最后通过理论计算与仿真结果的比较，证明了维修资源仿真预测的可行性。
At last, by comparing the simulation results to the computed values in theory, this paper proves the maintenance support resources can be well predicted by the computer simulation.
设计例子与仿真结果表明，根据该方法设计的系统有比较理想的鲁棒性和稳定性。
It is shown by design case and simulation result that the system designed with the proposed for the hydraulic turbine governing system has perfect stability and robustness.
结果显示基于预测的策略与仿真结果在所有的基准程序中平均具有90%的一致性。
The results demonstrate that transaction based prediction scheme works with an average accuracy of 90% over all the benchmarks when compared with the actual simulation results.
理论分析与仿真结果均表明，该算法能加快种群迭代速度，提高粒子搜索精度，防止粒子陷入局部最优。
Theoretical analysis and simulation results prove that the algorithm can increase iteration speed, enhance search accuracy, prevent the situation that particles fall into local best.
实验与仿真结果验证了文中所提出的方法，为提高电力采集系统故障时刻的精度提供了一种有效的途径。
The proposed method is proved through the experiment and simulation, and it can provide an effective way to improve the fault time accuracy of power sampling system.
根据本文的分析与仿真结果表示这种分布方式会对中心节点非常不利，这使得网络资源没有得到充分利用。
According to the analysis and simulation, results indicated that the distribution will result in center nodes very negative way, the network resources will not be fully utilized.
考虑主磁路饱和的同步电机激磁参数的估计值由最小二乘法参数辨识得到，实验数据与仿真结果基本吻合。
The magnetization parameter is estimated by the least-squares parameter identification with the consideration of main flux saturation and the experimental data agree with the simulative results.
实验与仿真结果表明：该系统采用音频开关而不导致电机负载的音频噪声，同时使EMI能被限制在低电平。
Experiments and simulations show that the proposed system can operate in audio switch frequency range without audio noise from the motor load, meanwhile, EMI can be limited to low level.
建立了超磁致伸缩执行器基于输入电压-输出位移的控制模型，实验测得系统频率响应曲线与仿真结果一致。
The control model based on input voltage and output displacement was built up, the frequency response curve of experimental measurements were exactly coincident withs…
通过理论推导与仿真结果的对比可知，数据关联抖动估算方法对线性时不变的集总参数，分布参数系统均是可行的。
Through comparison between theory proof and simulation, we find the approximation method is feasible in linear time invariant (LTI) system of concentration and distribution parameter.
论文最后进行了实验数据分析，将实验数据与仿真结果进行比较，进一步证实了仿真方法和反常衍射理论的适用性、正确性。
The last part of paper analyzed and compared the experiment data with simulation data, and proved that the correctness and applicability of the simulation method and anomalous diffraction theory.
本文基于矢量传感器阵组合增益的理论分析，在不同方位给出了各种矢量阵组合增益的计算机仿真结果，理论分析与仿真结果吻合很好。
Based on the theoretical analysis of vector array combined gain, the simulation results of different bearings are given, which are in accord with the theoretical analysis.
采用此模糊控制算法的仿真结果表明，此种方法不仅便于实现，而且与传统的控制方法相比具有较好的控制效果。
The results of simulation indicate that this type of control method is not only easy to achieve but also has the better effects than traditional control methods.
仿真与实验结果都证实了该方案不仅可以获得很好的动态调节特性，而且可以提高并机系统的稳定性。
The simulation and experimental results show that the proposed control scheme not only can achieve good dynamic performance but also can improve system stability.
结果证明此模型能够与实际运行情况很好地吻合，可用于仿真系统的构建、系统控制策略的研究及系统动态性能的分析等。
The results show that this model well conforms to the actual operation and can be used for simulation system construction, system control strategy study and dynamic performance analysis of the system.
仿真结果表明，参考信号的选择不仅与信号的相关性有关，还与振动信号的能量分布有关，为选择振动信号作为参考信号提供了依据。
Simulation results show that the selection of reference signal depends not only on the correlation , but also on the distribution of vibration energy, which can be used to guide the signal selection.
通过与BP算法的仿真结果比较分析，发现该算法具有稳定性好，收敛速度快，预测精度高的特点。
According to the analysis of simulation results compared with BP algorithm, this algorithm has the advantage of the fine stability, fast convergence speed and high precision.
建立其数学模型，并进行计算机仿真验证，其结果显示出该方法可以有效地提高目标的位置精度与可靠性。
A mathematical model is established and validated with computer imitation. The results show that the method can effectively improve accuracy of object position and reliability.
建立其数学模型，并进行计算机仿真验证，其结果显示出该方法可以有效地提高目标的位置精度与可靠性。
Mathematics model is established, and verified by the imitation of computer. The results show that the method can effectively improve the accuracy and reliability of the position.
仿真结果显示，运放开环与闭环时的频率响应、输出饱和、转换速率等特性得到了真实的反映。
The simulation results show the open-loop and closed-loop frequency responses, output saturation, and the slew-rate of operational amplifier are truly reflected by this model.
仿真结果表明：与传统PID控制器相比，该智能控制器的控制性能具有优越性。
Simulation results demonstrate that the control performance, stability, and adaptation of the intelligent controller are better than those of the conventional PID controller.
实验仿真结果表明，与无陀螺捷联惯导系统相比，该组合导航系统的精度和容错性能显著提高。
Computer simulation results show that, the precision and fault tolerance of the integrated navigation system are improved greatly, compared with the pure GFSINS.
通过整车试验数据与相同工况下的仿真结果对比，表明所述模型可以以很好的精度反映汽车在各种工况下的动力学性能。
Comparing the test result and simulation result and simulation result in same maneuver, it is proved that the presented model gets vehicle dynamic performance by simulation in high precision.
仿真结果表明，空台正弦扫描试验仿真得到的台面各节点加速度幅值与试验结果比较接近，所建立的模型可用于试件振动台试验仿真。
The results indicate that the simulation results are close to the experimental ones that the modal can be used for simulation of vibration test with attached structural members on it.
从仿真结果可见，与缆绳吊放声纳系统简单分段的线性模型相比，有限元非线性模型能更准确地描述系统的物理特性。
The results show that the infinite-element nonlinear model can describe the system more accuracy than the simple separating segment linear model do.
仿真结果表明：与常规电压型SVC控制器相比，SVC变结构控制器能有效地改善系统的动态特性。
The result of simulation shows that the proposed variable structure controller can improve dynamic characteristics of system more effectively in contrast to conventional voltage controller of SVC.
通过对基于该方法设计的BP网络离线训练后所进行的仿真结果分析与比较，使其有效性和可行性得以验证。
After the designed BP network be out-line trained based on the method, its efficiency and feasibility have be proved by comparing and analyzing simulated results.
通过对基于该方法设计的BP网络离线训练后所进行的仿真结果分析与比较，使其有效性和可行性得以验证。
After the designed BP network be out-line trained based on the method, its efficiency and feasibility have be proved by comparing and analyzing simulated results.
应用推荐