如果仪表指针出现了滞后现象等,将旋下仪表接头六方螺母,将缓冲器旋下清洗干净,装好后再进行使用。
If instrumentation pointer have lagged behind such phenomena, unscrew the meter connector six-party nut, buffer unscrew clean, pack good again after use.
仪表空气管线应该使用316不锈钢管。管线应为无缝管并且易于弯曲。接头应适用于所选的管线。
Instrument air tubing shall be 316 stainless steel. The tubing shall be seamless and suitable for bending. The fittings shall be suitable for the selected tubing.
根据用户要求,机组可配带快速接头、吸水管、输水管、仪表等附件。
Upon the user's request, the unit may be installed with fast connection, suction pipe, water delivery pipe, instruments and other accessories.
从控制仪表板上的空调暖气模式控制开关上断开真空线束接头。
Disconnect the vacuum harness connector from the back of the heater-A/C mode control switch on the control panel.
仪表的测量系统由接头、弹簧管和传动机构组成。通过指针指示仪表读数。
The system of measurement is composed by joint, spring pipe, and power transmission setting, and use the needle to note the number.
插车内温度感知器线束接头进仪表板线束接头。
Plug the in-vehicle temperature sensor wire harness connector into the instrument panel wire harness.
穿线盒是电动仪表的电缆穿管敷设时在套管的接连处、电缆的接头处以及分支处和拐弯处都必须采用的必不可少的连接件。
Electri i uire through Bix is a necessary used ad apting to lay cable eltcric instument on comelting part. branch priont and inleetion point-pipe. and cables when the eables is let mto drive-pipe.
穿线盒是电动仪表的电缆穿管敷设时在套管的接连处、电缆的接头处以及分支处和拐弯处都必须采用的必不可少的连接件。
Electri i uire through Bix is a necessary used ad apting to lay cable eltcric instument on comelting part. branch priont and inleetion point-pipe. and cables when the eables is let mto drive-pipe.
应用推荐