一种装仓电路和相关方法，其中对来自传感器电路中的列电路的像素信号进行采样和内插。
A binning circuit and related method, wherein pixel signals from column circuits in a sensor circuit are sampled and interpolated.
针对CMOS有源像素传感器，提出一种降低固定模式噪声(FPN)的列读出电路。
A column readout circuit to reduce fixed pattern noise (FPN) for CMOS active pixel sensor images is presented.
电源电压列在“主要性能参数”表中，在一般情况下，焊机内的电压自动补偿电路将保证焊接电流保持在允许的范围。
Supply voltage in the "main performance parameters" in the table, under normal circumstances, the welding voltage compensation circuit will guarantee automatic welding current to keep the scope.
针对两种采用不同灰度调制方式和预充方法的新型无源OLED显示列驱动电路进行研究和设计。
The paper presents two novel PM-OLED column driver circuits with different grayscale modulation methods and pre-charge methods.
求解动态电路一般是列微分方程，解微分方程。
The typical way to analyze dynamic circuit is writing differential equation, then obtaining the solution.
提出了一种新颖的高速、低功耗电路作为列阵的扫描电路，对其工作原理进行了分析。
We present a novel dynamic circuits with high speed and low power consumption as the scanning part of these arrays, whose working principles are analyzed.
从异步发电机稳态运行的等效电路模型出发，列写了等效电路模型的回路阻抗方程，令回路阻抗实部和虚部分别为零，建立方程组。
Based on the model of equivalent circuit of a asynchronous generator at steady-state operation, the loop impedance equation of it are listed in this paper.
在列并行模数转换器理论的研究基础上着手实际电路的设计。
Based on all the study above, a real column parallel single-slope ADC circuit is designed.
基于非制冷红外焦平面列阵(ufpa)探测器件进行了气象测云红外成像系统的光学设计、结构设计与电路设计，对系统光学设计结果进行详细分析。
On the basis of Uncool infrared Focal Plane Array (UFPA) detector, the optics, structure and the circuit of the infrared imaging system for cloud meteorological observation are designed.
同时，为了能够支持点反转和列反转两种面板驱动方式，本数据驱动电路的奇数和偶数输出管脚分别输出极性不同的灰度电压。
Also, to be able to deal with dot-line inversion, this source driver's odd output pins and even output pins respectively output gray scale voltages of differing polarity.
通过对普通列读出电路进行改进，在双采样电路基础上，增加了失调电压补偿过程。
The traditional readout circuit is improved by offset compensation based on double sampling technique.
芯片内部主要包括数字控制器，显示数据存取器，DC - DC电压转换器，参考电流产生器，电压预充电路产生器，64个行驱动电路和132个列驱动电路。
It consists of a digital controller, SRAM for display data memory, a DC-DC voltage converter, reference current generators, a pre-charge voltage generator, 64 common drivers, and 132 segment drivers.
轨道电路是现代列控系统中能够影响传输信号品质并且用来确保日常行车安全和提升运营效率的关键部分。
Therefore, modern train control system can affect the quality of transmitted signals and used to ensure traffic safety and improve the daily operational efficiency is a key part of the track circuit.
然后结合所设计的恒流源，对PM -OLED驱动电路中的行驱动电路和列驱动电路进行设计。
And then make use of constant current source to design PM-OLED driver circuit row driver circuit and column driver circuit.
定时调整电路具有铁电电 容器，用于在把从列解码器输出的激活信号发送到检测放大器电路时进 行定时调整。
Timing adjusting circuits have a ferroelectric capacitor for timing adjustment in transmitting the activation signals output from the column decoder to the sense amplifier circuits.
提出一个建立在基尔霍夫定则及其对偶定则基础之上的线性电路解法，只需对网络图的结构进行分析，不需列写任何电路方程式。
A solution of linear circuit based on Kirchhoff"s rule and its dual rule is presented. By means of this solution, analysis are required to the structure of graph, no any circuit equations are needed."
提出一个建立在基尔霍夫定则及其对偶定则基础之上的线性电路解法，只需对网络图的结构进行分析，不需列写任何电路方程式。
A solution of linear circuit based on Kirchhoff"s rule and its dual rule is presented. By means of this solution, analysis are required to the structure of graph, no any circuit equations are needed."
应用推荐