继而在四步模式下,研究了钳位电压和驱动电压对机构负位移的影响。
The influences of the clamping and driving voltages on the recession displacement were studied.
第一,在场效应晶体管关断期间钳位电压是800伏特,高于600伏特。
First, the clamping voltage during the MOSFETs turning off is 800V, what is higher then of 600V.
要确保输入端钳位电压足够的高,以避免由于源接点的非线性而产生的问题。
Make sure the compliance voltage is high enough to avoid problems due to source contact non-linearity.
这种离析主要原理的手法有助于合理审视电源电路里诸如变化速率、振荡、钳位、缓冲、反射电压等过程。
The separation into main elements should be done in respect of reasonable events in the power circuit like on and off slopes, oscillations, clamping, snubbering, reflected voltage, etc.
由于直流电压源的钳位作用,交流侧输出电压波形为矩形波,并且与负载阻抗角无关。
Because the clamp effect of DC voltage source, AC side output the rectangular wave voltage waveform, and it has nothing to do with the load impedance Angle.
利用有源钳位电路实现主变压器铁心对称复位,功率开关在宽输入电压和宽负载电流范围内零电压开关。
By using an active clamp circuit, the power transformer core is symmetrically reset. Zero voltage switching conditions are achieved over a broad input voltage and output current range.
当被测dut发生短路或其他异常导致电流或电压过高时,钳位电路会将输出电压或电流限制在一个固定值上,以保护器件不被损坏。
Meanwhile, the clamp circuit will limit the output voltage or current at a fixed value when they are abnormal that caused by a DUT short circuit or other fault in order to protect the device.
然而,由于漏感影响,反激变换器功率开关管关断时将引起电压尖峰,必须用钳位电路加以抑制。
However, due to leakage effects flyback converter power switch off when the voltage spike caused by the need to be inhibited by clamping circuit.
然而,由于漏感影响,反激变换器功率开关管关断时将引起电压尖峰,必须用钳位电路加以抑制。
However, due to leakage effects flyback converter power switch off when the voltage spike caused by the need to be inhibited by clamping circuit.
应用推荐