加热炉用金属丝作为温度计。
整体热处理时加热炉技术参数应符合要求。
The technical parameters of heating oven for overall heat treatment should comply with the requirements.
一间储藏马铃薯的仓库里,加热炉突然失效。
The furnace used to heat a large storage room filled with potatoes suddenly failed.
实践证明,轧钢加热炉使用转炉煤气是可行的。
The practical production show that the converter gas can be used in reheating furnace of steel rolling.
新的加热炉在加热面包和糕点时不会使它们变硬。
The new ovens are a gentler way to heat bread and pastry without hardening them.
也可以设置烟气余热回收系统来提高加热炉的热效率。
Flue gas can also beset up waste heat recovery system to increase the thermal efficiency of furnace.
提出了一种基于生产目标的加热炉优化设定控制方法。
A kind of optimal setting control method based on production targets is provided.
本设计的要点是加热炉高的热效率,提高燃油的利用率。
The gist of the present furnace design with high thermal efficiency and fuel utilization.
必须先切断电源,放电后才能打开机柜,加热炉防护罩。
The power firstly must be cut off, and after discharging can equipment cabinet and heating furnace protective cover be open.
为了节约能源,提高加热炉的热效率是一项重要的措施。
To save energy raising heat efficiency of furnace is an important measure.
因此加热炉优化设定控制技术的推广对钢铁企业意义重大。
So it is important to extend optimal setting control technology for reheat furnaces of steel enterprises.
讨论了两流薄板坯连铸连轧作业时铸坯在加热炉内的运动情况。
The movement of slabs in reheating furnace from two-strand thin slab continuous caster operations is discussed.
上述研究结果可为加热炉钢坯加热制度的制定和优化提供依据。
The above result of study can offer foundation for the establishment and optimizing of billet heating system.
连续加热炉的操作水平直接影响产品的质量,产量和生产消耗指标。
Continuous operation of the furnace directly affect the level of product quality, yield and production consumption indicators.
为了适应这种要求,常常修建低温箱或加热炉来提供所需的温度范围。
To meet this requirement, low-temperature Chambers or furnaces are often built to provide the needed range of temperature.
针对轧钢加热炉现状,介绍一种新型加热炉-蓄热式加热炉的控制方法。
A method to control the store heat stove in accordance with the recent status of steel rolling is introduced.
目前,链式炉排已广泛地应用于中小型燃煤加热炉,并取得了可喜的成果。
At present, the chain grates have been extensively applied to medium-and small-size coal-fired reheating furnace, and good effects achieved.
介绍了采用炼铁副产品高炉煤气为加热炉燃料的应用情况,总结了经验和教训。
This paper introduces that the blast furnace gas is used heating furnace, and summarizes serval experience.
所用的加热炉的尺寸与型号要进行控制,使每项操作的温度能够在给定的范围内。
The furnace must be of the proper size and type and controlled, so the temperatures are kept within the prescribed limits for each operation.
本文提出了预测圆筒型加热炉燃烧室内质量、动量及能量传递的二维数学模型。
A two-dimensional mathematical model has been developed to predict the transport of mass, momentum and energy in a cylindrical combustion chamber.
火焰式加热炉有两种基本类型:水平管箱式加热炉和立管圆筒形加热炉(图)。
Fired heaters come in two basic styles: horizontal-tube box - type heaters and vertical -tube cylindrical heaters Fig.
本文论述了一个应用于加热炉计算机控制和优化操作的离散状态空间模型的开发。
The development of the discrete state space models for computer control and operation optimization of reheat furnaces is presented in this paper.
本文分析了电阻加热炉的数学模型,说明了常规控制器不能达到高控制精度的原因。
This paper analyzes the mathematical model of a resistance heating furnace, showing that a normal controller is unable to reach a high control accuracy.
英国航空公司已经为头等舱乘客安装了蒸汽加热炉,以取代通常使用的对流加热炉。
Steam ovens have been installed in first class to supplement the convection ovens airlines typically use.
分析了重整装置加热炉热效率低的原因,介绍了提高加热炉热效率采取的几项措施。
The reasons of low furnace heat efficiency for reforming unit are analyzed. Some measures adopted for raising furnace heat efficiency are recommended.
介绍了加热炉在使用转炉煤气作为燃料时,对其流量、压力、加热温度和纯洁度的要求。
The requirement to flow, pressure, heating temperature and purity of converter gas used in reheating furnace were introduced.
介绍了加热炉在使用转炉煤气作为燃料时,对其流量、压力、加热温度和纯洁度的要求。
The requirement to flow, pressure, heating temperature and purity of converter gas used in reheating furnace were introduced.
应用推荐