本文提出了加速度记录的零线漂移校正方法和校正准则。
This paper proposes a method of correcting the acceleration records.
该可编程增益放大器采用源极反馈电阻可变的差分放大器结构，且带有直流漂移校正电路。
The PGA consists of the differential amplifier with variable source degeneration resistor and the DC-offset correction circuit.
由仿真结果可以看出，它能较精确地估计陀螺常值漂移和航向角误差，为系统误差的校正提供了可信信息。
The simulation results show that the constant gyro drifts and the heading errors, which provide information for calibrating the system errors, can be estimated exactly.
在IPPP帧结构中，转换编码结构需要对显著的色差漂移误差进行校正。
In the case of IPPP frame structure, the obvious chroma drift errors had been corrected in our transcoding architecture.
补偿固定噪声的时间漂移是红外焦平面非均匀校正技术中面临的一个重要问题。
Compensating for temporal drift of fixed-pattern noise is an important problem in the techniques for nonuniformity correction of infrared focal plane arrays.
该系统能对压力传感器的零点误差、灵敏度误差和温度漂移进行自动的补偿校正。
The system can automatically compensate and calibrate the pressure sensor's zero point error, sensitivity error and thermal drift.
本文应用天文导航理论，根据GPS提供的位置信息，对静电陀螺捷联导航系统陀螺常值漂移和载体航向角进行校正的算法进行了研究。
Using astronavigation theory, the algorithm of calibrating the constant gyro drifts of ESG strapdown inertial navigation system and carrier heading is presented in this paper.
在控制方案上采用速度控制和张力控制的复合控制方式，同时通过软硬件对张力测定仪的零点漂移进行补偿和现场校正。
The compound control mode of speed control and tension control was used and the zero shift of the tension measuring device was compensated and spot-calibrated by software and hardware.
改进的滤波估计法引入偏差去耦技术在零速校正期间估计出陀螺漂移，并利用速度信息快速估计出方位误差角。
In the improved filter estimation method, the decoupled state and bias estimation technology is introduced to estimate gyro constant bias during ZUPT.
本论文主要研究了差压传感器的设计方法、制作工艺、非线性自校正及温度漂移自补偿等技术。
This paper is mainly the research on the design techniques, facture technics, non-linear self-emendation and temperature-bias self-compensate techniques of dif-pressure sensors.
本方法比通常自校正内模控制算法的运算量大大减少，而在对象参数在一定范围内漂移时，同样能取到自校正效果。
The method has the advantage of easier calculation than normal ones. When the plant parameters change within a certain range, it can still work well.
本方法比通常自校正内模控制算法的运算量大大减少，而在对象参数在一定范围内漂移时，同样能取到自校正效果。
The method has the advantage of easier calculation than normal ones. When the plant parameters change within a certain range, it can still work well.
应用推荐