这个指令允许你设定不同的元件参数。
提出了用于功率因数校正时主要储能元件参数的计算方法。
The calculating method to identify the system parameters is recommended.
并讨论了当元件参数满足某些特定条件时，模型的化简问题。
When the parameters of components and system meet a certain condition, the models of load sensing system are simplified.
本文介绍用最优化方法设计有源滤波器各元件参数的通用程序。
This paper introduces a universal program to design parameters of the elements of active filters by using optimization method.
对噪声电压的影响也作了一些讨论，得出了测定元件参数的参考方法。
The effect of noise voltage is also discussed. A reference method of determining component parameter is given.
它指出了减少非线性误差的方向，并为部分元件参数的设计提供了依据。
This paper points out the direction of reducing nonlinear error and offers the basis for design of partial components parameters.
首先，建立优化双工器的目标函数，推导出目标函数对元件参数的梯度。
First, we formulate the objective function for the use of diplexer optimization, and calculate the gradient of the objective function with respect to the element parameters.
本文介绍了8k型电力机车辅助变流器的特点、主电路元件参数及控制。
It is introduced here the characteristics, the parameters of the power circuit devices and the control method of the auxiliary converter of 8k electric locomotive.
通过数学建模，找出换流尖峰电压与换流缓冲器保护元件参数之间的关系。
The relation between switching current overvoltage and parameters of snubber components is founded according to mathematics modeling.
以液压元件参数化设计为例，介绍了基于命令解释器模型的程序设计方法。
Take the parameterized design of hydraulic component as an example the program designing method based on command explainer model was introduced.
适当设置输入分布和输出求和CC网络元件参数，能实现任意高阶传输函数。
By setting any particular input distributing and output summing passive element parameters, the arbitrary high-order transfer functions can be realized.
采用频率特性分析方法研究了元件参数对分流阀的响应速度和分流精度影响。
The influence of the parameters of the valve on responding speed and flow - dividing accuracy is researched by frequency characteristic analysis method.
本文给出了选择探测器关键参数的准则及选择、计算各元件参数的可靠判据。
This paper gives the strict principles for selecting key component parameters and the reliable criterion for selecting and calculating the component parameters.
设计了适合超宽带通信的混频电路，并对电路进行优化确定电路的元件参数。
Designed the CMOS mixer circuit for UWB communication system, and the device parameters.
用拉普拉斯变换用MATLAB求解二阶电路微分方程验证了得到的各元件参数。
Secondly, solving differential equation in LAPLACE transformation with MATLAB validates the acquired parameters.
接着把有理多项式的参数转化成RLC集总元件参数，得到天线的等效电路模型；
Thirdly, deduce the parameters of the rational approximation to RLC lumped-element, then obtain the equivalent circuit model.
分析了模拟电压一频率比变换电路原理，给出了元件参数的设计要求及其计算方法。
After the analyses of circuit theory of analogue voltage-to-frequency ratio converter, the design requirement of component parameters and the calculation method are presented.
三是对装载机作业的不同工况进行动力学研究，对液压系统各元件参数选择及匹配。
Third , carry on dynamics research to different operating modes of the loader work , carry on the parameter to choose and match to every component of hydraulic system.
根据供电电网电压及中间直流回路电压给定，对主电路的元件参数进行了选择和优化。
According to source voltage and middle DC voltage command, the parameters of the rectifier are chosen and optimized.
该判据是在考虑恒功率负载负阻抗大小的基础上，给出了滤波器元件参数的约束条件。
The presented criteria utilize the dynamic negative incremental impedance of the CPL to place design constraints on the filter parameters and thus prevent instabilities.
在网络分析中，当元件参数发生变化时，我们用绝对灵敏度来研究它们对网络响应的影响。
In network analysis, to consider the effect on circuit response of variation in component parameters, the absolute sensitivity is applied.
本文还深入分析了该电路的工作原理及和控制策略，并且对谐振元件参数进行了优化设计。
The operation principle and control strategy are analyzed in detail, and an optimizing program of designing resonant parameters is provided.
对于有源非线性电阻电路，当非线性电阻不存在故障时，各元件参数、特性同样可唯一地确定。
Similarly, for the nonlinear active resistive circuit, when no fault occurs in nonlinear resistances, they can also be uniquely determined.
该方法不受电路规模和复杂程度的限制，可确定电路中哪些元件故障，辨识出故障元件参数值。
The method is not restrained by the number of elements and complexity of circuits. It can locate out the fault components in a circuit and can identify the parameters of the fault components.
本文仿真分析了CVT的谐波丈量畸变原理，并对其稳态电路进行了主要元件参数的灵敏度分析。
Simulation of the CVT's harmonic measurement distortion, and analyze the sensitivity of the main components parameters use of the steady-state circuit were conducted in the thesis.
从快速性和稳态误差二个方面，分析了元件参数（特别是阀芯定位弹簧刚度）对分流精度的影响。
The influence of the parameters of the valve(in particular the spring rigidity of the valve rod) on flow-dividing accuracy is analysed in the rate of self-regulation and the steady-state error.
根据系统的特点，通过静态设计，选取元件参数，然后通过动态建模分析以及几种控制策略的仿真研究。
According to the feature of this system, through static design and selecting component's parameter, then carrying out dynamic model's establishment and simulation of several kinds control strategies.
对于含有线性受控源、或独立电源的电路，当电路结构和元件参数满足一定条件时，也同样具有互易性。
For the circuit including linear controlled source or independent source, it also has reciprocity when the circuit constitution and element parameter satisfy some conditions.
对于含有线性受控源、或独立电源的电路，当电路结构和元件参数满足一定条件时，也同样具有互易性。
For the circuit including linear controlled source or independent source, it also has reciprocity when the circuit constitution and element parameter satisfy some conditions.
应用推荐