轴承座内的油位标记和油位表使油位保持在正确水平。
Oil level marks in the housing and an oil level gauge help to keep the correct oil level.
总结了利用该方法加工转炉轴承座内球面的步骤及其误差控制。
The step and error control in machining the converter bearing seat with this method are summed up.
对安装在轴承座内的数据采集模块在硬件和软件上进行了低功耗设计，使其能长期安全地运行。
The data acquisition module installed in the bearing block is designed in a low-power way both in the hardware and software.
对轴承座内孔进行堆焊 ，将大表面分割 成小表面 ，减少了喷涂层收缩时形 成的裂纹 ，提高了喷涂层与基体的结合强度。
Bead inside bore of bearing, the large surface is divided into several small ones, the number of flaws are decreased and the bond strength of spraying layer and substrate is strengthened.
另外，由转频附近细化谱分析及时域波形比较，发现输入轴非电机端轴承座内机件还有径向配合松动故障。
Besides, at the non-drive-end of the primary shaft, some mechanical fitting in the bearing case were detected loosen, through spectrum-zoom analysis and waveform comparison in the time-domain.
利用非线性接触有限元方法对向心关节轴承进行应力场分析，在有限元模型中将心轴和轴承座作为柔性体处理，分别考察内、外圈相对偏斜工况下的应力场分布。
In the finite element model, the shaft and bearing house are set as flexible body, the stress field is investigate in the tilting case of inner ring and outer ring.
利用非线性接触有限元方法对向心关节轴承进行应力场分析，在有限元模型中将心轴和轴承座作为柔性体处理，分别考察内、外圈相对偏斜工况下的应力场分布。
In the finite element model, the shaft and bearing house are set as flexible body, the stress field is investigate in the tilting case of inner ring and outer ring.
应用推荐