压杆的失稳将导致结构的失效。
Buckling of struts would lead to invalidation of the structure.
从德国进口的压铅机压杆在使用中表面严重划伤。
The pressure bar of a lead briquetting machine, imported from German, was seriously scratched during its service.
介绍了一种新型带放大器的压杆式压电压力传感器。
A new type of piezoelectric pressure gauge with an amplifier is presented.
当手柄抬高到垂直位置，它就将可拆卸“压杆”压下。
When the lever is raised to the vertical position it pushes a removable "Push Rod" down.
单轴对称的角钢、T型钢压杆有必要做弯扭屈曲验算。
Struts of monosymmetric section built with angles and cut-Ts need to be checked on flexural-torsional buckling.
在模型中加入压杆稳定约束，使智能桁架结构更加稳定。
The constraint of press stability was added and the structure was more stable.
通过一个例子说明微分变换法在压杆稳定问题中的应用方法。
The application of the differential transformation method is demonstrated by an example for stability problems of columns.
介绍了用于减小压杆计算长度的侧向支撑的强度和刚度设计要求。
The stiffness and strength requirements for the lateral bracings reducing the calculation length of the compression struts are introduced.
压杆的稳定设计是通过计算压杆截面积选用截面形状来达到的。
The stable design of compressed rods is realized by calculating the cross aero and selecting the shape of rods.
计算发现，压杆模型或软化桁架模型所分配到的外荷载并不平衡。
The calculation results revealed that the loads carried by the compression strut or the softened truss model were not in equilibrium.
压杆机构采用油压自动平衡系统，压杆高低不需要调整，操作简单。
The strut mechanism adopts automatic hydraulic balancing system. The height of strut is not necessary to make adjustment with simple operation.
许多快餐店有压杆式苏打饮料，你可以用那些机器给自己倒一杯软饮料。
Many fast food restaurants have soda fountains, which are machines where you can pour yourself a soft (usually carbonated) drink.
国际上比较常用的方法是应用拉-压杆模型法进行结构构件的配筋设计。
The application of strut-and-tie model to the design of structural element distributed steel was made as that internationally.
限位开关多数情况下是机械式，并靠控制杆或压杆进行物理接触激发的。
Limit switches are most often mechanical and are activated by physical contact with either a lever or plunger.
我继续向左压杆，并且把油门从加力状态下收回以便不使飞机加速的太快。
I keep that left-hand turn going and bring the throttles out of full AB to make sure I'm not accelerating too much.
提出了基于压杆模型和软化桁架模型的钢筋混凝土梁柱节点抗震设计方法。
A seismic resistant design method of reinforced concrete beam-column connections based on compression strut and softened truss models was proposed.
本文介绍了摆锤冲击压杆测定岩石动态荷载—位移全过程曲线的实验技术。
The experimental techniques of measuring the rock complete loading displacement curve under the pendulum impact are introduced in this paper.
本文叙述了两种软化桁架模型，它们的区别是对混凝土压杆角度的假定不同。
This paper describes two types of softened-truss model, depending on the assumption for the Angle of concrete strutS.
在此状态下可在任意长度的压杆上，加任意大小的轴向载荷，而不产生弯曲。
With this situation, any amount of axial load can be applied to compressive bar of arbitrary length without bending.
索杆张力结构是指由张力索和压杆组成的、具有预应力自平衡的新颖结构体系。
The cable strut tensile structures are the self stress equilibrium systems composed by tensional cables and struts.
因而对支承于弹性系统上的细长压杆，需考虑支坐变位对临界屈曲载荷的影响。
Thus, for the slender struts supported on the elastically system, the influence of the bearing deflection on the critical buckling load must be considered.
本文用解析法和有限元法分析了连续多支承压杆的稳定性及其近似解与精确解。
This paper analyzes the stability of continuous and multi-support compressed pillars using analysing method and finite element method.
本文给出了计算钢压杆弹塑性稳定极限承载力的有限条塑性系数增量初应力法。
The paper presents a numerical method, named the Finite Strip Plasticity Coefficient Increment Initial Stress Method, to solve the elastoplastic stability ultimate loads of steel columns.
本文根据非线性有限元理论研究讨论基于压杆失稳的张拉整体结构极限承载能力。
According to nonlinear finite element analysis, the ultimate load-carrying capacity of tensegrity system is discussed based on the buckling of struts.
本文应用李亚普诺夫稳定性理论的直接方法，讨论了弹性支承上的压杆稳定问题。
In this paper, stability problem of beams supported on elastic foundation is discussed by means of Liapunov's direct method.
运用小变形弹性稳定理论，对几种压杆的计算模型进行分析，导出相应的稳定方程。
Based on the small linear elastic stability theory, the stability equation is established by analyzing the mechanical calculating model of a few kinds of columns.
压杆机构自动偏摆角度定位设计，使鞋子取放容易，长筒或半长筒操作上亦非常方便。
The automatic swing Angle positioning design of the strut mechanism makes it easy to remove shoes, especially in operation with boots or half boots.
提出一种解决几何非线性问题的优化算法，研究了悬臂压杆的几何非线性大变形问题。
An optimum algorithm is proposed to solve the geometrically nonlinear problem of large deformation of a cantilever under pressure on free end.
本文采用空间拉压杆原理将节点简化为由一系列钢筋拉杆及混凝土压杆组成的结构体系。
In this paper the spatial strut and tie model is used, and the connection is simplified as a structural system which is composed of a series of steel bars and concrete struts.
本文采用空间拉压杆原理将节点简化为由一系列钢筋拉杆及混凝土压杆组成的结构体系。
In this paper the spatial strut and tie model is used, and the connection is simplified as a structural system which is composed of a series of steel bars and concrete struts.
应用推荐