最后对网络弹性进行了理论分析,给出了网络在出现最大集团临界点之前的平均集团大小的公式解。
Finally, the network resilience was analyzed theoretically, and a closed-form solution for average size of clusters was reached before the largest cluster of network appeared.
实验表明,对有较大弹性形变的图像,与块匹配法相比,该算法得到的平均匹配残差明显减小。
The experiment shows that the average residual error using the method is smaller than using block matching method for the large scale elastic deformed image.
同时采用成层地基进行分析,将其计算结果与常规方法中采用对弹性模量和泊松比在计算深度内按深度加权平均的计算结果进行比较;
Present results are compared with the results from conventional method, in which the elastic modulus and Poisson's ratio are weighted averaged with the depth.
用平均法研究了含预紧弹性约束的单自由度系统在简谐激励下的主共振及其稳定性。
The primary resonance and its stability of a harmonically forced oscillator with a pair of symmetric setup elastic stops are studied in this paper by means of average approach.
本文基于定向平均法计算了缝纫复合材料的宏观弹性常数。
The elastic constants of stitched composites were calculated based on orientation averaging method.
基于刚度体平均方法,建立了相应的刚度预报模型,得到了三维四向编织复合材料的工程弹性常数。
The model to predict stiffness was then established based on the stiffness volume average method. The elasticity constants of the material were obtained.
通过建立沥青混合料的三维随机格形模型,加载适当载荷和边界条件求解后,采用体积平均法得出混合料等效弹性性质。
Equivalent elastic properties of asphalt mixture were obtained by the method of average volume after establishing the 3d random lattice model with appropriate load and boundary conditions.
电子复自能的虚部给出了空间和角度相关的微分倒数非弹性平均自由程(diimfp)。
The imaginary part of the complex self energy of electron provides spatial and angular dependent differential inverse inelastic mean free path (DIIMFP).
横轴方向的位移荷载速度越大,纵轴方向的弹性模量越大,平台极限应变越小,而屈服应力和平均平台应力相差不大。
When the transverse loading speed becomes bigger, the axial elasticity modulus also becomes bigger, while the platform yeild strain becomes smaller, buy the yield stress changes little.
通过测试环向拉伸强度,双向自增强PEX管材的拉伸强度最高可达到32.29%,弹性模量最大可提高13.06%,断裂伸长率平均减小5.88%。
The result reveals that the biaxial oriented PEX pipe can increase the tensile strength by 32.29% at most, while the modulus of elasticity increasing 13.06% and the elongation at break reducing 5.88%.
设粘弹性板的轴向运动速度为常平均速度与简谐涨落的叠加,建立轴向加速运动粘弹性矩形薄板的运动微分方程。
The axially moving speed is a simple harmonic fluctuation about a constant mean speed, the differential equation of motion of axially accelerating viscoelastic plate is established.
其进料粒度达为450~1000mm,平均出料粒度小于或等于5~8mm。多方式弹性调节机构,有效的控制了出料度;
The size of feeding material is 450-1000mm, and the average discharge size is5-8mm, which is controlled effectively by multi-mode elastic adjusting mechanism.
所述弹性区域由多个区段限定,在所述弹性拉袢的弹性区域的长度方向上具有不同的平均宽度。
The elastic region is defined by a plurality of segments, having differing average widths in the length direction of the elastic tab elastic region.
提出了一种利用静电作用下悬臂梁的吸合电压提取MEMS薄膜沿厚度方向的平均应力梯度及弹性模量的方法,该方法的关键在于实现悬臂梁吸合电压的快速、精确计算。
A novel method for calculating Youngs modulus and residual stress of a MEMS film is proposed based on pull-in voltages of a set of fixed-fixed beams.
提出了一种利用静电作用下悬臂梁的吸合电压提取MEMS薄膜沿厚度方向的平均应力梯度及弹性模量的方法,该方法的关键在于实现悬臂梁吸合电压的快速、精确计算。
A novel method for calculating Youngs modulus and residual stress of a MEMS film is proposed based on pull-in voltages of a set of fixed-fixed beams.
应用推荐