧拉流动模型。
A quasi three dimensional flow Euler model with viscous force terms was constructed for integrated small turbofan engine systems.
气化炉 发动机系统，发电机，能够提供足够照明电能，和其他家庭用途。
Gasifier-engine system combined with generator provides electrical energy for lighting, and other household purposes.
过热模糊逻辑模块，其产生表示发动机系统暖机之后的枢轴温度的过热修正量；
The over heat fuzzy logic module generates an over heat modifier representing the temperature of the pintle after warmup of the engine.
一种低温导热绝缘胶粘剂用于氢氧发动机系统表面温度传感器的端封和胶接安装。
The adhesive of low temperature heat conduction and insulation is utilized to the seal end and bend to install the surface temperature sensor of the hydrogen oxygen engine system.
通过分析典型故障取得了满意效果，说明该方法可以对发动机系统进行状态监测。
The typical fault was analyzed with the gray correlation degree analysis, and the satisfying results were gotten, which shows the method can be applied in condition monitoring of engine.
以全流量补燃循环氢氧发动机系统为研究对象，对其的动态响应特性进行了研究。
The full flow staged combustion cycle and its superior performance compared to the traditional cycle are discussed.
运用CAN总线，设计了商用车发动机系统、悬架系统、车身系统的信号采集电路。
The application of CAN-bus on the data acquisition of commercial vehicle is narrated and the data acquisition circuit of engine, suspension system and body system are designed.
讨论和分析了压力畸变在发动机系统中的传递情况以及发动机压缩部件临界级的分布情况。
The paper discusses and analyzes pressure distortion transfer in engine system and the distribution of critical stages of engine compression components.
这个模型能广泛地用于各种构型的发动机系统，而且已用于推进系统的稳态与非稳态分析。
The model can be generally applied to various configurations of engine system and has been used for steady and unsteady analysis of propulsion system.
对最近的成果我们感到十分高兴，下一步我们将要把这些最新技术整合到更高效发动机系统中。
We are delighted with the latest results which have taken us another step forward in demonstrating our excellence in integrating new technologies into a highly effective engine system.
结合汽车制动系统、传动系统和发动机系统及整车动力学四大模型，完成了下层子系统的设计。
Furthermore, the brake system model, drive system model, engine system model and dynamics equations of whole vehicle are combined to finish the design of the substrate system.
文章介绍了质子交换膜燃料电池发动机系统的设计，提出了将其集成为车用发动机系统的设计方案。
This article introduces the research and designs of the PEMFC engine system, and a project of the vehicle fuel cell engine system is presented.
分布参数控制体系的新原理、方法、实现手段将对高超声速发动机系统的运行和设计产生重要影响。
The new principles and methods of distributed parameter control may have an impact on the operation and design of hypersonic jets.
该方法按照预定的计算顺序，对发动机系统的各个部件进行迭代计算，采用拟牛顿法求解系统可调变量。
The components of the engine system are calculated iteratively in a predetermined sequence, and a modified Newton method is used to find the unknown variables of the system.
在热声发动机系统中，回热器的振荡换热是沿流体通道的轴向，而加热器振荡换热主要是沿流体通道径向。
In thermoacoustic system, the oscillating heat transfer in regenerator is along the axis direction of the stack and in heat exchanger it is along the radial direction of the tube.
分析了质子交换膜燃料电池的工作原理，提出了将其集成为车用发动机系统的设计方案，并且付诸了实践应用。
This paper introduced the principle of Proton Exchange Membrane Fuel Cell (PEMFC), and design the vehicle FC-engine system, at the same time, we have taken many practice.
为了满足这些排放法规，汽车制造商不得不优化相关的燃烧、后处理和燃料等技术，从而开发超低排放发动机系统。
To comply with these regulations, automakers are being forced to develop ultra low-emission engine systems by optimizing combinations of technologies related to combustion, aftertreatment and fuel.
根据液体火箭发动机系统设计确定的离心泵的性能参数，对泵叶轮的几何参数分别进行了单目标和多目标优化设计。
The structural candidates of centrifugal impeller were designed respectively from single-objective and multi-objective optimization based on the system design of liquid propellant rocket engine.
根据液体火箭发动机系统设计确定的离心泵的性能参数，对泵叶轮的几何参数分别进行了单目标和多目标优化设计。
The structural candidates of centrifugal impeller were designed respectively from single-objective and multi-objective optimization based on the system design of liquid propellant rocket engine.
应用推荐