由于变换器工作在平均电流控制的APFC系统中,本文建立了BUCBB变换器的大信号动态模型,并将BUCBB变换器中的开关元件用受控源代替。
On account of the average current control chosen in the APFC system, a large signal dynamic BUCBB model is built and all the switching elements replaced by dependent sources.
提出了对传感器采集到的微弱信号进行累加平均和小波变换中的多分辨率分析方法相结合去噪。
The method that combine the cumulative average and multi-resolution analysis in wavelet transform was presented which can de-noise the weak signal collected from the sensor.
采用半导体存储器延迟信号,短时间平均器与长时间平均器对输入信号积分。
A semiconductor memory is used as a delay unit. Short-term averager and long-term averager integrate the input signals.
本文提出了平均误比特率最小意义下的最佳线性多用户信号检测器,并给出了求解这种最佳线性多用户信号检测器的近似方法——训练单层感知器法。
This paper presented a optimum linear multiuser detector in terms of minimum mean bit error rate, and given a approximate method of solving the detector - method of training single perceptron.
介绍了一种基于平均相关器的GPS信号快速捕获算法,通过VHDL语言描述在FPGA上实现了该算法。
Presented a method of fast acquisition of GPS signal based on averaging correlator and implemented it on FPGA by VHDL.
在天气回波信号谱宽固定的情况下,通过改变天气回波信号的平均多普勒频率,分析了回归滤波器对它的衰减情况。
Fixing the spectrum width of the weather echo signals, we change theirs mean Doppler frequency and filter them using regression filter. After filtering, we analyze the attenuation of them.
本文分析了时域平均法对光电信号进行滤波处理在激光绝对法校准振动传感器相频特性中的应用。
In this paper, the time domain average meth od is used to extract the interfere signal in calibrating the phase character of vibration sensor by laser interferometer.
探讨了应用经验模态分解代替时域同步平均分析减速器振动信号的方法。
Empirical Mode Decomposition (EMD) is introduced to replace time synchronous averaging of gearbox vibration signal.
针对交流伺服系统的位置控制,设计出一种新型滑模控制器,以前馈信号作为平均控制,采用模糊推理来调节开关控制的幅度。
A new slide mode controller is designed for AC servo system. The feed forward signal is used as average control, and fuzzy inference is used to regulate the magnitude of on-off control.
针对交流伺服系统的位置控制,设计出一种新型滑模控制器,以前馈信号作为平均控制,采用模糊推理来调节开关控制的幅度。
A new slide mode controller is designed for AC servo system. The feed forward signal is used as average control, and fuzzy inference is used to regulate the magnitude of on-off control.
应用推荐