This parameter specifies the minimum required assembly interference of the fit when the coupling still has not achieved the required loading capacity.
这个参数指定的最小的需要的配合的安装干涉，当联接静止的没有达成需要的负载能力。
Provides for accurate location and non-interference of parts in assembly.
提供准确的定位和互不干涉的零件组装。
The virtual design and assembly of modular electronic actuator is realized based on it, and assembly parts is detected by interference.
实现了电动执行器三维虚拟设计、装配，并对装配模型作干涉检查。
Firstly, it is proposed to build Interference-Freeness Matrix for assembly in order to describe the relation of parts.
首先，提出建立装配体的干涉—自由矩阵，描述零件相互之间的空间关系。
The rotor shall have an interference fit to the shaft and the rotating assembly shall be dynamically balanced to ISO 1940, G. 6.3.
定子应该通过压配合与轴结合在一起，旋转总装动态平衡应该符合ISO 1940， G.6.3标准。
Then, According to the cutting tooth processing principle, establish hypoid gear model, and conduct virtual assembly, interference checking, provides the precise model for the following analysis.
再根据切齿加工原理，建立了准双曲面齿轮模型，并进行虚拟装配，干涉检查，为后面分析提供精确的模型。
The parameter selection and permeability-proof for structure design, interference magnitude and assembly clearance of the couplings with the tubing were also studied systematically.
对管接头结构设计、过盈量和装配间隙等参数选择、防渗漏等进行了较系统地研究。
There are three classes of fits: 1) clearance fits, 2) transition fits (the assembly may have either clearance or interference), and 3) interference fits.
存在三种配合：1）间隙配合，2）过渡配合（装配后可以有 间隙或过盈），和3）过盈配合。
The interference taper assembly of the hub on the shaft is performed hydraulically and at ambient temperature, without dismounting the coupling.
轮毂与轴的对接锥形装配采用液压方式在环境温度下实现，而不需要对联轴节进行拆卸。
The interference taper assembly of the hub on the shaft is performed hydraulically and at ambient temperature, without dismounting the coupling.
轮毂与轴的对接锥形装配采用液压方式在环境温度下实现，而不需要对联轴节进行拆卸。
应用推荐