本文对RS- 485控制网络进行了改进，并提出RS - 485动态延时控制方式：对等式多机通信网络控制。
An improvement of RS-485 control network has been put forward and held up RS-485 coequal dynamic time control multiple computers communication in this paper.
采用排队论的方法对时隙动态分配方案中优先级别不同的用户请求的报文延时性能进行了分析对比。
Using the queue theory, the time delay performance of the scheme is analyzed and compared between two kinds of users' requirements with different Priority.
实验结果表明，通过延时模糊pid控制算法的实时精确控制，能够明显提高阻尼器控制系统的动态性能。
Experimental results show that it can significantly improve the dynamic performance of damper control system by real-time precision control of the delay and fuzzy PID control algorithm.
这里建立了6自由度轨转向架模型被用来研究的轨转向架动态系统的延时输出反馈控制。
A 6-dof rail-bogie model established here was used to investigate the time delay output feedback control of rail-bogie dynamic system.
在用偏振度作为反馈信号的动态偏振模色散补偿系统中，偏振度与差分群延时的关系对于准确快速的动态偏振模色散补偿很重要。
It is important to know how does the degree of polarization (DOP) change with differential group delay (DGD) when DOP is feedback information for adaptive PMD compensation.
通过分析几种典型的星际路由算法，考虑系统的动态因素，为系统设计了一种基于最小用户延时的动态星际路由算法。
By analyzing several typical interstellar routing algorithms, consider the dynamic factors of the LEO satellite mobile communication system, design a minimum user delay dynamic routing algorithm.
由于光网络具有大容量、低延时、动态控制以及任意粒度带宽等特性，把光网络与分布式计算系统结合，为数据密集型应用提供很好的应用环境。
On the other hand, optical networking can offer huge capacity and relatively low latency, as well as dynamic control and allocation of bandwidth at various granularities.
对被控对象模型中的不确定性进行了，针对设计中主要考虑的输入延时和高频未建模动态，建立了非结构化乘性不确定性模型。
The uncertainty of the controlled object modeling was analyzed. As for the time delay and high frequency no modeling considered in design, the uncertainty modeling of non structure was found.
针对开关动态对节点电压采样值的干扰，引入带通滤波，滤除高频动态的同时避免了常规低频滤波的延时。
Band pass filter is adopted to remove the high -frequency switching disturbance in node voltage measurements and avoid the time delay of common low pass filter.
车削过程自激振荡是一种以残留振痕作为机械延时反馈造成的动态失稳现象，消除这一现象是机械加工过程中的技术关键之一。
Self excited oscillation in turning process is a kind of unstable phenomenon resulting from former vibration trace. Eliminating of the phenomenon is a key technology in cutting process.
车削过程自激振荡是一种以残留振痕作为机械延时反馈造成的动态失稳现象，消除这一现象是机械加工过程中的技术关键之一。
Self excited oscillation in turning process is a kind of unstable phenomenon resulting from former vibration trace. Eliminating of the phenomenon is a key technology in cutting process.
应用推荐