• 在折射静校正处理中应针对不同地貌特征建立拾取原则初始速度模型确保折射静校正结果的准确可靠。

    The results have been used to guide the pickup of first breaks and to construct initial velocity model for refrac…

    youdao

  • 初始测量显示V6.2计算机上安装监视器模型队列跳过速度以前需要V6.1.2计算机上的相当。

    Initial measurements have shown that a monitor model installed to a single machine on V6.2 with queue bypass can run as fast as what previously required two machines on V6.1.2.

    youdao

  • 采用点点位位移速度对所建立函数模型进行验证,同时状态方程建立初始选取进行分析总结

    Finally, it validated established model with each point displacement velocity chart, analyzed and summarized the established of state equation and selection of initial value at the same time.

    youdao

  • 通过本文提出配置原则提高启发式方法初始方案质量,通过改进配置模型缩少了模拟退火方法寻优范围,从而提高求解速度

    Initial placement result from heuristic method is improved by the proposed placement principles, the search scope of SA method is reduced by new placement model, and the calculation speed is improved.

    youdao

  • 模型能够好地符合上升初始中间段的气泡上升速度

    The mathematical model for bubble rising velocity in the initial and middle regions is in good agreement with experimental data.

    youdao

  • 建立有限元模型,对平板叶片不同角度初始速度撞击矩形过程进行了数值模拟

    Numerical simulations of the course of the plate blade impacting target with the different angles and the initial velocity were performed based on the finite element model.

    youdao

  • 文中应用实例说明方法具有初始模型依赖性收敛速度反演结果稳定优点

    The application cases showed that the method has advantages of low dependence on initial model, rapid convergent speed and stable inverted results.

    youdao

  • 文章采用分析方法求出了具有初始血栓层的模型时间解,该时间外解近似相似性解给出的血栓的生长速度

    In this paper, we adopt the asymptotic analysis, get the time inner and outer solution of this model, and this time outer solution approximate the similarity solution.

    youdao

  • 对于上半空间无限大均匀血液在其底部血栓生长过程的数学模型,利用相似性解法求出的血栓的生长速度初始时刻无穷大,因而是无效的。

    About the model for one dimension thrombus growth on hemi-space, the thrombus growth velocity using the similarity method is infinite, so it is invalid.

    youdao

  • 运用简化模型初步分析了不同大气密度初始速度充气环境对降落伞充气时间充气距离,伞绳最大拉力影响

    The influence of atmosphere density and initial velocity on the parachute inflation times, inflation distance and Max strain of suspension-line were analyzed by the simplified model.

    youdao

  • 运用简化模型初步分析了不同大气密度初始速度充气环境对降落伞充气时间充气距离,伞绳最大拉力影响

    The influence of atmosphere density and initial velocity on the parachute inflation times, inflation distance and Max strain of suspension-line were analyzed by the simplified model.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定