针对冶金企业提出三条建议：（1）加强焊接冶金问题的研究以大力发展易焊结构钢材；
Three suggestions are given for steelmaking works as follows: (1)Considerable attention must be put to the study of welding metallurgy for developing the weldable structural steels;
加强构件的非水密焊接接合和填角焊应该在检查完分段后进行喷漆。
Non-watertight weld joints and fillet welding for stiffening member shall be painted after block inspection.
为了加强二极管的焊接效果，提高产品质量。
To enhance the sealing effect and improve the quality of products.
采用可编程控制器在汽车后桥壳加强环、后盖自动焊接工艺中实现逻辑顺序控制。
Using the programmable controller in the automobile rear axle house ring stiffener, logic sequential control was realized in the top plate automatic welding craft.
本衬垫供单面自动焊接用F/G层的加强，也易用于弯曲部分。
This backing is used for one-side automatic welding to reinforce F/G layer. It is also easily used at bending parts.
着重分析了面对名种职业危害，制订的有效防护措施，指出焊接操作人员应加强自身安全防护，以避免身体的损害。
It analyzes in detail the effective protection against the career disbenifit, and points out that welders should strengthen their own protection to avoid physical damage.
因此改善焊接工艺，加强质量管理，是保证焊接转向架结构强度的关键。
So it is essential to reinforce quality control and improve welding procedure in order to ensure the structural strength of bogies.
机架采用槽钢作为主梁，中间加加强筋板焊接而成。
The rack USES the channel steel to take the main body, the middle with stiffener board welded together.
在左、右起垄板上焊接的加强筋增加了起垄板的强度，保证了起垄质量的稳定性。
The reinforcing ribs welded on the left and right ridge forming plates increase the strength of the ridge forming plates, and ensure the stability of the ridge forming quality.
吊勾焊接在立柱上或焊接在加强板上。
The reinforcement bars are soldered on the external sides of the columns.
吊勾焊接在立柱上或焊接在加强板上。
The reinforcement bars are soldered on the external sides of the columns.
应用推荐