对变压器套管现场数据的处理结果验证了该算法的正确性。
The correctness of this algorithm is verified by the processing results of on-site data of transformer bushing.
分析了变压器套管法兰附近发生电晕放电的原因并提出处理方法。
Reasons for corona discharge nearby the flange of transformer bushing are analyzed, and puts forward processing method.
分析了因变压器套管穿芯引线设计及安装不合理导致的导电回路局部过热性故障，提出了防范措施。
The conductive loop partial overheat fault caused by improper design and installation of the through lead wire in transformer bushing is analyzed. The preventive measures are presented.
介绍了用于埃及unenta公司电力变压器的短尾油纸电容式变压器套管的电气性能、设计计算及试验结果。
This paper presents the oil impregnated paper condenser bushing with short lower for power transformer used in UNENTA system, Egypt, with its electrical parameters design calculation and test results.
你可以把这种电动机当作一个旋转变压器，其主要的线圈在固定套管(定子)内，二级导线附在一个内轴(转子)上。
Think of it as a rotating transformer, with the primary windings residing in a stationary casing (stator) and the secondary conductors attached to an inner shaft (rotor).
套管是变压器中一种重要的部件。
Bushing is one of the most important insulation parts in transformer.
变压器采用纯瓷套管。
对运行在空冷岛下方的超高压变压器高压套管的选型及运行维护等进行了探讨。
The type selection of high voltage bushing in UHV transformer below air-cooling island and its operation and maintenance are discussed.
套管作为变压器的配套件，其介损应当较低。
Acting as an important accessories of transformer, the bushing should have a lower dielectric loss.
末端加压法对高压直流输电系统所用换流变压器阀侧套管预防性试验，特别是将来特高压直流换流变压器阀侧套管预防性试验具有较高的实用价值。
Applying voltage into the bushing tap method for preventive test of converter transformer value side bushing in HVDC, especially in the future for UHV, will have better practical value.
对某电厂使用的变压器高压油浸纸电容式套管和环氧浸纸电容式套管的运行情况进行了比较，并对曾出现的故障类型进行了分析。
The tests of the grounding apparatus mounted at the transformer bushing tap and oil-filled paper condenser type bushing of 220 kV transformers in Shahe substation is presented.
换流变压器绝缘最关键的部位是由套管及纸板围屏系统组成的阀侧出线装置。
The most important part of converter transformer insulation is the valve side outlet device, which consists of bushing and surrounding barrier system.
电能由三相配电变压器经AC DC AC逆变电路输出传送到油管，经油管下部的油套管接触器连接到套管，形成一个完整的回路。
Electric power is output to the oil tube, which is connected with the bushing by the oil bushing connecter on the bottom of the oil tube, via a 3-phase transformer after AC-DC-AC inverse circuit.
VDI20/250是一种由硅橡胶制成的屏蔽式直通型可分离连接器，用于电缆连接到24kV级及以下电气系统的开关柜和变压器（开关柜和变压器应配有满足EN50180，EN50181和DIN47636标准的套管）。
ESW 20/250 is a screened straight cable connector made of silicone rubber for cable connection to switchgear and transformers up to 24kV with bushings according to EN50180, EN50181 and DIN47636.
SE20/250是一种由硅橡胶制成的屏蔽式肘形可分离连接器，用于电缆连接到24kV及以下电压系统的开关柜和变压器（开关柜和变压器应配有满足EN50180，EN50181和DIN47636标准的套管）。
SE20/250 is a screened elbow cable connector made of silicone rubber for cable connection to switchgear and transformers up to 24kV with bushings according to EN50180, EN50181 and DIN47636.
SE20/250是一种由硅橡胶制成的屏蔽式肘形可分离连接器，用于电缆连接到24kV及以下电压系统的开关柜和变压器（开关柜和变压器应配有满足EN50180，EN50181和DIN47636标准的套管）。
SE20/250 is a screened elbow cable connector made of silicone rubber for cable connection to switchgear and transformers up to 24kV with bushings according to EN50180, EN50181 and DIN47636.
应用推荐