地面温度应用体积小棒状传感器的多点采样平均来代替单点一次采样；
The conclusion is that ground temperature should be measured by stick-shaped sensors of small size and, single point sampling should be substituted by averaged multiple point sampling.
在激发光波动较大时双光路法与单光路采样平均法相比有明显优越性。
The method is better than sampling-averaging method when the incident laser intensity has more wave...
非ocg编译器针对SiliconLabs单电池供电c 80519 XXF所产生的代码，每次数据采样平均会有108个周期来执行中断服务程序和主循环。
Code generated for Silicon Labs single-cell C80519XXF by a non-OCG compiler results in an average of 108 cycles to execute the interrupt service routine and main loop overhead for each sample of data.
r——在所选择的任意采样间隔期间的平均可运行内核线程数。
R — The average number of runnable kernel threads over whatever sampling interval you have chosen.
b——采样期间在虚拟内存中等待队列的平均内核线程数。
B — the average number of kernel threads that are in the virtual memory waiting queue over your sampling interval.
测试客户端测量测试的持续时间内平均的响应时间和成功的采样数(即得到了响应的采样数)。
The test client measures average response time and number of successful hits (i.e. hits that get responses) for the duration of the testing.
它将计算用户指定的采样时间内的内存、分页和CPU活动的统计平均值。
It calculates statistic averages for memory, paging, and CPU activity on a sampling period of a length specified by the user.
其先进的电流检测电路采用采样和保持方法，以提供精确的平均电流信号。
Its advanced current sensing circuitry employs sample and hold methods to provide a precise average current signal.
通过计算导出了平均假频衰减与滤波器阶次及采样率的关系式。
A relation between average alias attenuation and filter order and sampling rate is derived from calculation.
通过对红外水分仪实际采样信号的滤波试验，并与一般平均滤波算法相比较，证明其具有更好的滤波效果。
Through the filter experiment on the actual sampling signal, and compares with the common average filter algorithm, it proved the wavelet analysis algorithm has better filter effect.
相位抖动：指的是反馈时钟和参考时钟之间上升沿差异与多次随机采样的平均偏移之间的差。
Phase Jitter: refers to the deviation of the FBKCLK rising edge to the REFCLK rising edge with respect to the average offset in a random sample of cycles.
本文提出一种直接在点采样曲面上计算曲面的高斯曲率、平均曲率及主曲率等局部微分性质的方法。
An approach is proposed to estimate several differential properties, including Gaussian curvature, mean curvature and main curvature on point-sampled surfaces in presence of noise.
我们在设计算法模型时考虑了这方面的重要性，利用像素点的平均采样提高了算法的效率。
We took into account the importance of this aspect in the design of algorithms model, and increased the efficiency of algorithm using the average sampling pixels.
包括对点云切片截面有效数据点进行平均采样，得到喷枪在工件表面的喷涂路径；
Including cross-section slice of the point cloud data points for the average effective sample obtained the spray gun spray path.
同时随机化零矢量，通过约束保证平均开关频率等于采样频率。
Zero vectors are randomized with the sample frequency and the average switching frequency equals to sample frequency with some constraint.
通过采样输入输出电压以获取电感的平均电流，从而代替了实际的采样电流，以进行PI调节。
The average inductance current can be calculated by input voltage and output voltage to use in PI regulator.
研究结果表明，当采样间隔接近采样目标的平均空间细节时，图像采集系统端到端信息率最大，图像质量最理想。
The research results show that the end-to-end information rate reaches its peak value when sampling interval is near to the mean spatial details of the target, where the image quality is ideal.
为了提高信噪比，采用了信号平均技术，并通过实验确定了最佳采样时间和平均次数。
The signal average method was used in order to increase the S/N ratio, and the optimum sweep time and average times were experimentally determined.
为防止计算失败及提高计算精度，采用了多个采样点绝对值和补偿及平均平滑补偿措施；
The measures of absolute value summation and multi-point averaging are applied to improve the measurement precision and prevent calculation failure.
理论分析发现，随着过采样率的增加，采样点之间相关性上升，新增加采样点对信号峰值平均功率比的影响下降，系统峰值平均功率比的变化缓慢并趋于稳定。
We can find that correlation value between sampled points ascends and the influence that the new sampled point acts on PAPR decreases with the increase of the oversampling rate.
本文论述了红外电视采样测温信号多场平均的原理，提出了实现这种方法的实用方案。
The principle of the averaging technique is described and two practical schemes are proposed for realizing this method.
此算法的关键不同点在于不是让算法结果在采样点的值等于原采样值，而是在一个象素大小的单位面积上得到的平均值等于原采样值。
A key difference is that this algorithm does not give the same value at the sampling point but gives the same average value in unit area of each pixel.
此算法的关键不同点在于不是让算法结果在采样点的值等于原采样值，而是在一个象素大小的单位面积上得到的平均值等于原采样值。
A key difference is that this algorithm does not give the same value at the sampling point but gives the same average value in unit area of each pixel.
应用推荐