仿真结果显示，该方法压缩比大，信息损失小，能够较好恢复原有图像。
Simulation proves this an efficient compression method owing to a larger compression ratio, a less loss of information, and better performance of recovering the original image.
仿真结果显示，自然梯度算法比传统梯度算法收敛速度更快，分离效果更好。
Simulation results show that the natural gradient approach has faster convergence speed and better separation performance than the conventional gradient based algorithm.
仿真结果显示，该方法压缩比大，信息损失小，能够较好的恢复原有的信号。
The result of simulation shows that this is an efficient compression method characterized by larger compression ratio and less loss, and the original signal can be recovered well.
仿真结果显示，复合余弦基神经网络图像去噪滤波器各项特性接近理想滤波器。
The simulation results reached nearly ideal filter characteristics, and the performance of removing image noise using this filter was compared with the median filter.
仿真结果显示该路由协议在平均分组递交率和路由协议开销等方面要优于传统路由协议。
The simulation results indicate that the performances of the protocol in packet delivery ratio and routing overhead are better than the conventional routing protocol.
仿真结果显示，采用神经网络半主动控制能取得很好的减振效果，证明该方法是可行的。
Simulation results show that the excellent effect of mitigating cable vibration can be acquired with the neural network approach of semi-active control and that the approach is feasible.
仿真结果显示，运放开环与闭环时的频率响应、输出饱和、转换速率等特性得到了真实的反映。
The simulation results show the open-loop and closed-loop frequency responses, output saturation, and the slew-rate of operational amplifier are truly reflected by this model.
仿真结果显示：虚拟阵元法应用于面阵，在输入信噪比较低的情况下仍可以准确判断来波方向。
Computer simulations show that, even under low input signal-to-noise-ratio, the accurate estimation of DOA could be given when the virtual array method is applied to the planar array.
仿真结果显示，采用该模型的场景温度计算值和实测结果相符，并能够满足仿真对实时性的要求。
The simulation results show that the temperature values predicted by the scene using this model accords with the measured temperatures, and also fulfils the real-time requirement.
在悬臂上进行最优控制的数值仿真结果显示该最优控制方法能充分利用控制作动器迅速抑制结构振动。
The optimal control law was simulated for a cantilever beam with the results showing that with the cable actuator, the structural vibrations were rapidly attenuated.
仿真结果显示，该方法在迭代次数很小时性能便可接近带有循环前缀的STBC - OFDM系统。
Simulation results show that the performance of this method approaches that of the STBC-OFDM with cyclic prefix even if the number of iteration is very small.
实验仿真结果显示，本文的算法在有效的控制输出码率稳定的同时，有效的提高的立体视频的立体感。
The experiment results demonstrate that the proposed scheme can improve perspective of the stereo video as well as control the stability of output rate effectively.
仿真结果显示，此法能够良好地抑制动态伪轮廓，并且有助于克服单纯延伸编码显示灰度级不足的缺点。
Simulation results show that this method can greatly reduce dynamic false contour and overcome the shortcoming of insufficient gray levels in pure stretched-out coding display.
仿真结果显示，在正常负载率区间下，新的调度策略有效的降低了任务拒绝率，而运行开销在可接受范围内。
Simulation result shows that under normal system load range, the proposed strategy reduces the task rejection rate effectively while keeping runtime overhead manageable.
仿真结果显示了不同高阶基函数CMAC网络的不同建模能力，证明了中间层作用函数地址的计算方法正确。
The simulation result shows different model capabilities of these Higher-order Basis Functions and the address calculation method of active basis functions in hidden layer is correct.
仿真结果显示，新调度机制可以将网络中的因特网语音服务的连接数和总吞吐量分别提高15%和11%左右。
The simulation results show the proposed scheduling mechanism could significantly increase number of VoIP connections and total throughput, about 15% and 11% respectively.
该算法基于恒模算法(CMA)，计算机仿真结果显示该算法收敛快速，性能稳定，能准确地完成多用户的分离。
This algorithm is based on constant module algorithm (CMA). The computer simulation results indicate that this algorithm have several advantages such as fast convergence, robustness and so on.
依据离散马尔可夫电池模型理论，模拟出跟踪电池基本行为的离散过程，仿真结果显示模拟过程与理论推导相吻合。
Based on the theory of the discrete-Markov battery model, the fundamental behavior of the battery is simulated. The result shows that the simulated process is consistent with the deduction.
最后，结合算法进行仿真实验，仿真结果显示机器人的轨迹可以遍历环境中的非障碍物区域，验证了算法的有效性。
Finally, the simulation result shows that the trace of the two robots can spread all over the area that isn't occupied by the obstacle, proves the method is effective.
仿真结果显示密文分布更合理，编码时间更短并且编码时间与文本文件的大小呈线性关系，增强了该算法的实用价值。
Simulation results show that the distribution of the ciphertext is flatter and the encryption time is shorter, the encryption time increases linearly with the file size, which made it more practical.
仿真结果显示了QMRA在状态信息不精确的情况下，具有较低的路由阻塞率和数据包的平均延迟，并且能够快速收敛。
Simulated results show QMRA achieves not only a low routing blocking ratio and a low average packet delay, but also a fast convergence, while the network state information is imprecise.
仿真结果显示了船艏结构损坏、碰撞力演变、能量传递和桥墩内部应力变化的详细情景，讨论了船-桥碰撞的力学特征。
The history and property of the bow damage, the collision force, the energy transform and the tress distribution in the bridge pier are presented and discussed.
基于电流预测控制的PWM逆变器的基本原理，提出了改进方法。仿真结果显示，通过这些方法可获得更好的电流控制性能。
This paper introduces the principles of current predictive control-based PWM inverter, analyses some existing problems, and proposes improvement method.
在该模型的基础上对系统进行并网发电仿真，仿真结果显示系统模型建立正确，选用的方案能够很好的实现可再生能源的并网发电。
Based on the given model, the system is simulated. The simulation results show the model build in this paper is true and the scheme can realize connect the renewable source systems to power grid.
仿真结果显示，功率控制的确能够有效地提高网络的吞吐量，而基于再励学习的功率控制算法能够取得和理论最优策略相近的性能。
Simulation demonstrated that power control can improve the whole network throughput significantly and the performance of our scheme approximates to that of the optimal algorithm.
对于铣削力引起的加工变形，在加工水平中分面时，将铣削力分别施加到轴承端和导流端，仿真结果显示，铣削力不会引起过大变形；
When milling horizontally middle plane, by applying milling force to bearing end and steam guidance end, simulation results showed no excessive deformation arose.
对于铣削力引起的加工变形，在加工水平中分面时，将铣削力分别施加到轴承端和导流端，仿真结果显示，铣削力不会引起过大变形；
When milling horizontally middle plane, by applying milling force to bearing end and steam guidance end, simulation results showed no excessive deformation arose.
应用推荐