电介质强度测试者应该按照UL 745-1规范。
Dielectric strength tester shall conform to UL 745-1 specifications.
郯庐断裂带Q值分布表明，沂沭带介质强度的完整性较差。
Distribution of Q value of the Tanlu fracture zone shown that medium intensity of the Yinshu zone isn't complete.
应用此装置测量了不同分断条件下陶土灭弧室和栅片灭弧室内的介质强度恢复特性。
With this equipment, the dielectric recovery strength characteristics of ceramic chambers and deion plate chambers are studied.
在具有同样介质强度条件下，推得不同断层面宽度情况下震源体线性尺度与震级的关系式。
In the condition of the same medium strength, the relative expression between source linear dimension and magnitude is derived in the case of different fault plane width.
电介质强度试验是在每对导体（包括地）之间和每个导体与包装了金属薄片的尾档之间测量。
The Dielectric Strength Test is to be performed between each pair of conductors (including ground if applicable) and between each conductor and the foil wrapped cord guard.
电气强度测试仪(也称为耐压测试仪，电介质强度测试仪，闪点测试器，高压测试仪)是用来测量此类电流值的测试仪。
A dielectric Withstand tester (also called hipot tester, dielectric strength tester, flash tester, high voltage tester) is then used to measure this current.
具备四种测试仪的全部主要技术性能，可连续自动测试漏电流、接地阻抗、电介质强度、剩余电压。可打印测试数据。
The machine contain main functions of above four testing apparatus, it can automatic test leaking current, grounding electric resistance, dielectric intensity, resting voltage and print testing data.
指出在大震孕育过程中的区域地震活动迁移过程，可能与区域介质强度或原有断面“闭锁”“粘结”程度存在差异有关。
The migration process might be related to the difference of the medium strength in the different areas, and to the degree of locking on the different fault surfaces.
都显示锚杆中锚固段的应力波波速（固结波速）和锚固介质的强度直接相关，固结波速和锚固介质强度之间成抛物线关系。
Numerical simulation results agree with experimental results, both of which show that velocity of consolidation wave in grouted rock bolt are related to the anchoring strength of fresh concrete.
基本上，这些需求的钢管材料，都具有足够大的强度，韧性，良好的焊接能力以及耐腐蚀介质。
Basically, those steel pipe materials which, with adequately high strength, show sufficient toughness, good welding behaviour and resistance to corrosive media are in demand.
阀门的强度性能是指阀门承受介质压力的能力。
The intensity of the performance of the valve is the valve's ability to bear the pressure medium.
本文比对分析了极间介质为两层膜和三层膜的模型电容器元件的介电强度、局部放电性能以及耐久性能的试验结果。
Test result of dielectric strength, partial discharge and endurance property are analyzed and contrasted between solid dielectric is two film and tree film in model capacitor elements.
胶件密度、机械强度、硬度、耐介质系数等性能指标均达到技术要求。
The density, machinery intensity, hardness and medium resistance index of the rubber products meted the technology requirement.
岩体是一种不连续介质，岩体及岩体结构面强度特性具有一定的特殊性。
Rock mass is a discontinuous medium. The strength properties of rock mass and its structure plane are of certain peculiarity.
介质阻挡放电(DBD)处理聚合物表面可有效提高其亲水性和结合强度。
Dielectric barrier discharge (DBD) can be applied to modify polymer surface to improve its wettability and adhesive strength.
讨论了分散介质、搅拌强度、磁性粒子性质及用量等因素对聚合反应及聚合物磁含量的影响。
The effects of the dispersing medium, the agitation intensity, the amount and properties of magnetic particles on the polymerization and magnetic content in the polymer microspheres are discussed.
测点上某一震相的振幅和周期决定于震源强度以及震源到测点的整个传播过程中介质对震波的影响。
The amplitude and period of a phase at a receiving point depend on source strength and the effect of medium on seismic wave in the propagating from source to the receiving point.
胶料的硫化速度较快，强度较高，耐臭氧性能和耐介质性能较好：老化性能优良，耐油性能略有下降。
The aging speed, the strength of the hose, the chemical media resistance, and anti-ozone properties of the blend obtained improved significantly, but the oil resistance decreased slightly.
管道韧性设计受多方面因素的影响，分别分析了管道钢的强度及设计水平、管壁厚度、管径、输送介质、钢管的不同部位、环境条件等相关的影响因素。
The following factors having effect on pipe toughness are analysed: line pipe strength and design level, pipe thickness and diameter, medium transported, locations in pipe environmental impact, etc.
通过测量后向反射波与入射波的强度比，可以确定介质的三阶极化率。
Third-order susceptibility has been determined by the ratio of the input probing beam in tensity to the backward wave intensity in four-wave mixing.
目的：研究不同介质对毫米波辐射强度的影响。
Objective: the influences of different mediums on the intensity of millimeter wave radiation were studied.
结果表明，混浊介质对光的吸收作用增强了成像的分辨率，同时降低成像强度。
The results show that the enhancement of absorption increases the image resolution, and more absorption contributes lower image intensity.
进行工艺控制测试，例如：强度验证，介质控制等。
Perform process control testing, I, e. intensity verification, media control, etc.
中远区微差爆破振动叠加效应产生的主要因素是介质的衰减慢。 振动叠加强度与爆源结构特性、爆心距和间隔时间有关。
The intensity of vibration superposition is affected by the characteristics of explosion source , millisecond delay interval and distance between explosion source and measuring point.
积分式中的被积函数包含一噪声强度垂直指向性因子，海洋介质分层条件通过该指向性因子影响噪声场的空间相干。
The integrand includes a multiplying factor of the vertical directivity of the noise intensity, and the layered ocean environment affects the spatial coherences via this directivity factor.
结果表明，提高声源强度、降低重力水平或者采用密度大声速小的气体介质有利于提高声悬浮能力。
The calculated results show that strong vibrating source, low gravitational level and sound medium with large density and small sound speed will enhance the levitation ability.
本文介绍了用于易燃、易结垢、高温差介质的管壳式换热器的选型、结构设计、强度计算。
In this article, the selection, structure design and strength calculation of tabular heat exchangers working with combustible, easy fouling and high temperature contents were introduced.
击穿性能是电介质材料最基本的要求，提高材料的电气强度是电介质研究最为重要的任务之一。
Breakdown property is the basis requirement to dielectric and the improvement of the electrical strength is one of the most important works in dielectric research field.
进一步探索岩土介质的强度与变形机理，就必然要深入分析其细观变形和破坏性态。
In order to explore the strength and deformation mechanism of the geo-materials, some researches on the deformation and failure process in mesoscope must be performed.
进一步探索岩土介质的强度与变形机理，就必然要深入分析其细观变形和破坏性态。
In order to explore the strength and deformation mechanism of the geo-materials, some researches on the deformation and failure process in mesoscope must be performed.
应用推荐