因此应在初始故障阶段进行调整，避免进入连锁故障阶段。
So adjustments must be executed in initial phase to avoid entering into cascading phase.
最后，利用概率神经网络技术进一步从关联故障特征中辨识出初始故障源。
Finally, PNN method is used to identify the primary fault sources from the features of correlative faults.
满足了在发生故障时让系统保持其初始状态的要求，并按照要求初始消息不在WebSphereMQ队列中。
The requirement of having the systems in their original state in case of a failure is satisfied, and the original message is kept aside in a WebSphere MQ queue as per the requirements.
我们决定不要自动进行故障恢复到初始服务器。
We decided to not have automatic failing back to the original server.
初始化磁盘故障恢复以便磁盘现在从主站点镜像到目标站点，以防将来主站点有任何故障会发生，如清单20所示。
Initiate disk failback such that the disks are now being mirrored from the primary site to the target site, in case any future primary site failures occur, as shown in Listing 20.
理解如何生成和分析odrtarget . xml文件可能有助于在进行初始问题识别时节约宝贵的故障诊断和排除时间。
Understanding how to generate and analyze the ODR target.xml file can help you to save critical troubleshooting time when making this initial determination.
注意：该过程假设当出现故障时，将文件恢复到初始的LotusDomino服务器上。
NOTE: This procedure assumes that, in case of failure, you plan to restore the files to the originating Lotus Domino server.
订阅未初始化或没有为故障转移模式操作而创建。
The subscription is not initialized or not created for failover mode operations.
基于行波的输电线路双端测距算法只用到到达故障线路两侧母线的第一个故障初始行波波头，其可靠性较高。
Based on the traveling wave, double ended approach only deals with the first transient traveling wave reaching the two buses of the fault line.
对风电系统稳定运行状态进行潮流计算，作为风电系统复杂故障前的初始状态值。
Tidway calculation of wind - electricity system in stabilization condition, being taken as the beginning amount of complexity fault.
通过仿真研究，确定了遗忘因子和初始条件的最佳值，实现了对过程故障诊断和预报。
The optimum values of oblivious genes and initial conditions can be confirmed, and also the process fault diagnosis can be realized through the simulation experiments.
实时协同编辑中协作站点在不同时机加入时，由于网络延时或故障会导致其初始状态的不一致，即同步问题。
Due to the network prolonging or fault, inconsistency or synchronous problem of the initial state of cooperative sites occurs when they join a real-time cooperative editing system at different time.
针对小波变换在故障检测与测距中应用的实际问题如小波基函数、小波变换初始数据、行波波速的选取等进行了研究。
The practical problems in the fault detection and fault location using the wavelet transform, such as the wavelet basis function, the initial data, the velocity of traveling wave are studied.
资源在初始调度方案执行过程中可能会出现故障，而使初始方案不能继续执行，需要对初始方案进行调整。
The initial schedule may not be valid because some resource is broken down during the process of its (executing) and it need to be adjusted.
系统初始化后进入由键盘、显示、SCI、故障处理等模块组成的后台程序。
After initialization, the system ran into the background program which includes keyboard, display module, SCI module, and fault processing module.
该文提出利用线路故障产生的暂态行波实现配电架空线、电缆混合线路单相接地及相间短路故障测距，分析了故障初始行波模分量的暂态特征。
Using transient traveling waves generated by fault to locate single-phase earth fault or short circuit fault in distribution feeders mixed with overhead lines and cables is proposed.
探索综合利用故障初始电流、电压行波线模分量实现配电线路双端故障测距的新方法。
A new method of fault location for distribution feeders based on the aerial mode component of fault generating current and voltage traveling waves is discussed.
在故障时刻，无论故障相电压的相位处在何种初始状态下，都有零序电流反向的特征。
At the time of failure, no matter what kind of start state of voltage phase, the zero-sequence transient current has the characteristic of inverse phase.
故障初始症兆为一症兆集。
在一实施例中，数据处理系统中的一个固件组件在初始程序装入期间确定第一资源已出故障。
In one embodiment, a firmware component within the data processing system, during initial program load, determines that a first resource has failed.
介绍了单相接地故障行波选线原理，故障线路电流初始行波幅值最大，极性与非故障线路相反。
Its principle is presented: the amplitude of initial traveling wave on faulty feeder is higher than those on other feeders and its polarity is in inverse.
介绍了单相接地故障行波选线原理，故障线路电流初始行波幅值最大，极性与非故障线路相反。
Its principle is presented: the amplitude of initial traveling wave on faulty feeder is higher than those on other feeders and its polarity is in inverse.
应用推荐