图1显示了三个模型分层的云计算。
Figure 1 shows layered cloud computing with the three models.
模型2采用这些危险因素另加冠状动脉钙评分。用模型2比较模型1我们计算分级改善和比较危险分层。
Model 2 used these risk factors plus CACS. We calculated the net reclassification improvement and compared the distribution of risk using model 2 vs model 1.
通过改造绕组调制函数所建立的数学模型分析计算绕组的分层系数、正交误差和电气误差。
Through reform the modulating function of the winding to set up the mathematic model, by which it analyses and calculate the layer coefficient, quadrature error, electrical error.
基于分层降维离散变量优化方法，对建立的数学模型进行了优化计算。
Based on gradation decreasing dimension method, the mathematical model is applied in scheme design of the gearbox.
在混合损失计算模型的基础上，应用动量守恒原理推导出了新的水平井筒气液两相分层流型压降计算模型。
Based on the model to calculate mixture loss, a new calculation model of pressure drop for stratified flow in horizontal wellbore has been developed by applying the momentum conservation equation.
分层诊断是减少基于模型诊断计算复杂性的重要方法。
Hierarchical diagnosis is an important method for reducing the complexity of model-Based diagnosis.
反分析计算时采用分层均质模型，将计算区域内各层岩层分别视为均质各向同性体，初始地应力假设成线性分布。
It assumed that the initial rock stresses is in linear distribution, all layers of strata are regarded as layered homogeneous in calculation districts, and this model is applied to doing calculation.
基于分层降维离散变量优化方法，对建立的数学模型进行了计算。
Based on gradation decreasing dimension discrete variable optimum method, for established the mathematical model calculated.
针对多模型控制方法中模型数目巨大，计算时间长等问题，提出了分层递阶结构多模型自适应前馈解耦控制器。
To solve such problem as too many models and long computing time, a hierarchical multiple model adaptive decoupling controller is designed.
建立了在密度分层环境中热尾流特性的计算模型。
The calculation model of thermal wake characteristics of submarine in stratified flow is established in this paper.
工艺控制论的模式：解析数学模型，分层递阶智能控制结构，计算机仿真实验和模型参数自适应。
The models of technological control theory included: analytical mathematical model, multilevel intelligent control, and simulation experiment on computer and self-adaptation for model parameter.
模型试验实测沉降量与用分层总和法、数值分析法计算结果接近。
The settlement data of model tests are in general agreement with the calculated values on models of numerical analysis.
根据连续分层介质中声波传播理论建立了计算水溶性高分子溶解过程中声衰减的数学模型。计算结果与实验结果一致。
Depending on the experimental result and the theory of sound wave propagation in layered medium, a mechanism of gradient water-soluble polymer solution was developed.
计算方法采用连杆法，地基模型采用规范规定的分层总和法模型。
The hingcd-member method is used in calculation and the model of stratified summation method specified in the Code is adopted as the foundation soil.
为了提高计算复杂多发箔条云团的雷达散射截面的精度和效率，提出了一种基于分层结构的复杂多发箔条云团散射模型。
In order to improve the efficiency and precision of the radar cross section computation, a scattering model of the layered complex multi chaff clouds is presented in this paper.
文中提出由递推法分层土模型计算分抗力分项系数，物理概念明确计算方法合理，结果可信。
The partial coefficients of resistance obtained by recurrence analysis method have clear physical concepts. The calculation method is reasonable and the obtained results are credible.
模型试验实测沉降量与用分层总和法、数值分析法计算结果接近。
The values of the settlement are approximation with calculated value of summating for each layer and calculated values on prototype of numerical analysis. Therefore, this method is very feasible.
为优化装配系统中公差链的公差值，建立了几何尺寸公差的优化模型，并提出公差的分层优化设计算法：第一层，解决设计公称值居中的优化问题；
In order to optimize tolerance values for an assembly system, a model for geometric dimension tolerance optimization was established and an algorithm for optimal tolerance design was proposed.
通过功能符号形式化描述建立分层次的机构概念运动模型，实现对计算机辅助概念运动设计的支持。
By setting up a hierarchical mechanism motion model for conceptual design through the formal description of function symbol we provide a solid support to the computer aided conceptual motion design.
讨论了几个典型的羽流流量计算公式，结合一种二区自然通风模型，建立了热分层高度、通风量和中和界高度的计算式。
Discusses several representative equations of point source plume. Establishes calculating equations of thermal stratification height, ventilation rate and neutral level based on a two-zone model.
最后，根据可分层术语集合的特性，证明了循环不动点理论在本体知识库下可用于计算可分层术语集合的语义模型。
Finally, this thesis proves that the recursion fixed point theory can also be used for the semantic model computation of a stratified TBox in ontology knowledge base.
通过所建立的模型进行了分层、分段储量计算，其结果与原结果基本一致，并且实现了油藏精细描述—油藏精细数字模拟一体化。
Reserves of separate layer and section are computed through the established model, and the calculated reserves are almost the same as the original reserves. The integration of reservoir deta...
通过所建立的模型进行了分层、分段储量计算，其结果与原结果基本一致，并且实现了油藏精细描述—油藏精细数字模拟一体化。
Reserves of separate layer and section are computed through the established model, and the calculated reserves are almost the same as the original reserves. The integration of reservoir deta...
应用推荐