如果需要，输入configureports 1 -4preferred - mediumcopper——在端口1 - 4上将默认的首选介质光纤改为铜缆。
Enter configure ports 1-4 preferred-medium copper — Changes default preferred medium from fiber to copper on ports 1-4, if required.
另外在该算法的基础上，对光纤光栅耦合器的开关特性及不同输入功率下的输小响应进行了分析。
Then, we analyzed the switching character of the fiber Bragg gating couplers and the output response under different input powers by this new algorithm.
在单模光纤中，输入的激光功率大于阈值时，出现放大的反斯托克斯·拉曼背向自发散射现象。
Amplified anti-Stokes Raman spontaneous backscattering phenomena has been observed in single mode fiber, during input laser power is large than threshold power.
在装置中间，其中一根光纤用于传输入射激光，周围多根光纤与中心光纤等间隔，用于接收血液中的散射光。
The central one of the fiber probe is used for transmitting laser beam, the others having same spaces to the center one are used for receiving scattered signal.
其次，采用数值计算的方式，分析了输入方波信号与光纤束位相匹配对对比度调制传递函数的影响。
The next, the influence of phase match between input signal and line-array fiber-optic image bundles on the contrast transfer function was analysed digitally.
鉴于光纤陀螺角速率信号可以直接获取，提出了一种以角速率信号作为圆锥补偿算法输入的新补偿算法。
Considering the direct angular velocity signal output from fibre optic gyroscope, a novel coning compensation algorithm was introduced and it need input angular velocity signal.
偏振控制器PC是高速光纤通信系统研究中一个非常重要的器件，它可以将任意的输入光偏振态变换为任意形式的输出光偏振态。
PC, a key element in high rate optical fiber communication system, changes any input light polarization state into any desired output light polarization state.
介绍一种紧凑的、能以较低输入光功率工作的光学双稳器件，由光电检测器、光纤定向耦合器和半导体激光二极管组合而成的。
A compact, low input power optical bistable device, combined with photodetector and optical fiber directional coupler and semiconductor laser diode, was presented.
基于耦合非线性薛定谔方程，通过数值模拟，研究了光子晶体光纤中孤子脉冲的输入功率对脉冲传输的影响。
Based on the nonlinear Schr? Dinger coupling equation, the impact of input power of soliton in the Photonic crystal fibers on the pulse evolution is studied by numerical simulation.
偏振方向沿光纤特征方向的线偏振光输入，将得到偏振方向不同的线偏振光输出。
The output light is also linearly polarized if the polarization direction of linearly polarized input light is coincident with the characteristic direction, while bo.
增大初始啁啾和输入功率可以得到更大的压缩因子，同时最佳光纤长度减小，它们之间基本成线性关系。
It was found that the compression factor and the compression quality factor increased with initial chirp and power, but optimum fiber length decreased.
数字光纤接收机的灵敏度计算与其输入光脉冲波形直接相关。
The sensitivity of a digital optical fiber receiver is directly relevant to the optical pulse shape at the input of the receiver, and varies with the optical pulse.
设计的信号模拟电路精确模拟了光纤陀螺输出信号的波形，给计数卡提供了准确的输入测试信号。
The designed signal simulation circuit can precisely simulate the output signal waveform of fiber-optic gyro, offer accurate input signal to counter card.
从理论上详细分析了光纤环形腔有内相位调制时的输出光电流功率谱密度函数，该理论对任意相干长度的输入激光光源都是有效的。
The power density spectrum of an inner-phase-modulated optical fiber resonator is analyzed theoretically and experimentally, which is valid for any source coherence time.
一种光纤激光腔，其包括激光增益介质，用于接收来自激光泵的光输入投射。
A fiber laser cavity that includes a laser gain medium for receiving an optical input projection from a laser pump.
当输入为单波长信号光时，可以通过测量探测器输出的电信号来获得光纤光栅所承受的温度和应变信息。
The amount of the temperature or strain imposed on this device was obtained by measuring the electric signals changing with the shift of resonant wavelength.
讨论了掺镱双包层光纤放大器输出脉冲能量随不同输入脉冲峰值功率和泵浦功率的关系。
The relations between the output pulse energy of the amplifier and the different input pulse peak power or pump power are also discussed.
结果表明，增大初始啁啾和输入功率可以得到更大的压缩因子，同时最佳光纤长度减小，它们之间基本成线性关系。
It is founded that the compression factor and the compression quality factor increase with initial chirp and power, but optimum fiber length decreases.
提出了臂内含有光纤光栅的方向耦合器的一般模型，推导了任意端口输入时任何一端口的输出表达式。
A general model for fiber directional coupler with fiber Bragg gratings in its arms is presented. The output expression of any arm is obtained when input is from an arm.
在输入宽带光源时，得到两光纤布拉格光栅在不同中心波长之差时的掺铒光纤放大器的增益特性。
When the broad band light source is input, the VEDFA gain characteristics in the two fiber gratings different wavelength difference are obtained.
光纤陀螺与温度相关误差项主要为零漂和标度因数，输入轴失准角也是影响光纤陀螺应用的一个重要误差项。
The errors of FOG involved with temperature are zero bias and scale factor. Input axis misalignment is another important error with temperature.
其91600系列多频道系统在双渠道的双向多协议数据多模光纤之上提供16路10位数字视频录像机的输入和输出。
The 91600 Series Fiber Multi-Channel System provides 16-channel input and output of 10-bit digitized video over one multimode fiber.
该录音机的特点是：XLR平衡和RCA不平衡模拟输入输出，以及同轴和光纤数字输入输出。
The recorder features XLR balanced and RCA unbalanced analog inputs and outputs, as well as coaxial and optical digital ins and outs.
通过控制拉锥后的末端光纤尺寸，实现了多模光束输入转换成单模光束输出。
By controlling the taper end size of the fiber, the unique tapered fiber can convert a multi-mode beam into a single-mode one.
通过控制拉锥后的末端光纤尺寸，实现了多模光束输入转换成单模光束输出。
By controlling the taper end size of the fiber, the unique tapered fiber can convert a multi-mode beam into a single-mode one.
应用推荐